Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Options for the asphalt Coating in Center Point, Alabama


Tar And Chip Paving installed on an unstable surface can quickly lead to problems. There are three main choices for the Simple setup:

  1. Paving Over Existing Driveway: If your existing driveway is in good condition rather than revealing severe cracks or crumbling, hot asphalt mixture can be laid directly over your driveway. One aspect is elevation: make certain fences, garage flooring, and other constructions are not jeopardized by the greater degree of this surface.
  2. Remove old driveway, counter into the ground: The existing driveway is totally eliminated (or you may not have a driveway yet) and 4 to 6 inches of warm paving stone is put right on the ground.
  3. Remove the old driveway and fasten it to a solid surface. This is the preferred method. An aggregated stone flooring partially replaces part of this hot asphalt mix.

Our Services:

The best time to install Tar And Chip Paving from Center Point

The longer asphalt you work, the more leeway you might have. For example, at 40 F, the crews only have 16 minutes to work on 1 1/2 inch thick asphalt. As the asphalt thickness increases by 3 inches, the workability time also raises: 46 minutes. In general, for thin asphalt applications (about 1.5 cm), you should wait until temperatures are 21 ° C or higher. Between 50 and 60 F, then you'll need to speak to your contractor. The hot mix remains practical during this period, however, the time is constrained.

How much does an Tar And Chip Paving cost in Center Point?

Consider the weather vagaries of our climate when deciding upon the quality of asphalt. The significant temperature variations we experience cause appreciable damage to asphalt work.

In addition, it will be useful to tell the contractor should you have a recreational vehicle or even a van. He will have to adapt the asphalt mixture in order to be more immune to the burden of heavy vehicles.

The advantages of Tar And Chip Paving

A driveway paved with asphalt has several benefits:

It will cost you between $ 3 and $11 per square foot; the price varies depending on the quality of the asphalt used and the paving contractor.

To get a sustainable Tar And Chip Paving

The existence of an asphalt paver can be around 20 decades, when the very best conditions are met. We're referring to a professional paving contractor, a good grade of asphalt and an optimal asphalt laying technique.

Tar And Chip Paving in Center Point: price, quality of work and lifespan


The durability of residential asphalt paving chiefly depends upon the quality of the placing. Indeed, the significant causes of deformation or ripping of an asphalt coating are the absence of compaction plus a thin foundation. However, the maintenance of the asphalt pavement is also a determining factor in its longevity. That's to say, you will need to seal your drive once in 10 decades, at a minimum, so as to maintain its great state.


We advise you to notify your asphalting contractor in case you choose to have your driveway asphalt in order to sell your property. It might not be essential to pay top dollar for laying asphalt , in this circumstance.

Tar And Chip Paving placing: cost and contract

The option of the asphalt laying contractor is essential. In order to not have unpleasant surprises, then you will need to choose it carefully.

Guarantee that the paving contractor has liability insurance. A trip to the website of the Office for Consumer Protection (OPC) will make it possible for you to verify whether an entrepreneur has been the subject of complaints.

The following details should be included in the contract:

- date of beginning and finish of the job;

- evidence of insurance;

- technical particulars;

- RBQ accreditation number.

You ought to be aware that a paving builder cannot demand you to make a deposit before work has begun. However, you should agree to the payment terms and make sure it is on the contract.

Prior to estimating the asphalt driveway to your new residence by a contractor, or obtaining some fundamental knowledge is imperative to guarantee that the job is well done. Know first that the absence of compaction and the insufficient thickness of the foundation are the two chief sources for the deformation or ripping of a coating of asphalt. If it's a new driveway, it has to first be excavated to make room for a layer of crushed stone of adequate thickness. A geotextile membrane will be placed beneath the granular backfill if the soil proves to be somewhat loamy (clayey). If you own a new house, it's ideal to wait for 6 to 12 months prior to paving your drive, to allow the dirt to settle naturally. In the case of a fix of this entry, an easy replacement of the asphalt coating can be considered in the event the contractor considers that the existing base is sufficient. In both scenarios, base redone or base maintained, the whole period of its warranty has to be the same.

Tar And Chip Paving Center Point Alabama

The weather conditions in our lovely state may have a devastating effect in an asphalt drive, hence the significance of adding a slope with a minimum slope of 2%. This will enable water to drain to the road and decrease the risk of heaving or cracking. This important detail must be taken into consideration when excavating and maintained during backfilling.

If you've got a van or recreational vehicle, notify the builder before the onset of the work: he will have the ability to provide materials so. Some asphalt mixtures produce an asphalt which is more resistant to heavy duty vehicles.

The asphalt layer should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 ) so as to accomplish a thickness of at least 5 cm (2 ) after being compacted. For optimal stability, the base should extend across the surface to be paved by about thirty centimeters (a dozen inches) on each side. Also mention that the setup of unwanted supports around the foundation is a good method to avoid possible cracks and this asphalting done in chilly weather will be of inferior quality. It's therefore far better to wait for the bright days to go back before starting work.

A Tar And Chip Paving contract with your contractor in Center Point

To avoid unpleasant surprises, choose your contractor and make certain the name and address of the company are composed about the contract. The start and finish dates of this job, in addition to proof of this contractor's liability insurance and also the technical specifics of the project to be completed, should also be included. No contractor should need a down payment before work begins. To prevent the inconvenience that could lead to unforeseen costs, take a look at the Tar And Chip PavingCenter Point site. You will thus have all the resources in hand to successfully finish your asphalt paving project.

Tar And Chip Paving Center Point - Greatest Alabama in Alabama!

For quality asphalting work , phone on Tar And Chip Paving, Center Point professional team. Consult our Business department to figure out the regions served.

Snow Removal Center Point | Asphalt Center Point
Home >> alabama/center point >> tar and chip paving
Share this...