Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Options for the asphalt Coating in Gulf Shores, Alabama


Tar And Chip Paving installed on an unstable surface can quickly lead to problems. There are three Chief choices for the Simple setup:

  1. Paving Over Existing Driveway: If your current driveway is in good condition rather than revealing severe fractures or crumbling, hot asphalt mixture can be laid directly over your driveway. 1 facet is elevation: make sure fences, garage floors, and other structures aren't compromised by the higher level of this new surface.
  2. Eliminate old driveway, counter into the floor: The present driveway is totally eliminated (or you may not have a driveway yet) and 4 to 6 inches of hot paving stone is put directly on the ground.
  3. Remove the old driveway and secure it to a good surface. This is the preferred method. An aggregated stone flooring partially replaces part of the hot asphalt mix. Generally 6 to 8 inches of aggregate extends under 3 inches of asphalt.

Our Services:

The best time to install Tar And Chip Paving in Gulf Shores

The longer asphalt you work, the more leeway you might have. By way of instance, at 40 F, the crews only have 16 minutes to work on 1 1/2 inch thick asphalt. In general, for thin asphalt applications (approximately 1.5 cm), you should wait until temperatures are 21 ° C or higher. Between 50 and 60 F, you'll need to consult with your contractor. The hot mix remains practical during this period, however, the time is constrained.

How much does an Tar And Chip Paving price in Gulf Shores?

Consider the weather vagaries of the climate when choosing the quality of asphalt. The substantial temperature variations that we experience cause considerable damage to asphalt work.

Furthermore, it will be useful to distinguish the contractor if you own a recreational vehicle or a van. He will need to adapt the asphalt mix so as to be more resistant to the weight of heavy vehicles.

The Benefits of Tar And Chip Paving

  • Smooth finish;
  • non invasive
  • Simple to maintain
  • watertightness ensured
  • withstands the rigors of the Quebec climate quite well (provided it has been set up optimally);
  • prevents the growth of moss;

It'll cost you between $ 3 and $11 per square foot; the price fluctuates based on the characteristic of the asphalt employed along with the paving contractor.

For a sustainable Tar And Chip Paving

The life of an asphalt paver may be up to 20 decades, when the best states are met. We are talking about a professional paving contractor, a great quality of asphalt and an optimal asphalt laying technique.


The longevity of residential asphalt paving chiefly depends on the standard of the laying. Indeed, the significant causes of deformation or ripping of an asphalt layer are the lack of compaction plus a lean base. On the other hand, the maintenance of the asphalt sidewalk can be a determining factor in its longevity. That's to say, you will have to seal your drive once in ten decades, at a minimum, in order to keep its great state.


We advise you to inform your asphalting contractor if you decide to get your driveway asphalt so as to sell your property. It may not be necessary to pay top dollar for placing asphalt , in such a case.

Tar And Chip Paving placing: price and contract

The option of the asphalt laying contractor is essential. In order to not have unpleasant surprises, you will need to choose it carefully.

Our ensures and Tar And Chip Paving work

Make sure the paving contractor has liability insurance coverage. A visit to the web site of the Office for Consumer Protection (OPC) will allow you to verify whether an entrepreneur has been the subject of complaints.

The following details should be included in the arrangement:

- date of start and end of the job;

- proof of insurance;

- technical details;

- RBQ certification number.

You should know that a paving contractor cannot demand you to make a deposit before work has started. However, you need to agree on the payment provisions and make sure it's on the contract.

Before redoing the asphalt drive to your new home by a contractor, or obtaining some basic knowledge is vital to guarantee that the job is well done. Know first that the lack of compaction and the inadequate depth of the base are the two main causes of the deformation or tearing of a layer of asphalt. If it is a new driveway, then it has to initially be excavated to make room for a layer of crushed stone of adequate depth. A geotextile membrane is going to be placed under the granular backfill if the dirt turns out to be somewhat loamy (clayey). If you own a new home, it's ideal to wait for 6 to 12 months before paving your driveway, to enable the dirt to settle naturally. In the event of a fix of this entrance, an easy replacement of the asphalt layer can be considered in the event the contractor considers that the present foundation is sufficient. In both cases, base redone or foundation maintained, the whole period of its guarantee has to be the same.

Tar And Chip Paving Gulf Shores Alabama

The weather conditions in our lovely state can have a disastrous impact on an asphalt drive, hence the importance of including a slope with a minimum slope of 2%. This will enable water to drain into the street and decrease the risk of heaving or cracking. This significant detail has to be taken into consideration when excavating and maintained during backfilling.

In case you've got a van or recreational vehicle, notify the contractor before the onset of the work: he will have the ability to supply materials accordingly. Some asphalt mixtures produce an asphalt that is more immune to heavy-duty vehicles.

The asphalt coating should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 in) so as to reach a thickness of 5 cm (2 ) after being compacted. For optimum stability, the base should extend across the surface to be paved by about thirty centimeters (a couple inches) on each side. Also mention that the setup of side supports around the foundation is a fantastic method to prevent possible cracks and this asphalting done in chilly weather is going to be of poor quality. It's therefore better to await the bright days to go back before starting work.

To avoid unpleasant surprises, then choose your contractor diligently and make certain that the title and address of his business are written on the contract. The start and end dates of the work, in addition to proof of the contractor's liability insurance and also the technical details of the job to be carried out, should also be included. No contractor should require a deposit before work begins. To avoid the inconvenience that could cause unforeseen expenses, visit the Tar And Chip PavingGulf Shores website. You will thus have the tools in hand to successfully finish your asphalt paving project.

Tar And Chip Paving Gulf Shores - Greatest Alabama at Alabama!

For quality asphalting work , phone on Tar And Chip Paving, Gulf Shores professional team. We've got more than twenty years of expertise in asphalt laying, resurfacing, maintenance and repair. Confirm our Business department to figure out the regions served.

Snow Removal Gulf Shores | Asphalt Gulf Shores
Home >> alabama/gulf shores >> tar and chip paving
Share this...