Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt surface in Albertville, Alabama


Tar And Chip Paving installed in an unstable surface could quickly lead to difficulties. There are three Chief choices for the Simple installation:

  1. Paving Over Existing Driveway: If your existing driveway is in good shape rather than showing serious fractures or crumbling, hot asphalt mix can be placed directly within your driveway. One aspect is elevation: make certain fences, garage flooring, and other structures aren't jeopardized by the higher level of the surface.
  2. Remove old driveway, counter into the floor: The existing driveway is totally removed (or you may not have a driveway yet) and 4 to 6 inches of warm paving stone is placed right on the ground.
  3. Eliminate the old driveway and fasten it into a solid surface. This is actually the preferred method. An aggregated stone floor partly replaces part of this hot asphalt mix. Typically 6 to 8 inches of aggregate extends under 3 inches of asphalt.

Our Services:

The best time to install Tar And Chip Paving from Albertville

The longer asphalt you work, the more leeway you might have. By way of instance, in 40 F, the crews just have 16 minutes to work on 1 1/2 inch thick asphalt. As the asphalt depth increases by 3 inches, the workability time also raises: 46 minutes. In general, for thin asphalt applications (about 1.5 cm), you need to wait until temperatures are 21 ° C or even higher. Between 50 and 60 F, you ought to speak to your contractor. The hot mix is ​​still practical during this period of time, but the time is limited.

How much can an Tar And Chip Paving cost in Albertville?

Consider the weather vagaries of the climate when choosing the quality of asphalt. The substantial temperature variations we experience cause considerable damage to asphalt perform.

In addition, it'll be useful to distinguish the contractor if you own a recreational vehicle or even a van. He will need to adapt the asphalt mixture so as to be more immune to the burden of heavy vehicles.

The advantages of Tar And Chip Paving

A driveway paved with asphalt has several advantages:

It will cost you between $ 3 and $11 per square foot; the cost fluctuates based on the characteristic of the asphalt employed along with the paving contractor.

To get a sustainable Tar And Chip Paving

The life of an asphalt paver may be around 20 years, when the very best states are satisfied. We're referring to a professional paving builder, a great grade of asphalt as well as an optimal asphalt laying technique.


The longevity of residential asphalt paving chiefly depends upon the standard of the laying. Really, the major causes of deformation or ripping of an asphalt coating are the absence of compaction plus a thin foundation. However, the maintenance of the asphalt pavement can be a deciding factor in its own longevity. That is to say, you'll need to seal your driveway once in 10 decades, at a minimum, in order to keep its good condition.


We advise you to inform your asphalting builder in case you choose to get your driveway asphalt so as to sell your property. It might not be necessary to pay top dollar for placing asphalt , in this circumstance.

Tar And Chip Paving laying: price and contract

The option of the asphalt laying builder is indispensable. In order not to have unpleasant surprises, then you will have to select it carefully.

Our guarantees and Tar And Chip Paving work

Guarantee that the paving contractor has liability insurance coverage. A trip to the web site of the Office for Consumer Protection (OPC) will allow you to verify whether an entrepreneur has ever been the subject of complaints.

The following details must be included in the arrangement:

- date of beginning and end of the job;

- proof of insurance;

- technical details;

- RBQ accreditation number.

You ought to know that a paving contractor cannot require that you make a deposit before work has started. But you should agree on the payment provisions and make sure it's on the contract.

Before redoing the asphalt drive to your new home by a builder, or acquiring some basic knowledge is vital to make sure the job is done. Know first that the absence of compaction and the inadequate thickness of the base are the two main causes of the deformation or ripping of a coating of asphalt. If it's a new driveway, then it must first be excavated to make room for a layer of crushed stone of sufficient thickness. A geotextile membrane will be placed beneath the granular backfill if the soil proves to be very loamy (clayey). If you have a new house, it is best to wait 6 to 12 months prior to paving your drive, to enable the soil to settle naturally. In the case of a repair of this entrance, a simple replacement of the asphalt layer can be considered in the event the contractor considers that the existing base is sufficient. In both cases, base redone or base maintained, the duration of its warranty has to be the same.

Tar And Chip Paving Albertville Alabama

The weather conditions in our lovely state may have a devastating effect in an asphalt driveway, hence the importance of adding a slope having a minimum slope of 2%. This will allow water to drain into the street and decrease the danger of heaving or cracking. This important detail has to be taken into account when excavating and maintained during backfilling.

In case you have a van or recreational vehicle, notify the contractor prior to the start of the work: he is going to be able to provide materials accordingly. Some asphalt mixtures produce an asphalt that is more immune to heavy duty vehicles.

The asphalt layer should have an initial thickness of 6.35 to 7.6 cm (2.5 to 3 in) so as to accomplish a thickness of 5 cm (2 ) after being compacted. For optimum stability, the base should extend across the surface to be paved by about thirty centimeters (a couple inches) on each side. Also note that the installation of side supports around the foundation is a good way to avoid possible cracks and that asphalting done in chilly weather is going to be of poor quality. It is therefore far better to await the sunny days to go back before beginning work.

To avoid unpleasant surprises, choose your contractor diligently and make sure the title and address of the business are written about the contract. The start and finish dates of the work, as well as evidence of this builder's liability insurance and also the technical details of the job to be carried out, should also be included. No contractor should require a deposit before work begins. To prevent the inconvenience that could cause unforeseen costs, visit the Tar And Chip PavingAlbertville website. You will thus have all the resources in hand to successfully complete your asphalt paving project.

Tar And Chip Paving Albertville - Best Alabama at Alabama!

For quality asphalting work , phone on Tar And Chip Paving, Albertville specialist team. We have more than twenty years of expertise in asphalt laying, resurfacing, maintenance and repair. Consult our Business department to figure out the regions served.

Snow Removal Albertville | Asphalt Albertville
Home >> alabama/albertville >> tar and chip paving
Share this...