Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Options for the asphalt Coating in Decatur, Alabama


Tar And Chip Paving installed in an unstable surface could quickly lead to difficulties. There are three main options for the Simple setup:

  1. Paving Over Existing Driveway: If your existing driveway is in good shape and not revealing serious cracks or crumbling, hot asphalt mixture can be laid directly over your driveway. 1 aspect is height: make sure fences, garage flooring, and other constructions are not jeopardized by the higher level of the new surface.
  2. Eliminate old driveway, counter into the floor: The present driveway is completely removed (or you might not have a driveway nonetheless ) and 4 to 6 inches of warm paving stone is put right on the ground.
  3. Remove the old driveway and fasten it to a solid surface. This is actually the preferred method. An aggregated stone flooring partially replaces part of this hot asphalt mix.

Our Services:

The best time to install Tar And Chip Paving in Decatur

The more asphalt you work, the more leeway you have. For example, at 40 F, the crews only have 16 minutes to operate on 1 1/2 inch thick asphalt. As the asphalt thickness increases by 3 inches, the workability time also raises: 46 minutes. In general, for thin asphalt programs (approximately 1.5 cm), you should wait until temperatures are 21 ° C or higher. Between 50 and 60 F, then you'll need to consult with your contractor. The hot mix is ​​still functional during this period of time, but the time is limited.

How much can an Tar And Chip Paving price in Decatur?

Consider the weather vagaries of our climate when deciding upon the quality of asphalt. The substantial temperature variations that we experience cause considerable damage to asphalt work.

Furthermore, it'll be useful to distinguish the contractor if you own a recreational vehicle or a van. He will have to adapt the asphalt mix so as to be more immune to the burden of heavy vehicles.

The advantages of Tar And Chip Paving

A driveway paved with asphalt has several benefits:

It'll cost you between $ 3 and $11 per square foot; the price fluctuates based on the quality of the asphalt used along with the paving contractor.

To get a sustainable Tar And Chip Paving

The existence of an asphalt paver can be up to 20 years, when the best states are satisfied. We're talking about a professional paving contractor, a good quality of asphalt and an optimal asphalt laying technique.


The longevity of residential asphalt paving chiefly is dependent upon the quality of the laying. Indeed, the major causes of deformation or ripping of an asphalt layer are the absence of compaction and a lean base. However, the upkeep of the asphalt pavement is also a deciding factor in its longevity. That is to say, you will need to seal your drive once in 10 decades, at a minimum, so as to keep its good condition.


We advise you to inform your asphalting builder in case you choose to have your driveway asphalt so as to offer your property. It may not be necessary to pay top dollar for laying asphalt , in this circumstance.

Tar And Chip Paving laying: price and contract

The option of the asphalt laying contractor is essential. In order not to have unpleasant surprises, you'll have to choose it carefully.

Guarantee that the paving contractor has liability insurance. A visit to the web site of the Office for Consumer Protection (OPC) will allow you to verify whether an entrepreneur has been the subject of complaints.

The following details should be included in the arrangement:

- date of beginning and finish of the work;

- proof of insurance;

- technical details;

- RBQ certification number.

You ought to know that a paving builder can't require you to make a deposit before work has started. But you need to agree to the payment terms and make sure it's about the contract.

Before redoing the asphalt drive to your new residence by a contractor, or obtaining some fundamental knowledge is imperative to guarantee that the job is done. Know first that the absence of compaction and the inadequate thickness of the base are the two main sources for the deformation or ripping of a coating of asphalt. If it is a new driveway, then it must first be excavated to make room for a layer of crushed stone of adequate thickness. A geotextile membrane will be placed beneath the granular backfill if the soil turns out to be somewhat loamy (clayey). If you own a new house, it is best to wait 6 to 12 months before paving your drive, to enable the dirt to settle naturally. In the event of a repair of the entrance, an easy replacement of the asphalt coating can be considered if the contractor considers that the present foundation is sufficient. In both scenarios, foundation redone or foundation preserved, the duration of its guarantee has to be exactly the same.

Tar And Chip Paving Decatur Alabama

The weather conditions in our beautiful province can have a disastrous impact on an asphalt drive, hence the significance of adding a slope having a minimum slope of 2%. This will enable water to drain into the road and minimize the danger of heaving or cracking. This significant detail has to be taken into consideration when excavating and maintained during backfilling.

If you have a van or recreational vehicle, notify the contractor prior to the onset of the job: he is going to have the ability to provide materials so. Some asphalt mixtures produce an asphalt that is more immune to heavy-duty vehicles.

The asphalt coating should have an initial thickness of 6.35 to 7.6 cm (2.5 to 3 in) so as to reach a thickness of at least 5 cm (2 ) after being compacted. For optimal stability, the foundation should extend across the surface to be paved by about thirty centimeters (a dozen inches) on each side. Also mention that the installation of side supports around the foundation is a good way to avoid potential cracks and that asphalting done in chilly weather will be of inferior quality. It is therefore better to await the sunny days to go back before beginning work.

To avoid unpleasant surprises, then select your contractor diligently and be certain that the title and address of his business are written about the contract. The start and finish dates of the job, as well as evidence of this contractor's liability insurance and also the technical specifics of this job to be completed, should also be included. No contractor should require a down payment before work starts. To avoid the inconvenience that might lead to unforeseen costs, take a look at the Tar And Chip PavingDecatur website. You may thus have all the tools in hand to successfully finish your asphalt paving project.

Tar And Chip Paving Decatur - Best Alabama in Alabama!

For caliber asphalting perform , call on Tar And Chip Paving, Decatur professional team. We've got more than twenty years of expertise in asphalt laying, resurfacing, maintenance and repair. Consult our Company department to figure out the regions served.

Snow Removal Decatur | Asphalt Decatur
Home >> alabama/decatur >> tar and chip paving
Share this...