Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt surface in Gadsden, Alabama


Tar And Chip Paving installed in an unstable surface can quickly lead to difficulties. There are three Chief choices for the Simple setup:

  1. Paving Over Existing Driveway: If your existing driveway is in good condition rather than revealing serious fractures or crumbling, hot asphalt mix can be laid directly over your driveway. 1 facet is elevation: make certain fences, garage flooring, and other structures aren't compromised by the higher degree of this new surface.
  2. Eliminate old driveway, counter into the floor: The existing driveway is completely eliminated (or you may not have a driveway yet) and 4 to 6 inches of hot paving stone is placed right on the ground.
  3. Remove the old driveway and fasten it to a solid surface. This is actually the preferred method. An aggregated stone floor partly replaces part of this hot asphalt mixture.

Our Services:

The best time to install Tar And Chip Paving in Gadsden

The more asphalt you operate, the more leeway you have. For example, at 40 F, the crews only have 16 minutes to work on 1 1/2 inch thick asphalt. As the asphalt depth increases by 3 inches, the workability time also raises: 46 minutes. In general, for thin asphalt applications (approximately 1.5 cm), you should wait until temperatures are 21 ° C or higher. Between 50 and 60 F, then you'll need to speak to your contractor. The hot mix remains functional during this period of time, but the time is limited.

How much does an Tar And Chip Paving cost in Gadsden?

Consider the weather vagaries of our climate when deciding upon the quality of asphalt. The significant temperature variations that we experience cause appreciable damage to asphalt work.

Furthermore, it will be good to distinguish the contractor if you own a recreational vehicle or a van. He might have to accommodate the asphalt mix in order to be more resistant to the weight of heavy vehicles.

The Benefits of Tar And Chip Paving

A driveway paved with asphalt has several benefits:

It will cost you between $ 3 and $11 per square foot; the price fluctuates based on the quality of the asphalt employed and the paving contractor.

For a sustainable Tar And Chip Paving

The existence of an asphalt paver can be around 20 years, when the very best conditions are satisfied. We're referring to a professional paving builder, a good grade of asphalt and also an optimal asphalt laying technique.

Tar And Chip Paving in Gadsden: cost, quality of work and lifespan


The durability of residential asphalt paving largely is dependent on the quality of the laying. Indeed, the major causes of deformation or tearing of an asphalt layer are the absence of compaction and a lean base. However, the upkeep of the asphalt sidewalk is also a deciding factor in its own longevity. That is to say, you'll have to seal your drive once in ten years, at a minimum, so as to maintain its great state.


We advise you to notify your asphalting builder in case you choose to get your driveway asphalt in order to sell your property. It might not be essential to pay top dollar for placing asphalt , in such a circumstance.

Tar And Chip Paving placing: price and contract

The option of the asphalt laying builder is essential. In order not to have unpleasant surprises, then you will need to choose it carefully.

Our guarantees and Tar And Chip Paving work

Make sure the paving contractor has liability insurance. A visit to the web site of the Office for Consumer Protection (OPC) will make it possible for you to verify whether an entrepreneur has ever been the subject of complaints.

The following details should be included in the arrangement:

- date of start and end of the job;

- evidence of insurance;

- technical details;

- RBQ certification number.

You should know that a paving contractor cannot require you to make a deposit before work has begun. But you need to agree on the payment terms and be sure it's about the contract.

A strong base for Tar And Chip Paving- Gadsden

Before redoing the asphalt drive to your new home by a builder, or acquiring some fundamental knowledge is vital to make sure the job is well done. Know first that the lack of compaction and the insufficient depth of the base are the two main sources for the deformation or tearing of a layer of asphalt. If it's a new driveway, then it has to first be excavated to make room for a layer of crushed stone of sufficient depth. A geotextile membrane will be placed under the granular backfill if the soil proves to be somewhat loamy (clayey). If you have a new home, it is best to wait 6 to 12 months prior to paving your driveway, to allow the soil to settle . In the case of a repair of the entrance, an easy replacement of the asphalt coating can be considered in the event the contractor considers that the present base is adequate. In both cases, base redone or foundation preserved, the whole period of its warranty has to be the same.

Tar And Chip Paving Gadsden Alabama

The weather conditions in our lovely state may have a disastrous impact on an asphalt drive, thus the importance of including a slope with a minimum slope of 2%. This will allow water to drain into the road and decrease the danger of heaving or cracking. This important detail must be taken into consideration when excavating and preserved during backfilling.

In case you've got a van or recreational vehicle, notify the builder before the onset of the job: he is going to have the ability to provide materials so. Some asphalt combinations produce an asphalt that is more resistant to heavy duty vehicles.

The asphalt layer should have an initial thickness of 6.35 to 7.6 cm (2.5 to 3 ) in order to accomplish a thickness of 5 cm (2 ) after being compacted. For optimal stability, the foundation should extend across the surface to be paved by roughly thirty centimeters (a dozen inches) on each side. Also mention that the installation of side supports around the foundation is a fantastic way to prevent potential cracks and this asphalting done in cold weather will be of inferior quality. It's therefore better to wait for the bright days to go back before beginning work.

To avoid unpleasant surprises, then choose your contractor and be certain the title and address of the business are composed on the contract. The start and finish dates of the work, as well as evidence of the builder's liability insurance and the technical details of this project to be carried out, should also be included. No contractor should need a down payment before work starts. To prevent the inconvenience that might cause unforeseen costs, visit the Tar And Chip PavingGadsden site. You will thus have all the tools in hand to successfully complete your asphalt paving project.

Tar And Chip Paving Gadsden - Best Alabama in Alabama!

For quality asphalting perform , phone on Tar And Chip Paving, Gadsden specialist team. Consult our Business section to figure out the regions served.

Snow Removal Gadsden | Asphalt Gadsden
Home >> alabama/gadsden >> tar and chip paving
Share this...