Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Options for the asphalt surface in Irondale, Alabama


Tar And Chip Paving installed in an unstable surface could quickly lead to problems. There are three Chief choices for the basic installation:

  1. Paving Over Existing Driveway: If your current driveway is in good condition rather than showing severe fractures or crumbling, hot asphalt mix can be laid directly over your driveway. One aspect is height: make sure fences, garage flooring, and other structures are not compromised by the higher level of the surface.
  2. Remove old driveway, counter into the ground: The existing driveway is totally eliminated (or you might not have a driveway nonetheless ) and 4 to 6 inches of warm paving stone is placed right on the ground.
  3. Eliminate the old driveway and fasten it to a good surface. This is actually the preferred method. An aggregated stone flooring partly replaces part of this hot asphalt mixture. Generally 6 to 8 inches of limestone extends under 3 inches of asphalt.

Our Services:

The best time to install Tar And Chip Paving from Irondale

The more asphalt you work, the more leeway you have. For example, at 40 F, the crews just have 16 minutes to work on 1 1/2 inch thick asphalt. Generally, for lean asphalt applications (about 1.5 cm), you need to wait until temperatures are 21 ° C or even higher. Between 50 and 60 F, then you'll need to speak to your contractor. The hot mix is ​​still practical during this period, but the time is limited.

How much does an Tar And Chip Paving price in Irondale?

Take into account the weather vagaries of the climate when choosing the quality of asphalt. The substantial temperature variations we experience cause considerable damage to asphalt work.

Furthermore, it will be good to distinguish the contractor should you own a recreational vehicle or a van. He will have to adapt the asphalt mix in order to be more immune to the weight of heavy vehicles.

The advantages of Tar And Chip Paving

A driveway paved with asphalt has several benefits:

It will cost you between $ 3 and $11 per square foot; the price fluctuates based on the characteristic of the asphalt used along with the paving contractor.

For a sustainable Tar And Chip Paving

The existence of an asphalt paver can be up to 20 years, when the very best states are met. We're talking about a professional paving contractor, a good quality of asphalt and also an optimal asphalt laying technique.

Tar And Chip Paving in Irondale: cost, quality of work and lifespan


The longevity of residential asphalt paving chiefly is dependent upon the standard of the placing. Really, the significant causes of deformation or tearing of an asphalt coating are the lack of compaction plus a lean base. On the other hand, the upkeep of the asphalt pavement can be a determining factor in its longevity. That's to say, you'll have to seal your drive once in ten decades, at a minimum, so as to keep its great condition.


We suggest that you inform your asphalting contractor if you decide to get your driveway asphalt so as to offer your property. It might not be essential to pay top dollar for laying asphalt , in this case.

Tar And Chip Paving laying: price and contract

The choice of the asphalt laying contractor is essential. In order not to have unpleasant surprises, you will need to choose it carefully.

Our ensures and Tar And Chip Paving work

Guarantee that the paving contractor has liability insurance. A trip to the web site of the Office for Consumer Protection (OPC) will allow you to verify whether an entrepreneur has been the subject of complaints.

These details must be included in the arrangement:

- date of beginning and end of the job;

- evidence of insurance;

- technical particulars;

- RBQ accreditation number.

You ought to know that a paving contractor cannot demand you to make a deposit before work has begun. But you should agree on the payment provisions and make sure it's about the contract.

Before redoing the asphalt driveway to your new home by a builder, or acquiring some fundamental knowledge is imperative to guarantee that the job is done. Know first that the lack of compaction and the inadequate depth of the base are the two chief sources for the deformation or tearing of a layer of asphalt. If it is a new driveway, then it must first be excavated to make room for a coating of crushed stone of adequate depth. A geotextile membrane will be set beneath the granular backfill if the dirt turns out to be very loamy (clayey). If you have a new house, it is best to wait 6 to 12 months prior to paving your drive, to enable the dirt to settle . In the case of a repair of the entrance, a simple replacement of the asphalt layer can be considered if the contractor believes that the existing foundation is adequate. In both scenarios, base redone or base preserved, the whole period of its warranty has to be the same.

Tar And Chip Paving Irondale Alabama

The weather conditions in our lovely state can have a devastating effect on an asphalt drive, hence the significance of including a slope with a minimum slope of 2%. This will enable water to drain to the street and decrease the risk of heaving or cracking. This significant detail must be taken into account when excavating and maintained during backfilling.

In case you have a van or recreational vehicle, notify the builder prior to the start of the work: he is going to be able to provide materials accordingly. Some asphalt mixtures produce an asphalt that is more immune to heavy-duty vehicles.

The asphalt layer should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 ) so as to accomplish a thickness of at least 5 cm (2 in) after being compacted. For optimal stability, the base should extend over the surface to be paved by about thirty centimeters (a couple inches) on each side. Also note that the installation of side supports around the base is a fantastic method to avoid potential cracks and that asphalting done in chilly weather is going to be of poor quality. It's therefore far better to await the bright days to return before beginning work.

A definite contract with your builder in Irondale

To avoid unpleasant surprises, select your contractor diligently and make sure that the title and address of his company are composed on the contract. The start and end dates of this job, as well as proof of this builder's liability insurance and the technical specifics of this job to be completed, should also be included. No contractor should need a down payment before work starts. To prevent the inconvenience that might cause unforeseen expenses, visit the Tar And Chip PavingIrondale site. You may thus have the tools in hand to successfully complete your asphalt paving project.

Tar And Chip Paving Irondale - Greatest Alabama at Alabama!

For quality asphalting perform , call on Tar And Chip Paving, Irondale professional team. We have over twenty years of expertise in asphalt laying, resurfacing, maintenance and repair. Confirm our Company department to figure out the regions served.

Snow Removal Irondale | Asphalt Irondale
Home >> alabama/irondale >> tar and chip paving
Share this...