Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Asphalt- Options for the asphalt Coating in Irondale, Alabama


Asphalt installed in an unstable surface can quickly lead to difficulties. There are 3 main options for the basic setup:

  1. Paving Over Existing Driveway: If your existing driveway is in good condition rather than revealing severe cracks or crumbling, hot asphalt mixture can be placed directly within your driveway. 1 facet is height: make certain fences, garage flooring, and other structures are not compromised by the greater degree of the new surface.
  2. Eliminate old driveway, counter into the ground: The existing driveway is completely removed (or you might not have a driveway nonetheless ) and 4 to 6 inches of warm paving stone is put directly on the ground.
  3. Remove the old driveway and fasten it to a solid surface. This is the preferred method. An aggregated stone flooring partially replaces part of this hot asphalt mixture. Typically 6 to 8 inches of aggregate extends under 3 inches of asphalt.

Our Services:

The best time to install Asphalt in Irondale

The more asphalt you work, the more leeway you might have. For example, at 40 F, the crews just have 16 minutes to work on 1 1/2 inch thick asphalt. As the asphalt thickness increases by 3 inches, the workability time also increases: 46 minutes. In general, for thin asphalt applications (approximately 1.5 cm), you should wait until temperatures are 21 ° C or even higher. Between 50 and 60 F, you ought to consult with your contractor. The hot mix is ​​still practical in this period of time, but the time is constrained.

How much does an Asphalt cost in Irondale?

Consider the weather vagaries of the climate when choosing the quality of asphalt. The significant temperature variations that we experience cause appreciable damage to asphalt perform.

In addition, it'll be useful to distinguish the contractor if you have a recreational vehicle or a van. He will have to accommodate the asphalt mix in order to be more resistant to the burden of heavy vehicles.

The advantages of Asphalt

A driveway paved with asphalt has several advantages:

It will cost you between $ 3 and $11 per square foot; the price fluctuates based on the characteristic of the asphalt employed along with the paving contractor.

To get a sustainable Asphalt

The existence of an asphalt paver can be up to 20 decades, when the best states are met. We are referring to a professional paving contractor, a great quality of asphalt and also an optimal asphalt laying technique.


The durability of residential asphalt paving largely is dependent on the quality of the placing. Indeed, the major causes of deformation or ripping of an asphalt coating are the lack of compaction plus a lean base. On the other hand, the upkeep of the asphalt sidewalk is also a determining factor in its own longevity. That's to say, you'll need to seal your driveway once in 10 decades, at a minimum, in order to keep its good condition.


We suggest that you inform your asphalting builder if you choose to get your driveway asphalt so as to sell your property. It may not be necessary to pay top dollar for laying asphalt , in such a case.

Asphalt placing: price and contract

The option of the asphalt laying builder is indispensable. In order not to have unpleasant surprises, then you will need to choose it carefully.

Our ensures and Asphalt work

Make sure the paving contractor has liability insurance. A trip to the website of the Office for Consumer Protection (OPC) will make it possible for you to confirm whether an entrepreneur has become the subject of complaints.

These details must be included in the contract:

- date of beginning and end of the work;

- evidence of insurance;

- technical details;

- RBQ accreditation number.

You should be aware that a paving builder can't demand that you make a deposit before work has started. However, you need to agree to the payment provisions and make sure it is about the contract.

A solid base for Asphalt- Irondale

Before redoing the asphalt drive to your new residence by a contractor, or obtaining some fundamental knowledge is imperative to make sure the job is done. Know first that the lack of compaction and the insufficient depth of the foundation are the two chief causes of the deformation or ripping of a layer of asphalt. When it's a new driveway, then it must first be excavated to make room for a coating of crushed stone of sufficient thickness. A geotextile membrane will be placed beneath the granular backfill if the soil turns out to be somewhat loamy (clayey). If you own a new home, it's ideal to wait 6 to 12 months prior to paving your driveway, to allow the dirt to settle . In the event of a repair of this entrance, a simple replacement of the asphalt layer can be considered if the contractor considers that the existing base is adequate. In both cases, foundation redone or base preserved, the whole period of its warranty has to be the same.

Asphalt Irondale Alabama

The weather conditions in our lovely state may have a disastrous impact in an asphalt drive, thus the significance of including a slope with a minimum slope of 2%. This will enable water to drain into the street and minimize the danger of heaving or cracking. This important detail has to be taken into consideration when excavating and maintained during backfilling.

If you have a van or recreational vehicle, notify the contractor prior to the onset of the job: he is going to have the ability to provide materials accordingly. Some asphalt mixtures produce an asphalt that is more resistant to heavy duty vehicles.

The asphalt layer should have an initial thickness of 6.35 to 7.6 cm (2.5 to 3 ) in order to accomplish a thickness of 5 cm (2 in) after being compacted. For optimum stability, the foundation should extend across the surface to be paved by about thirty centimeters (a couple inches) on each side. Also mention that the installation of side supports around the base is a good way to avoid potential cracks and that asphalting done in cold weather will be of inferior quality. It's therefore better to wait for the sunny days to go back before starting work.

To avoid unpleasant surprises, select your contractor diligently and make sure that the name and address of his company are written on the contract. The beginning and finish dates of the work, in addition to proof of this builder's liability insurance and also the technical specifics of this job to be carried out, should also be included. No contractor should need a deposit before work starts. To prevent the inconvenience that might lead to unforeseen costs, visit the AsphaltIrondale website. You will thus have the tools in hand to successfully finish your asphalt paving project.

Asphalt Irondale - Greatest Alabama in Alabama!

For quality asphalting work , call on Asphalt, Irondale specialist team. Consult our Business section to figure out the regions served.

Tar And Chip Paving Irondale | Parking Lot Repair And Striping Irondale
Home >> alabama/irondale >> asphalt
Share this...