Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Options for the asphalt Coating in Millbrook, Alabama


Tar And Chip Paving installed on an unstable surface can quickly lead to problems. There are 3 main choices for the Simple setup:

  1. Paving Over Existing Driveway: If your current driveway is in good shape rather than showing severe cracks or crumbling, hot asphalt mixture can be laid directly over your driveway. One aspect is height: make certain fences, garage flooring, and other structures are not jeopardized by the greater degree of the surface.
  2. Eliminate old driveway, counter into the ground: The existing driveway is completely removed (or you may not have a driveway yet) and 4 to 6 inches of hot paving stone is put directly on the ground.
  3. Eliminate the old driveway and fasten it to a solid surface. This is actually the preferred method. An aggregated stone flooring partly replaces part of the hot asphalt mixture.

Our Services:

The best time to install Tar And Chip Paving in Millbrook

The more asphalt you work, the more leeway you might have. For instance, at 40 F, the crews just have 16 minutes to operate on 1 1/2 inch thick asphalt. As the asphalt depth increases by 3 inches, the workability time also raises: 46 minutes. In general, for thin asphalt programs (approximately 1.5 cm), you should wait until temperatures are 21 ° C or even higher. Between 50 and 60 F, you ought to speak to your contractor. The hot mix remains practical in this period of time, however, the time is constrained.

How much does an Tar And Chip Paving cost in Millbrook?

Take into account the weather vagaries of our climate when deciding upon the quality of asphalt. The significant temperature variations that we experience cause appreciable damage to asphalt perform.

Furthermore, it'll be useful to distinguish the contractor if you have a recreational vehicle or a van. He will have to accommodate the asphalt mix in order to be more resistant to the weight of heavy vehicles.

The Benefits of Tar And Chip Paving

  • Smooth end;
  • non invasive
  • Simple to Keep
  • watertightness guaranteed
  • withstands the rigors of this Quebec climate very well (provided it has been installed );
  • prevents the growth of moss;

It will cost you between $ 3 and $11 per square foot; the cost fluctuates based on the quality of the asphalt used and the paving contractor.

For a sustainable Tar And Chip Paving

The existence of an asphalt paver may be around 20 decades, when the very best states are met. We're talking about a professional paving builder, a great grade of asphalt as well as an optimal asphalt laying technique.

Tar And Chip Paving in Millbrook: price, quality of work and lifespan


The longevity of residential asphalt paving chiefly depends upon the standard of the placing. Indeed, the significant causes of deformation or tearing of an asphalt layer are the lack of compaction and a thin foundation. On the other hand, the upkeep of the asphalt sidewalk is also a deciding factor in its longevity. That's to say, you will have to seal your drive once in 10 years, at a minimum, in order to keep its good condition.


We advise you to inform your asphalting contractor if you choose to get your driveway asphalt in order to offer your property. It may not be essential to pay top dollar for placing asphalt , in such a case.

Tar And Chip Paving laying: cost and contract

The choice of the asphalt laying builder is essential. In order not to have unpleasant surprises, then you will need to select it carefully.

Our guarantees and Tar And Chip Paving work

Guarantee that the paving contractor has liability insurance. A visit to the web site of the Office for Consumer Protection (OPC) will make it possible for you to confirm whether an entrepreneur has ever become the subject of complaints.

These details should be included in the arrangement:

- date of beginning and finish of the work;

- evidence of insurance;

- technical particulars;

- RBQ accreditation number.

You ought to be aware that a paving builder cannot require you to make a deposit before work has begun. However, you should agree on the payment provisions and be sure it is on the contract.

A solid base for Tar And Chip Paving- Millbrook

Before redoing the asphalt drive to your new residence by a builder, or obtaining some basic knowledge is imperative to guarantee that the job is done. Know first that the lack of compaction and the insufficient depth of the foundation are the two chief causes of the deformation or tearing of a coating of asphalt. If it's a new driveway, it has to first be excavated to make room for a layer of crushed stone of sufficient depth. A geotextile membrane is going to be placed beneath the granular backfill if the dirt turns out to be very loamy (clayey). If you have a new home, it's ideal to wait 6 to 12 months prior to paving your driveway, to enable the dirt to settle . In the case of a fix of the entrance, a simple replacement of the asphalt coating can be considered if the contractor considers that the existing foundation is sufficient. In both cases, foundation redone or foundation maintained, the whole period of its warranty must be exactly the same.

Tar And Chip Paving Millbrook Alabama

The weather conditions in our lovely state can have a devastating effect on an asphalt driveway, hence the importance of including a slope with a minimum slope of 2%. This will allow water to drain into the road and decrease the danger of heaving or cracking. This significant detail must be taken into account when excavating and maintained during backfilling.

If you have a van or recreational vehicle, notify the builder prior to the onset of the job: he is going to be able to supply materials so. Some asphalt combinations produce an asphalt which is more immune to heavy duty vehicles.

The asphalt coating should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 in) so as to reach a thickness of at least 5 cm (2 ) after being compacted. For optimal stability, the base should extend over the surface to be paved by about thirty centimeters (a couple inches) on each side. Also mention that the installation of side supports around the foundation is a good way to avoid possible cracks and this asphalting done in chilly weather will be of poor quality. It's therefore better to await the bright days to go back before starting work.

A Tar And Chip Paving contract with your contractor in Millbrook

To avoid unpleasant surprises, choose your contractor diligently and make sure that the name and address of his company are written about the contract. The beginning and finish dates of the job, as well as proof of this contractor's liability insurance and the technical specifics of the project to be completed, should also be included. No contractor should need a down payment before work begins. To prevent the inconvenience that could cause unforeseen costs, take a look at the Tar And Chip PavingMillbrook website. You will thus have all the tools in hand to successfully complete your asphalt paving project.

Tar And Chip Paving Millbrook - Greatest Alabama at Alabama!

For quality asphalting perform , call on Tar And Chip Paving, Millbrook specialist team. Confirm our Company section to find out the regions served.

Snow Removal Millbrook | Asphalt Millbrook
Home >> alabama/millbrook >> tar and chip paving
Share this...