Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt surface in Fort Payne, Alabama


Tar And Chip Paving installed on an unstable surface can quickly lead to problems. There are three Chief options for the basic installation:

  1. Paving Over Existing Driveway: If your current driveway is in good condition and not showing serious fractures or crumbling, hot asphalt mix can be laid directly over your driveway. One facet is elevation: make sure fences, garage floors, and other constructions are not jeopardized by the greater degree of the new surface.
  2. Remove old driveway, peg to the ground: The existing driveway is completely removed (or you might not have a driveway yet) and 4 to 6 inches of hot paving stone is put right on the ground.
  3. Remove the old driveway and fasten it to a solid surface. This is the preferred method. An aggregated stone floor partially replaces part of this hot asphalt mixture.

Our Services:

The best time to install Tar And Chip Paving in Fort Payne

The longer asphalt you operate, the more leeway you have. By way of instance, in 40 F, the crews just have 16 minutes to operate on 1 1/2 inch thick asphalt. In general, for lean asphalt applications (about 1.5 cm), you should wait until temperatures are 21 ° C or even higher. Between 50 and 60 F, you'll need to consult with your contractor. The hot mix remains practical during this period of time, but the time is constrained.

How much can an Tar And Chip Paving price in Fort Payne?

Consider the weather vagaries of our climate when choosing the quality of asphalt. The substantial temperature variations we experience cause appreciable damage to asphalt work.

In addition, it will be useful to tell the contractor if you have a recreational vehicle or even a van. He might need to accommodate the asphalt mix so as to be more immune to the burden of heavy vehicles.

The Benefits of Tar And Chip Paving

A driveway paved with asphalt has several benefits:

It will cost you between $ 3 and $11 per square foot; the price fluctuates based on the quality of the asphalt employed along with the paving contractor.

To get a sustainable Tar And Chip Paving

The life of an asphalt paver may be up to 20 decades, when the very best conditions are met. We are referring to a professional paving builder, a good grade of asphalt as well as an optimal asphalt laying technique.

Tar And Chip Paving in Fort Payne: cost, quality of work and lifespan


The durability of residential asphalt paving largely is dependent upon the quality of the laying. Indeed, the major causes of deformation or ripping of an asphalt coating are the lack of compaction and a thin foundation. However, the upkeep of the asphalt pavement can be a determining factor in its longevity. That's to say, you will have to seal your driveway once in ten years, at a minimum, in order to maintain its good condition.


We advise you to notify your asphalting contractor in case you choose to get your driveway asphalt so as to offer your property. It may not be essential to pay top dollar for laying asphalt , in this circumstance.

Tar And Chip Paving laying: cost and contract

The choice of the asphalt laying builder is indispensable. In order not to have unpleasant surprises, then you will need to select it carefully.

Make sure the paving contractor has liability insurance. A visit to the web site of the Office for Consumer Protection (OPC) will make it possible for you to confirm whether an entrepreneur has been the subject of complaints.

The following details must be included in the contract:

- date of start and finish of the job;

- proof of insurance;

- technical particulars;

- RBQ certification number.

You ought to know that a paving builder can't require that you make a down payment before work has started. However, you should agree to the payment provisions and be sure it's on the contract.

Before redoing the asphalt driveway to your new home by a builder, or obtaining some fundamental knowledge is vital to make sure the job is done. Know first that the lack of compaction and the insufficient depth of the foundation are the two main causes of the deformation or ripping of a coating of asphalt. If it's a new driveway, then it must first be excavated to make room for a coating of crushed stone of adequate depth. A geotextile membrane will be placed under the granular backfill if the soil proves to be somewhat loamy (clayey). If you own a new home, it's ideal to wait for 6 to 12 months prior to paving your driveway, to allow the dirt to settle naturally. In the case of a repair of the entry, an easy replacement of the asphalt coating can be considered if the contractor considers that the present foundation is adequate. In both cases, base redone or base preserved, the duration of its guarantee must be exactly the same.

Tar And Chip Paving Fort Payne Alabama

The weather conditions in our beautiful province may have a disastrous impact in an asphalt driveway, hence the importance of adding a slope with a minimum slope of 2%. This will allow water to drain to the road and decrease the risk of heaving or cracking. This important detail has to be taken into consideration when excavating and preserved during backfilling.

If you have a van or recreational vehicle, notify the builder prior to the start of the work: he will be able to supply materials accordingly. Some asphalt mixtures produce an asphalt that is more immune to heavy-duty vehicles.

The asphalt layer should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 ) so as to reach a thickness of 5 cm (2 in) after being compacted. For optimum stability, the base should extend over the surface to be paved by about thirty centimeters (a couple inches) on each side. Also note that the installation of unwanted supports around the foundation is a fantastic method to prevent possible cracks and this asphalting done in cold weather will be of poor quality. It's therefore better to wait for the bright days to go back before beginning work.

A Tar And Chip Paving contract with your builder in Fort Payne

To avoid unpleasant surprises, choose your contractor and make certain that the name and address of his business are composed on the contract. The start and end dates of this work, in addition to evidence of this contractor's liability insurance and also the technical details of this project to be completed, should also be included. No contractor should need a deposit before work begins. To avoid the inconvenience that could lead to unforeseen expenses, take a look at the Tar And Chip PavingFort Payne website. You will thus have the resources in hand to successfully finish your asphalt paving project.

Tar And Chip Paving Fort Payne - Best Alabama at Alabama!

For quality asphalting work , phone on Tar And Chip Paving, Fort Payne specialist team. We have over 20 decades of expertise in asphalt laying, resurfacing, maintenance and repair. Confirm our Company department to find out the regions served.

Snow Removal Fort Payne | Asphalt Fort Payne
Home >> alabama/fort payne >> tar and chip paving
Share this...