Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt surface in Hartselle, Alabama


Tar And Chip Paving installed in an unstable surface can quickly lead to difficulties. There are 3 Chief options for the basic installation:

  1. Paving Over Existing Driveway: If your existing driveway is in good condition rather than revealing severe fractures or crumbling, hot asphalt mixture can be placed directly within your driveway. One facet is height: make certain fences, garage flooring, and other structures are not compromised by the greater degree of this new surface.
  2. Remove old driveway, peg to the ground: The present driveway is completely removed (or you might not have a driveway nonetheless ) and 4 to 6 inches of hot paving stone is placed directly on the ground.
  3. Eliminate the old driveway and secure it to a good surface. This is the preferred method. An aggregated stone floor partially replaces part of this hot asphalt mix.

The more asphalt you work, the more leeway you might have. By way of example, at 40 F, the crews only have 16 minutes to operate on 1 1/2 inch thick asphalt. As the asphalt thickness increases by 3 inches, the workability time also raises: 46 minutes. Generally, for thin asphalt programs (about 1.5 cm), you should wait until temperatures are 21 ° C or even higher. Between 50 and 60 F, then you ought to consult with your contractor. The hot mix remains practical during this period, however, the time is constrained.

How much can an Tar And Chip Paving cost in Hartselle?

Consider the weather vagaries of the climate when deciding upon the standard of asphalt. The substantial temperature variations that we experience cause appreciable damage to asphalt perform.

Furthermore, it will be good to distinguish the contractor should you have a recreational vehicle or a van. He might have to accommodate the asphalt mix in order to be more resistant to the weight of heavy vehicles.

The Benefits of Tar And Chip Paving

  • Smooth end;
  • non invasive
  • Simple to Keep
  • watertightness ensured
  • withstands the rigors of this Quebec climate quite well (provided it has been set up );
  • prevents the growth of moss;

It will cost you between $ 3 and $11 per square foot; the price fluctuates based on the quality of the asphalt employed and the paving contractor.

To get a sustainable Tar And Chip Paving

The life of an asphalt paver can be around 20 years, when the best states are met. We're talking about a professional paving contractor, a great quality of asphalt and also an optimal asphalt laying technique.

Tar And Chip Paving in Hartselle: cost, quality of work and lifespan


The durability of residential asphalt paving chiefly is dependent on the quality of the laying. Indeed, the major causes of deformation or tearing of an asphalt layer are the lack of compaction plus a lean base. However, the maintenance of the asphalt pavement is also a deciding factor in its longevity. That is to say, you'll have to seal your drive once in ten years, at a minimum, in order to keep its good state.


We suggest that you inform your asphalting contractor in case you decide to have your driveway asphalt in order to sell your property. It might not be essential to pay top dollar for laying asphalt , in this circumstance.

Tar And Chip Paving placing: cost and contract

The choice of the asphalt laying contractor is essential. In order not to have unpleasant surprises, then you'll need to select it carefully.

Make sure the paving contractor has liability insurance. A trip to the web site of the Office for Consumer Protection (OPC) will allow you to verify whether an entrepreneur has ever become the subject of complaints.

These details should be included in the arrangement:

- date of start and finish of the job;

- proof of insurance;

- technical details;

- RBQ accreditation number.

You ought to know that a paving builder cannot demand that you make a down payment before work has begun. However, you should agree to the payment terms and make sure it is on the contract.

Prior to estimating the asphalt driveway to your new residence by a contractor, or obtaining some fundamental knowledge is imperative to guarantee that the job is done. Know first that the lack of compaction and the insufficient thickness of the foundation are the two main causes of the deformation or ripping of a coating of asphalt. If it's a new driveway, then it has to initially be excavated to make room for a coating of crushed stone of sufficient thickness. A geotextile membrane will be placed under the granular backfill if the dirt proves to be very loamy (clayey). If you own a new house, it is best to wait 6 to 12 months prior to paving your drive, to enable the soil to settle . In the event of a repair of this entrance, an easy replacement of the asphalt layer can be considered if the contractor believes that the present base is sufficient. In both cases, base redone or foundation maintained, the whole period of its warranty has to be exactly the same.

Tar And Chip Paving Hartselle Alabama

The weather conditions in our lovely state can have a disastrous impact in an asphalt drive, thus the significance of adding a slope with a minimum slope of 2%. This will enable water to drain to the street and decrease the danger of heaving or cracking. This significant detail must be taken into consideration when excavating and maintained during backfilling.

In case you have a van or recreational vehicle, notify the contractor before the onset of the job: he will be able to provide materials accordingly. Some asphalt combinations produce an asphalt that is more resistant to heavy duty vehicles.

The asphalt layer should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 ) in order to accomplish a thickness of 5 cm (2 ) after being compacted. For optimal stability, the foundation should extend over the surface to be paved by about thirty centimeters (a couple inches) on each side. Also note that the setup of side supports around the foundation is a fantastic method to prevent possible cracks and that asphalting done in cold weather will be of poor quality. It's therefore better to wait for the sunny days to return before starting work.

To avoid unpleasant surprises, select your contractor and make sure the name and address of the company are composed on the contract. The beginning and end dates of this work, in addition to proof of this contractor's liability insurance and the technical specifics of this job to be completed, should also be included. No contractor should need a deposit before work starts. To avoid the inconvenience that could cause unforeseen costs, visit the Tar And Chip PavingHartselle site. You will thus have all the resources in hand to successfully finish your asphalt paving project.

Tar And Chip Paving Hartselle - Greatest Alabama at Alabama!

For quality asphalting perform , call on Tar And Chip Paving, Hartselle specialist team. Confirm our Business section to figure out the regions served.

Snow Removal Hartselle | Asphalt Hartselle
Home >> alabama/hartselle >> tar and chip paving
Share this...