Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Options for the asphalt surface in Huntsville, Alabama


Tar And Chip Paving installed on an unstable surface could quickly lead to difficulties. There are three Chief options for the Simple setup:

  1. Paving Over Existing Driveway: If your current driveway is in good condition rather than revealing serious fractures or crumbling, hot asphalt mix can be laid directly over your driveway. One facet is elevation: make certain fences, garage flooring, and other structures aren't compromised by the higher level of this new surface.
  2. Eliminate old driveway, peg to the floor: The existing driveway is completely removed (or you may not have a driveway yet) and 4 to 6 inches of warm paving stone is placed right on the ground.
  3. Remove the old driveway and fasten it into a good surface. This is the preferred method. An aggregated stone flooring partially replaces part of this hot asphalt mixture.

Our Services:

The best time to install Tar And Chip Paving from Huntsville

The longer asphalt you operate, the more leeway you might have. For instance, at 40 F, the crews just have 16 minutes to work on 1 1/2 inch thick asphalt. As the asphalt thickness increases by 3 inches, the workability time also raises: 46 minutes. In general, for thin asphalt programs (about 1.5 cm), you need to wait until temperatures are 21 ° C or higher. Between 50 and 60 F, then you'll need to consult with your contractor. The hot mix remains practical in this period of time, but the time is limited.

How much does an Tar And Chip Paving price in Huntsville?

Take into account the weather vagaries of our climate when deciding upon the standard of asphalt. The significant temperature variations we experience cause appreciable damage to asphalt perform.

Furthermore, it'll be useful to tell the contractor should you have a recreational vehicle or a van. He might have to accommodate the asphalt mixture so as to be more resistant to the weight of heavy vehicles.

The Benefits of Tar And Chip Paving

A driveway paved with asphalt has several benefits:

It will cost you between $ 3 and $11 per square foot; the cost varies depending on the quality of the asphalt employed along with the paving contractor.

For a sustainable Tar And Chip Paving

The existence of an asphalt paver may be around 20 decades, when the best conditions are satisfied. We are referring to a professional paving builder, a good grade of asphalt and also an optimal asphalt laying technique.

Tar And Chip Paving in Huntsville: cost, quality of work and lifespan


The durability of residential asphalt paving largely depends upon the quality of the laying. Indeed, the major causes of deformation or tearing of an asphalt coating are the lack of compaction and a thin foundation. On the other hand, the upkeep of the asphalt pavement is also a deciding factor in its own longevity. That is to say, you will have to seal your drive once in 10 years, at a minimum, in order to keep its good condition.


We advise you to notify your asphalting contractor if you choose to have your driveway asphalt so as to sell your property. It may not be necessary to pay top dollar for placing asphalt , in such a case.

Tar And Chip Paving laying: price and contract

The option of the asphalt laying builder is indispensable. In order to not have unpleasant surprises, you will have to choose it carefully.

Make sure the paving contractor has liability insurance. A visit to the website of the Office for Consumer Protection (OPC) will make it possible for you to verify whether an entrepreneur has become the subject of complaints.

The following details should be included in the contract:

- date of start and end of the work;

- proof of insurance;

- technical details;

- RBQ certification number.

You should be aware that a paving builder can't demand that you make a deposit before work has started. However, you need to agree on the payment provisions and make sure it's on the contract.

Before redoing the asphalt drive to your new home by a contractor, or obtaining some fundamental knowledge is vital to guarantee that the job is well done. Know first that the lack of compaction and the insufficient depth of the base are the two chief causes of the deformation or ripping of a layer of asphalt. If it's a new driveway, it has to first be excavated to make room for a coating of crushed stone of sufficient thickness. A geotextile membrane is going to be placed beneath the granular backfill if the dirt turns out to be somewhat loamy (clayey). If you have a new house, it is best to wait for 6 to 12 months before paving your drive, to enable the soil to settle . In the event of a fix of the entry, an easy replacement of the asphalt coating can be considered in the event the contractor considers that the present base is sufficient. In both scenarios, base redone or base maintained, the duration of its warranty must be exactly the same.

Tar And Chip Paving Huntsville Alabama

The weather conditions in our lovely state may have a devastating effect on an asphalt drive, thus the importance of including a slope with a minimum slope of 2%. This will enable water to drain to the street and decrease the risk of heaving or cracking. This significant detail must be taken into account when excavating and maintained during backfilling.

In case you have a van or recreational vehicle, notify the contractor before the start of the work: he will have the ability to provide materials so. Some asphalt mixtures produce an asphalt that is more resistant to heavy-duty vehicles.

The asphalt layer should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 ) so as to accomplish a thickness of 5 cm (2 ) after being compacted. For optimal stability, the base should extend over the surface to be paved by about thirty centimeters (a couple inches) on each side. Also note that the installation of side supports around the foundation is a good way to prevent potential cracks and this asphalting done in cold weather will be of poor quality. It is therefore far better to await the bright days to go back before beginning work.

A definite contract with your builder in Huntsville

To avoid unpleasant surprises, select your contractor and be sure that the name and address of the business are written on the contract. The start and finish dates of the work, as well as proof of the builder's liability insurance and the technical specifics of the job to be completed, should also be included. No contractor should need a down payment before work starts. To avoid the inconvenience that might lead to unforeseen expenses, take a look at the Tar And Chip PavingHuntsville website. You may thus have all the tools in hand to successfully complete your asphalt paving project.

Tar And Chip Paving Huntsville - Best Alabama in Alabama!

For caliber asphalting work , phone on Tar And Chip Paving, Huntsville professional team. Confirm our Company section to figure out the regions served.

Snow Removal Huntsville | Asphalt Huntsville
Home >> alabama/huntsville >> tar and chip paving
Share this...