Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt surface in Birmingham, Alabama


Tar And Chip Paving installed on an unstable surface can quickly lead to problems. There are 3 main options for the basic installation:

  1. Paving Over Existing Driveway: If your current driveway is in good condition and not showing serious fractures or crumbling, hot asphalt mix can be laid directly over your driveway. 1 aspect is height: make certain fences, garage floors, and other structures are not jeopardized by the higher level of the surface.
  2. Remove old driveway, counter into the floor: The existing driveway is completely eliminated (or you may not have a driveway yet) and 4 to 6 inches of hot paving stone is put right on the ground.
  3. Eliminate the old driveway and fasten it into a good surface. This is actually the preferred method. An aggregated stone flooring partially replaces part of the hot asphalt mix.

Our Services:

The best time to install Tar And Chip Paving in Birmingham

The more asphalt you operate, the more leeway you have. By way of example, at 40 F, the crews only have 16 minutes to work on 1 1/2 inch thick asphalt. As the asphalt thickness increases by 3 inches, the workability time also raises: 46 minutes. Generally, for lean asphalt programs (approximately 1.5 cm), you should wait until temperatures are 21 ° C or even higher. Between 50 and 60 F, you'll need to consult with your contractor. The hot mix remains functional during this period, however, the time is constrained.

How much does an Tar And Chip Paving cost in Birmingham?

Consider the weather vagaries of the climate when choosing the standard of asphalt. The substantial temperature variations we experience cause appreciable damage to asphalt perform.

In addition, it'll be good to distinguish the contractor should you have a recreational vehicle or a van. He might have to adapt the asphalt mixture in order to be more immune to the weight of heavy vehicles.

The Benefits of Tar And Chip Paving

  • Smooth end;
  • non-slip
  • easy to maintain
  • watertightness guaranteed
  • withstands the rigors of the Quebec climate quite well (provided it's been installed optimally);
  • prevents the growth of moss;

It'll cost you between $ 3 and $11 per square foot; the price varies depending on the characteristic of the asphalt used and the paving contractor.

To get a sustainable Tar And Chip Paving

The life of an asphalt paver can be up to 20 decades, when the very best states are satisfied. We're talking about a professional paving builder, a good grade of asphalt and an optimal asphalt laying technique.

Tar And Chip Paving in Birmingham: cost, quality of work and lifespan


The longevity of residential asphalt paving chiefly depends on the standard of the placing. Indeed, the significant causes of deformation or tearing of an asphalt coating are the lack of compaction plus a lean base. However, the maintenance of the asphalt sidewalk is also a determining factor in its own longevity. That's to say, you will need to seal your driveway once in ten decades, at a minimum, in order to maintain its great state.


We suggest that you inform your asphalting contractor in case you decide to have your driveway asphalt in order to offer your property. It may not be essential to pay top dollar for laying asphalt , in this circumstance.

Tar And Chip Paving placing: price and contract

The choice of the asphalt laying builder is indispensable. In order to not have unpleasant surprises, you will have to choose it carefully.

Guarantee that the paving contractor has liability insurance coverage. A trip to the web site of the Office for Consumer Protection (OPC) will allow you to verify whether an entrepreneur has ever been the subject of complaints.

These details should be included in the arrangement:

- date of start and end of the work;

- proof of insurance;

- technical details;

- RBQ certification number.

You ought to be aware that a paving builder can't demand you to make a deposit before work has started. But you need to agree on the payment terms and make sure it's on the contract.

Prior to estimating the asphalt drive to your new residence by a builder, or acquiring some basic knowledge is vital to make sure the job is done. Know first that the absence of compaction and the inadequate depth of the foundation are the two main sources for the deformation or ripping of a coating of asphalt. If it is a new driveway, it has to initially be excavated to make room for a layer of crushed stone of adequate depth. A geotextile membrane is going to be set under the granular backfill if the dirt proves to be somewhat loamy (clayey). If you own a new home, it is ideal to wait 6 to 12 months before paving your drive, to allow the dirt to settle . In the case of a repair of this entrance, an easy replacement of the asphalt layer can be considered if the contractor believes that the existing foundation is sufficient. In both cases, base redone or base maintained, the whole period of its guarantee has to be exactly the same.

Tar And Chip Paving Birmingham Alabama

The weather conditions in our beautiful province can have a devastating effect in an asphalt drive, hence the importance of adding a slope with a minimum slope of 2%. This will enable water to drain to the road and minimize the risk of heaving or cracking. This significant detail has to be taken into consideration when excavating and maintained during backfilling.

In case you've got a van or recreational vehicle, notify the contractor prior to the onset of the job: he is going to have the ability to supply materials so. Some asphalt mixtures produce an asphalt which is more immune to heavy-duty vehicles.

The asphalt coating should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 in) in order to accomplish a thickness of 5 cm (2 in) after being compacted. For optimum stability, the base should extend across the surface to be paved by about thirty centimeters (a couple inches) on each side. Also mention that the setup of unwanted supports around the base is a fantastic way to prevent possible cracks and this asphalting done in cold weather is going to be of poor quality. It is therefore far better to await the bright days to go back before beginning work.

A definite contract with your builder in Birmingham

To avoid unpleasant surprises, select your contractor and be sure the name and address of his business are composed about the contract. The start and finish dates of the work, as well as proof of this builder's liability insurance and the technical specifics of the job to be completed, should also be included. No contractor should need a deposit before work starts. To avoid the inconvenience that could cause unforeseen expenses, visit the Tar And Chip PavingBirmingham website. You will thus have the resources in hand to successfully complete your asphalt paving project.

Tar And Chip Paving Birmingham - Best Alabama at Alabama!

For caliber asphalting perform , phone on Tar And Chip Paving, Birmingham professional team. We've got over twenty decades of experience in asphalt laying, resurfacing, maintenance and repair. Confirm our Business section to figure out the regions served.

Snow Removal Birmingham | Asphalt Birmingham
Home >> alabama/birmingham >> tar and chip paving
Share this...