Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt Coating in Bessemer, Alabama


Tar And Chip Paving installed on an unstable surface can quickly lead to problems. There are 3 main choices for the basic setup:

  1. Paving Over Existing Driveway: If your existing driveway is in good condition rather than showing serious cracks or crumbling, hot asphalt mixture can be placed directly within your driveway. One aspect is elevation: make sure fences, garage floors, and other constructions are not compromised by the higher level of the new surface.
  2. Eliminate old driveway, peg to the ground: The present driveway is totally eliminated (or you might not have a driveway yet) and 4 to 6 inches of warm paving stone is put right on the ground.
  3. Remove the old driveway and secure it to a good surface. This is actually the preferred method. An aggregated stone flooring partially replaces part of this hot asphalt mixture. Generally 6 to 8 inches of aggregate goes under 3 inches of asphalt.

Our Services:

The best time to install Tar And Chip Paving in Bessemer

The more asphalt you operate, the more leeway you might have. By way of example, at 40 F, the crews only have 16 minutes to operate on 1 1/2 inch thick asphalt. As the asphalt thickness increases by 3 inches, the workability time also increases: 46 minutes. In general, for thin asphalt applications (about 1.5 cm), you need to wait until temperatures are 21 ° C or higher. Between 50 and 60 F, then you ought to speak to your contractor. The hot mix is ​​still practical in this period of time, but the time is limited.

How much can an Tar And Chip Paving price in Bessemer?

Consider the weather vagaries of our climate when choosing the quality of asphalt. The significant temperature variations we experience cause considerable damage to asphalt perform.

In addition, it'll be useful to tell the contractor if you own a recreational vehicle or even a van. He might need to adapt the asphalt mixture so as to be more immune to the burden of heavy vehicles.

The Benefits of Tar And Chip Paving

  • Smooth finish;
  • non invasive
  • Simple to maintain
  • watertightness ensured
  • withstands the rigors of this Quebec climate quite well (provided it's been set up optimally);
  • prevents the growth of moss;

It will cost you between $ 3 and $11 per square foot; the price varies depending on the characteristic of the asphalt used along with the paving contractor.

For a sustainable Tar And Chip Paving

The life of an asphalt paver can be around 20 years, when the best conditions are met. We are talking about a professional paving builder, a great quality of asphalt as well as also an optimal asphalt laying technique.


The longevity of residential asphalt paving largely is dependent on the quality of the placing. Really, the major causes of deformation or tearing of an asphalt coating are the lack of compaction and a thin foundation. However, the maintenance of the asphalt pavement can be a deciding factor in its own longevity. That's to say, you will have to seal your drive once in ten years, at a minimum, in order to maintain its great state.


We advise you to inform your asphalting builder in case you decide to have your driveway asphalt in order to sell your property. It might not be essential to pay top dollar for placing asphalt , in this circumstance.

Tar And Chip Paving laying: cost and contract

The option of the asphalt laying contractor is indispensable. In order to not have unpleasant surprises, you'll need to select it carefully.

Our ensures and Tar And Chip Paving work

Make sure the paving contractor has liability insurance coverage. A visit to the web site of the Office for Consumer Protection (OPC) will allow you to confirm whether an entrepreneur has been the subject of complaints.

These details must be included in the arrangement:

- date of beginning and finish of the job;

- proof of insurance;

- technical details;

- RBQ certification number.

You ought to be aware that a paving contractor cannot require that you make a deposit before work has begun. However, you should agree to the payment terms and be sure it is about the contract.

Prior to estimating the asphalt driveway to your new residence by a contractor, or acquiring some basic knowledge is vital to make sure the job is well done. Know first that the lack of compaction and the inadequate depth of the foundation are the two chief causes of the deformation or tearing of a layer of asphalt. If it is a new driveway, it must first be excavated to make room for a coating of crushed stone of sufficient thickness. A geotextile membrane is going to be set under the granular backfill if the dirt turns out to be very loamy (clayey). If you own a new house, it is ideal to wait for 6 to 12 months before paving your drive, to allow the dirt to settle naturally. In the case of a fix of this entrance, a simple replacement of the asphalt coating can be considered if the contractor considers that the present foundation is sufficient. In both cases, base redone or base maintained, the duration of its warranty has to be the same.

Tar And Chip Paving Bessemer Alabama

The weather conditions in our lovely state may have a disastrous impact on an asphalt drive, thus the importance of adding a slope having a minimum slope of 2%. This will enable water to drain to the street and decrease the danger of heaving or cracking. This significant detail has to be taken into account when excavating and maintained during backfilling.

In case you have a van or recreational vehicle, notify the builder before the start of the job: he is going to be able to provide materials accordingly. Some asphalt mixtures produce an asphalt which is more immune to heavy-duty vehicles.

The asphalt layer should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 ) in order to reach a thickness of 5 cm (2 in) after being compacted. For optimal stability, the base should extend across the surface to be paved by about thirty centimeters (a couple inches) on each side. Also mention that the installation of unwanted supports around the foundation is a good way to prevent potential cracks and that asphalting done in cold weather is going to be of inferior quality. It's therefore far better to wait for the sunny days to return before starting work.

To avoid unpleasant surprises, then choose your contractor diligently and be sure that the name and address of his company are composed about the contract. The beginning and finish dates of this job, as well as evidence of the builder's liability insurance and the technical details of the project to be carried out, should also be included. No contractor should require a deposit before work starts. To avoid the inconvenience that could cause unforeseen expenses, visit the Tar And Chip PavingBessemer site. You will thus have the resources in hand to successfully complete your asphalt paving project.

Tar And Chip Paving Bessemer - Greatest Alabama in Alabama!

For quality asphalting work , phone on Tar And Chip Paving, Bessemer professional team. Confirm our Company section to figure out the regions served.

Snow Removal Bessemer | Asphalt Bessemer
Home >> alabama/bessemer >> tar and chip paving
Share this...