Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Options for the asphalt Coating in Jasper, Alabama


Tar And Chip Paving installed in an unstable surface could quickly lead to difficulties. There are 3 Chief choices for the Simple installation:

  1. Paving Over Existing Driveway: If your current driveway is in good condition rather than revealing serious fractures or crumbling, hot asphalt mix can be laid directly over your driveway. One aspect is height: make certain fences, garage floors, and other structures aren't jeopardized by the greater degree of the surface.
  2. Eliminate old driveway, peg to the floor: The present driveway is completely eliminated (or you might not have a driveway yet) and 4 to 6 inches of warm paving stone is placed directly on the ground.
  3. Eliminate the old driveway and secure it to a good surface. This is actually the preferred method. An aggregated stone flooring partially replaces part of the hot asphalt mix.

The longer asphalt you work, the more leeway you have. For instance, at 40 F, the crews only have 16 minutes to work on 1 1/2 inch thick asphalt. As the asphalt depth increases by 3 inches, the workability time also increases: 46 minutes. Generally, for thin asphalt applications (approximately 1.5 cm), you need to wait until temperatures are 21 ° C or even higher. Between 50 and 60 F, you'll need to consult with your contractor. The hot mix is ​​still functional during this period of time, however, the time is constrained.

How much can an Tar And Chip Paving cost in Jasper?

Take into account the weather vagaries of the climate when choosing the standard of asphalt. The significant temperature variations that we experience cause considerable damage to asphalt work.

In addition, it will be good to distinguish the contractor if you own a recreational vehicle or a van. He will have to adapt the asphalt mix so as to be more immune to the weight of heavy vehicles.

The Benefits of Tar And Chip Paving

A driveway paved with asphalt has several advantages:

It'll cost you between $ 3 and $11 per square foot; the cost fluctuates based on the characteristic of the asphalt employed and the paving contractor.

For a sustainable Tar And Chip Paving

The existence of an asphalt paver may be around 20 years, when the best conditions are satisfied. We're referring to a professional paving builder, a good quality of asphalt and an optimal asphalt laying technique.


The longevity of residential asphalt paving chiefly depends on the quality of the placing. Indeed, the major causes of deformation or tearing of an asphalt layer are the lack of compaction and a lean base. However, the upkeep of the asphalt pavement is also a determining factor in its own longevity. That's to say, you'll have to seal your driveway once in ten decades, at a minimum, so as to keep its good state.


We suggest that you notify your asphalting contractor if you choose to get your driveway asphalt in order to sell your property. It might not be necessary to pay top dollar for laying asphalt , in such a circumstance.

Tar And Chip Paving placing: cost and contract

The choice of the asphalt laying builder is essential. In order not to have unpleasant surprises, you will need to select it carefully.

Our guarantees and Tar And Chip Paving work

Make sure the paving contractor has liability insurance coverage. A trip to the web site of the Office for Consumer Protection (OPC) will allow you to verify whether an entrepreneur has been the subject of complaints.

The following details must be included in the contract:

- date of start and finish of the work;

- evidence of insurance;

- technical details;

- RBQ accreditation number.

You should know that a paving contractor cannot demand you to make a down payment before work has started. However, you should agree to the payment provisions and be sure it is about the contract.

A solid foundation for Tar And Chip Paving- Jasper

Before redoing the asphalt driveway to your new home by a builder, or acquiring some basic knowledge is imperative to make sure the job is well done. Know first that the lack of compaction and the inadequate thickness of the base are the two main sources for the deformation or tearing of a layer of asphalt. When it's a new driveway, it must first be excavated to make room for a coating of crushed stone of sufficient depth. A geotextile membrane is going to be set under the granular backfill if the dirt turns out to be somewhat loamy (clayey). If you have a new home, it's ideal to wait for 6 to 12 months prior to paving your driveway, to enable the soil to settle naturally. In the event of a repair of this entry, an easy replacement of the asphalt layer can be considered in the event the contractor believes that the present foundation is adequate. In both cases, base redone or foundation preserved, the duration of its warranty has to be exactly the same.

Tar And Chip Paving Jasper Alabama

The weather conditions in our beautiful province may have a disastrous impact on an asphalt driveway, hence the importance of including a slope having a minimum slope of 2%. This will enable water to drain into the street and decrease the risk of heaving or cracking. This significant detail must be taken into account when excavating and preserved during backfilling.

If you have a van or recreational vehicle, notify the builder before the onset of the job: he will have the ability to supply materials so. Some asphalt combinations produce an asphalt that is more immune to heavy duty vehicles.

The asphalt layer should have an initial thickness of 6.35 to 7.6 cm (2.5 to 3 in) so as to accomplish a thickness of 5 cm (2 in) after being compacted. For optimum stability, the foundation should extend across the surface to be paved by roughly thirty centimeters (a couple inches) on each side. Also note that the installation of unwanted supports around the foundation is a fantastic method to prevent potential cracks and this asphalting done in chilly weather will be of inferior quality. It's therefore far better to await the bright days to return before starting work.

A Tar And Chip Paving contract with your contractor in Jasper

To avoid unpleasant surprises, then choose your contractor diligently and be sure the name and address of the business are composed on the contract. The beginning and end dates of the work, in addition to evidence of the builder's liability insurance and also the technical specifics of the job to be carried out, should also be included. No contractor should require a down payment before work starts. To avoid the inconvenience that could cause unforeseen expenses, visit the Tar And Chip PavingJasper website. You may thus have all the resources in hand to successfully finish your asphalt paving project.

Tar And Chip Paving Jasper - Best Alabama in Alabama!

For quality asphalting work , phone on Tar And Chip Paving, Jasper specialist team. We've got more than 20 decades of expertise in asphalt laying, resurfacing, maintenance and repair. Consult our Business section to figure out the regions served.

Snow Removal Jasper | Asphalt Jasper
Home >> alabama/jasper >> tar and chip paving
Share this...