Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt surface in Hoover, Alabama


Tar And Chip Paving installed on an unstable surface can quickly lead to difficulties. There are three Chief choices for the Simple setup:

  1. Paving Over Existing Driveway: If your current driveway is in good condition rather than revealing serious fractures or crumbling, hot asphalt mix can be placed directly within your driveway. 1 facet is height: make sure fences, garage flooring, and other structures are not jeopardized by the higher degree of this new surface.
  2. Remove old driveway, counter into the ground: The existing driveway is completely removed (or you may not have a driveway yet) and 4 to 6 inches of hot paving stone is placed right on the ground.
  3. Eliminate the old driveway and fasten it to a good surface. This is actually the preferred method. An aggregated stone floor partly replaces part of the hot asphalt mixture. Typically 6 to 8 inches of aggregate extends under 3 inches of asphalt.

The more asphalt you work, the more leeway you have. For example, in 40 F, the crews only have 16 minutes to work on 1 1/2 inch thick asphalt. In general, for lean asphalt programs (approximately 1.5 cm), you need to wait until temperatures are 21 ° C or even higher. Between 50 and 60 F, you ought to consult with your contractor. The hot mix remains practical during this period of time, but the time is constrained.

How much does an Tar And Chip Paving cost in Hoover?

Take into account the weather vagaries of our climate when deciding upon the standard of asphalt. The significant temperature variations that we experience cause considerable damage to asphalt work.

Furthermore, it'll be useful to tell the contractor if you own a recreational vehicle or a van. He might have to accommodate the asphalt mixture in order to be more immune to the weight of heavy vehicles.

The advantages of Tar And Chip Paving

A driveway paved with asphalt has several benefits:

It'll cost you between $ 3 and $11 per square foot; the price varies depending on the characteristic of the asphalt used along with the paving contractor.

For a sustainable Tar And Chip Paving

The life of an asphalt paver can be around 20 years, when the very best conditions are met. We are talking about a professional paving builder, a good grade of asphalt and also an optimal asphalt laying technique.


The longevity of residential asphalt paving chiefly is dependent upon the standard of the placing. Really, the major causes of deformation or tearing of an asphalt layer are the lack of compaction and a lean base. However, the maintenance of the asphalt pavement can be a deciding factor in its longevity. That's to say, you will have to seal your drive once in ten decades, at a minimum, in order to keep its good condition.


We suggest that you notify your asphalting builder if you choose to get your driveway asphalt in order to offer your property. It might not be essential to pay top dollar for laying asphalt , in such a case.

Tar And Chip Paving laying: cost and contract

The choice of the asphalt laying builder is essential. In order not to have unpleasant surprises, then you'll have to choose it carefully.

Make sure the paving contractor has liability insurance. A visit to the website of the Office for Consumer Protection (OPC) will allow you to verify whether an entrepreneur has been the subject of complaints.

The following details must be included in the contract:

- date of start and end of the job;

- proof of insurance;

- technical particulars;

- RBQ accreditation number.

You should be aware that a paving builder cannot require you to make a down payment before work has started. But you should agree on the payment terms and make sure it's about the contract.

A strong base for Tar And Chip Paving- Hoover

Before redoing the asphalt driveway to your new home by a contractor, or acquiring some basic knowledge is vital to guarantee that the job is well done. Know first that the lack of compaction and the insufficient depth of the base are the two main sources for the deformation or ripping of a coating of asphalt. When it is a new driveway, it must initially be excavated to make room for a layer of crushed stone of adequate thickness. A geotextile membrane will be set beneath the granular backfill if the dirt proves to be somewhat loamy (clayey). If you own a new house, it's ideal to wait 6 to 12 months prior to paving your driveway, to allow the dirt to settle . In the case of a fix of the entry, a simple replacement of the asphalt coating can be considered if the contractor believes that the present base is adequate. In both scenarios, base redone or foundation preserved, the duration of its guarantee must be the same.

Tar And Chip Paving Hoover Alabama

The weather conditions in our beautiful province can have a disastrous impact on an asphalt drive, thus the significance of including a slope with a minimum slope of 2%. This will allow water to drain into the street and decrease the risk of heaving or cracking. This important detail has to be taken into consideration when excavating and maintained during backfilling.

If you have a van or recreational vehicle, notify the builder before the start of the work: he will have the ability to supply materials accordingly. Some asphalt combinations produce an asphalt that is more resistant to heavy duty vehicles.

The asphalt layer should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 in) in order to reach a thickness of at least 5 cm (2 in) after being compacted. For optimal stability, the foundation should extend across the surface to be paved by roughly thirty centimeters (a dozen inches) on each side. Also mention that the installation of side supports around the foundation is a good way to avoid possible cracks and this asphalting done in chilly weather will be of inferior quality. It is therefore far better to await the bright days to return before beginning work.

To avoid unpleasant surprises, then select your contractor diligently and make certain the name and address of the company are written on the contract. The start and end dates of this job, as well as proof of this contractor's liability insurance and also the technical specifics of the project to be carried out, should also be included. No contractor should require a down payment before work starts. To avoid the inconvenience that might lead to unforeseen expenses, visit the Tar And Chip PavingHoover site. You will thus have the resources in hand to successfully complete your asphalt paving project.

Tar And Chip Paving Hoover - Best Alabama in Alabama!

For quality asphalting work , phone on Tar And Chip Paving, Hoover professional team. We've got more than twenty years of expertise in asphalt laying, resurfacing, maintenance and repair. Consult our Business section to find out the regions served.

Snow Removal Hoover | Asphalt Hoover
Home >> alabama/hoover >> tar and chip paving
Share this...