Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt surface in Madison, Alabama


Tar And Chip Paving installed in an unstable surface can quickly lead to difficulties. There are three Chief options for the Simple setup:

  1. Paving Over Existing Driveway: If your current driveway is in good condition and not showing severe fractures or crumbling, hot asphalt mixture can be laid directly over your driveway. 1 facet is height: make sure fences, garage floors, and other structures aren't compromised by the higher degree of this surface.
  2. Remove old driveway, peg to the floor: The existing driveway is totally removed (or you might not have a driveway nonetheless ) and 4 to 6 inches of hot paving stone is put directly on the ground.
  3. Eliminate the old driveway and secure it into a good surface. This is the preferred method. An aggregated stone floor partially replaces part of this hot asphalt mix. Generally 6 to 8 inches of limestone extends under 3 inches of asphalt.

Our Services:

The best time to install Tar And Chip Paving from Madison

The more asphalt you operate, the more leeway you might have. By way of instance, at 40 F, the crews only have 16 minutes to work on 1 1/2 inch thick asphalt. In general, for lean asphalt programs (approximately 1.5 cm), you should wait until temperatures are 21 ° C or even higher. Between 50 and 60 F, you ought to speak to your contractor. The hot mix remains functional in this period, however, the time is constrained.

How much does an Tar And Chip Paving cost in Madison?

Consider the weather vagaries of our climate when choosing the quality of asphalt. The substantial temperature variations we experience cause considerable damage to asphalt perform.

Furthermore, it will be useful to tell the contractor if you own a recreational vehicle or even a van. He will have to adapt the asphalt mixture so as to be more resistant to the weight of heavy vehicles.

The Benefits of Tar And Chip Paving

  • Smooth finish;
  • non-slip
  • Simple to Keep
  • watertightness ensured
  • withstands the rigors of this Quebec climate quite well (provided it's been installed optimally);
  • prevents the growth of moss;

It'll cost you between $ 3 and $11 per square foot; the cost varies depending on the characteristic of the asphalt employed and the paving contractor.

To get a sustainable Tar And Chip Paving

The existence of an asphalt paver can be up to 20 years, when the very best conditions are met. We're referring to a professional paving builder, a great grade of asphalt as well as an optimal asphalt laying technique.

Tar And Chip Paving in Madison: cost, quality of work and lifespan


The longevity of residential asphalt paving largely is dependent on the standard of the placing. Really, the significant causes of deformation or tearing of an asphalt coating are the absence of compaction plus a lean base. However, the upkeep of the asphalt sidewalk can be a deciding factor in its longevity. That is to say, you'll have to seal your drive once in ten years, at a minimum, in order to maintain its great condition.


We advise you to notify your asphalting builder in case you choose to get your driveway asphalt so as to sell your property. It might not be essential to pay top dollar for laying asphalt , in such a case.

Tar And Chip Paving placing: price and contract

The option of the asphalt laying contractor is essential. In order not to have unpleasant surprises, then you'll need to choose it carefully.

Make sure the paving contractor has liability insurance. A trip to the web site of the Office for Consumer Protection (OPC) will make it possible for you to confirm whether an entrepreneur has become the subject of complaints.

These details must be included in the arrangement:

- date of start and end of the work;

- proof of insurance;

- technical particulars;

- RBQ accreditation number.

You should be aware that a paving contractor can't require you to make a down payment before work has begun. But you need to agree on the payment provisions and be sure it's about the contract.

Before redoing the asphalt drive to your new home by a contractor, or obtaining some fundamental knowledge is vital to make sure the job is well done. Know first that the absence of compaction and the insufficient thickness of the base are the two main causes of the deformation or ripping of a layer of asphalt. If it's a new driveway, then it must first be excavated to make room for a coating of crushed stone of sufficient thickness. A geotextile membrane will be set beneath the granular backfill if the soil proves to be very loamy (clayey). If you have a new house, it is best to wait for 6 to 12 months prior to paving your driveway, to enable the soil to settle naturally. In the event of a fix of this entry, a simple replacement of the asphalt coating can be considered in the event the contractor believes that the present foundation is adequate. In both scenarios, base redone or base preserved, the whole period of its guarantee has to be exactly the same.

Tar And Chip Paving Madison Alabama

The weather conditions in our beautiful province may have a devastating effect in an asphalt drive, thus the importance of adding a slope with a minimum slope of 2%. This will allow water to drain into the street and decrease the danger of heaving or cracking. This significant detail must be taken into consideration when excavating and maintained during backfilling.

In case you've got a van or recreational vehicle, notify the contractor prior to the onset of the work: he will have the ability to supply materials accordingly. Some asphalt mixtures produce an asphalt that is more immune to heavy duty vehicles.

The asphalt coating should have an initial thickness of 6.35 to 7.6 cm (2.5 to 3 ) in order to accomplish a thickness of 5 cm (2 ) after being compacted. For optimal stability, the base should extend across the surface to be paved by roughly thirty centimeters (a couple inches) on each side. Also note that the installation of unwanted supports around the foundation is a good method to prevent possible cracks and that asphalting done in cold weather will be of poor quality. It's therefore far better to wait for the sunny days to return before starting work.

A definite contract with your contractor in Madison

To avoid unpleasant surprises, choose your contractor and be certain that the name and address of the company are written on the contract. The beginning and end dates of this job, as well as proof of this builder's liability insurance and the technical details of the job to be carried out, should also be included. No contractor should need a down payment before work begins. To avoid the inconvenience that might cause unforeseen expenses, take a look at the Tar And Chip PavingMadison website. You may thus have all the tools in hand to successfully complete your asphalt paving project.

Tar And Chip Paving Madison - Best Alabama in Alabama!

For caliber asphalting work , call on Tar And Chip Paving, Madison professional team. We've got over twenty decades of expertise in asphalt laying, resurfacing, maintenance and repair. Consult our Business department to find out the regions served.

Snow Removal Madison | Asphalt Madison
Home >> alabama/madison >> tar and chip paving
Share this...