Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Options for the asphalt Coating in Cullman, Alabama


Tar And Chip Paving installed in an unstable surface could quickly lead to problems. There are 3 Chief options for the Simple installation:

  1. Paving Over Existing Driveway: If your existing driveway is in good condition rather than showing serious cracks or crumbling, hot asphalt mix can be placed directly within your driveway. 1 aspect is height: make sure fences, garage flooring, and other structures are not compromised by the greater level of the surface.
  2. Eliminate old driveway, counter into the ground: The present driveway is completely eliminated (or you might not have a driveway yet) and 4 to 6 inches of warm paving stone is put right on the ground.
  3. Eliminate the old driveway and fasten it to a solid surface. This is actually the preferred method. An aggregated stone floor partially replaces part of the hot asphalt mix. Generally 6 to 8 inches of limestone goes under 3 inches of asphalt.

Our Services:

The best time to install Tar And Chip Paving in Cullman

The longer asphalt you operate, the more leeway you have. For instance, at 40 F, the crews just have 16 minutes to operate on 1 1/2 inch thick asphalt. Generally, for thin asphalt programs (about 1.5 cm), you should wait until temperatures are 21 ° C or higher. Between 50 and 60 F, then you'll need to consult with your contractor. The hot mix remains practical during this period of time, but the time is limited.

How much can an Tar And Chip Paving price in Cullman?

Take into account the weather vagaries of our climate when deciding upon the quality of asphalt. The significant temperature variations we experience cause appreciable damage to asphalt work.

Furthermore, it will be good to distinguish the contractor if you own a recreational vehicle or a van. He might have to accommodate the asphalt mix in order to be more resistant to the weight of heavy vehicles.

The advantages of Tar And Chip Paving

  • Smooth finish;
  • non-slip
  • easy to maintain
  • watertightness ensured
  • withstands the rigors of the Quebec climate very well (provided it has been installed optimally);
  • prevents the growth of moss;

It'll cost you between $ 3 and $11 per square foot; the cost varies depending on the characteristic of the asphalt used and the paving contractor.

To get a sustainable Tar And Chip Paving

The existence of an asphalt paver can be up to 20 years, when the very best states are satisfied. We are talking about a professional paving contractor, a great quality of asphalt and an optimal asphalt laying technique.

Tar And Chip Paving in Cullman: price, quality of work and lifespan


The longevity of residential asphalt paving largely is dependent on the standard of the laying. Indeed, the major causes of deformation or ripping of an asphalt layer are the lack of compaction plus a thin foundation. On the other hand, the maintenance of the asphalt pavement can be a deciding factor in its own longevity. That's to say, you'll have to seal your drive once in 10 years, at a minimum, in order to keep its good condition.


We suggest that you notify your asphalting contractor if you choose to get your driveway asphalt so as to sell your property. It might not be necessary to pay top dollar for placing asphalt , in this circumstance.

Tar And Chip Paving laying: cost and contract

The choice of the asphalt laying contractor is essential. In order not to have unpleasant surprises, you will have to select it carefully.

Our guarantees and Tar And Chip Paving work

Guarantee that the paving contractor has liability insurance. A visit to the web site of the Office for Consumer Protection (OPC) will allow you to confirm whether an entrepreneur has become the subject of complaints.

The following details should be included in the contract:

- date of start and end of the work;

- proof of insurance;

- technical details;

- RBQ accreditation number.

You ought to be aware that a paving contractor cannot require you to make a deposit before work has started. But you should agree on the payment terms and make sure it is about the contract.

A strong base for Tar And Chip Paving- Cullman

Prior to estimating the asphalt driveway to your new residence by a contractor, or acquiring some basic knowledge is imperative to make sure the job is done. Know first that the absence of compaction and the inadequate depth of the base are the two chief sources for the deformation or ripping of a layer of asphalt. When it's a new driveway, it must first be excavated to make room for a layer of crushed stone of sufficient depth. A geotextile membrane will be set under the granular backfill if the dirt turns out to be somewhat loamy (clayey). If you have a new home, it is best to wait for 6 to 12 months before paving your driveway, to allow the dirt to settle naturally. In the case of a fix of this entrance, an easy replacement of the asphalt layer can be considered if the contractor considers that the existing foundation is adequate. In both scenarios, foundation redone or foundation preserved, the whole period of its guarantee has to be exactly the same.

Tar And Chip Paving Cullman Alabama

The weather conditions in our beautiful province may have a devastating effect on an asphalt driveway, thus the significance of adding a slope having a minimum slope of 2%. This will enable water to drain into the street and decrease the danger of heaving or cracking. This important detail has to be taken into consideration when excavating and preserved during backfilling.

If you've got a van or recreational vehicle, notify the contractor prior to the start of the job: he is going to be able to supply materials accordingly. Some asphalt combinations produce an asphalt which is more resistant to heavy-duty vehicles.

The asphalt coating should have an initial thickness of 6.35 to 7.6 cm (2.5 to 3 ) in order to reach a thickness of 5 cm (2 ) after being compacted. For optimum stability, the foundation should extend over the surface to be paved by roughly thirty centimeters (a dozen inches) on each side. Also mention that the installation of side supports around the base is a good way to avoid potential cracks and that asphalting done in cold weather is going to be of poor quality. It is therefore better to wait for the bright days to return before starting work.

To avoid unpleasant surprises, then select your contractor diligently and make sure that the name and address of his company are written about the contract. The beginning and end dates of the work, in addition to evidence of the contractor's liability insurance and the technical specifics of the job to be completed, should also be included. No contractor should require a deposit before work begins. To avoid the inconvenience that could cause unforeseen expenses, visit the Tar And Chip PavingCullman website. You will thus have all the tools in hand to successfully finish your asphalt paving project.

Tar And Chip Paving Cullman - Best Alabama in Alabama!

For quality asphalting perform , call on Tar And Chip Paving, Cullman professional team. Consult our Business department to find out the regions served.

Snow Removal Cullman | Asphalt Cullman
Home >> alabama/cullman >> tar and chip paving
Share this...