Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Options for the asphalt surface in Mountain Brook, Alabama


Tar And Chip Paving installed on an unstable surface could quickly lead to difficulties. There are 3 Chief choices for the Simple setup:

  1. Paving Over Existing Driveway: If your existing driveway is in good condition and not revealing severe cracks or crumbling, hot asphalt mix can be placed directly within your driveway. One aspect is elevation: make certain fences, garage flooring, and other structures are not jeopardized by the higher level of the surface.
  2. Remove old driveway, peg to the floor: The existing driveway is completely removed (or you may not have a driveway yet) and 4 to 6 inches of warm paving stone is placed directly on the ground.
  3. Eliminate the old driveway and fasten it into a solid surface. This is actually the preferred method. An aggregated stone flooring partly replaces part of this hot asphalt mix. Generally 6 to 8 inches of limestone extends under 3 inches of asphalt.

Our Services:

The best time to install Tar And Chip Paving in Mountain Brook

The more asphalt you operate, the more leeway you might have. For example, at 40 F, the crews just have 16 minutes to operate on 1 1/2 inch thick asphalt. Generally, for thin asphalt applications (about 1.5 cm), you should wait until temperatures are 21 ° C or higher. Between 50 and 60 F, then you ought to speak to your contractor. The hot mix remains practical in this period of time, however, the time is constrained.

How much does an Tar And Chip Paving price in Mountain Brook?

Consider the weather vagaries of our climate when choosing the quality of asphalt. The substantial temperature variations we experience cause appreciable damage to asphalt perform.

In addition, it will be useful to distinguish the contractor should you own a recreational vehicle or even a van. He might need to accommodate the asphalt mixture so as to be more resistant to the weight of heavy vehicles.

The Benefits of Tar And Chip Paving

A driveway paved with asphalt has several advantages:

It will cost you between $ 3 and $11 per square foot; the cost varies depending on the characteristic of the asphalt used along with the paving contractor.

To get a sustainable Tar And Chip Paving

The existence of an asphalt paver can be around 20 years, when the very best states are met. We are talking about a professional paving contractor, a great quality of asphalt and also an optimal asphalt laying technique.

Tar And Chip Paving in Mountain Brook: price, quality of work and lifespan


The longevity of residential asphalt paving largely is dependent upon the quality of the placing. Really, the significant causes of deformation or tearing of an asphalt layer are the lack of compaction and a thin foundation. On the other hand, the upkeep of the asphalt sidewalk can be a deciding factor in its own longevity. That's to say, you'll have to seal your drive once in 10 years, at a minimum, in order to maintain its good state.


We advise you to notify your asphalting contractor if you choose to have your driveway asphalt in order to offer your property. It may not be necessary to pay top dollar for laying asphalt , in this case.

Tar And Chip Paving placing: price and contract

The option of the asphalt laying builder is essential. In order to not have unpleasant surprises, you'll need to select it carefully.

Our guarantees and Tar And Chip Paving work

Make sure the paving contractor has liability insurance coverage. A visit to the website of the Office for Consumer Protection (OPC) will allow you to verify whether an entrepreneur has ever been the subject of complaints.

These details should be included in the contract:

- date of start and finish of the work;

- evidence of insurance;

- technical details;

- RBQ accreditation number.

You ought to know that a paving builder cannot demand you to make a down payment before work has started. However, you need to agree on the payment terms and make sure it is on the contract.

Prior to estimating the asphalt driveway to your new home by a contractor, or obtaining some fundamental knowledge is vital to make sure the job is done. Know first that the lack of compaction and the inadequate depth of the base are the two main sources for the deformation or tearing of a layer of asphalt. When it's a new driveway, then it must first be excavated to make room for a layer of crushed stone of adequate depth. A geotextile membrane is going to be set under the granular backfill if the dirt proves to be very loamy (clayey). If you own a new house, it is best to wait for 6 to 12 months before paving your drive, to enable the soil to settle . In the event of a repair of this entry, a simple replacement of the asphalt coating can be considered in the event the contractor believes that the existing foundation is adequate. In both cases, foundation redone or foundation preserved, the whole period of its warranty must be the same.

Tar And Chip Paving Mountain Brook Alabama

The weather conditions in our lovely state can have a disastrous impact on an asphalt drive, thus the significance of including a slope with a minimum slope of 2%. This will allow water to drain to the road and decrease the risk of heaving or cracking. This important detail has to be taken into account when excavating and maintained during backfilling.

If you have a van or recreational vehicle, notify the contractor prior to the start of the work: he is going to have the ability to supply materials so. Some asphalt mixtures produce an asphalt which is more immune to heavy duty vehicles.

The asphalt layer should have an initial thickness of 6.35 to 7.6 cm (2.5 to 3 in) in order to accomplish a thickness of 5 cm (2 ) after being compacted. For optimal stability, the base should extend across the surface to be paved by roughly thirty centimeters (a dozen inches) on each side. Also mention that the installation of side supports around the base is a good method to avoid potential cracks and that asphalting done in cold weather is going to be of poor quality. It is therefore better to wait for the sunny days to return before starting work.

A Tar And Chip Paving contract with your builder in Mountain Brook

To avoid unpleasant surprises, then choose your contractor diligently and make certain the title and address of his business are written on the contract. The beginning and finish dates of this work, in addition to proof of the builder's liability insurance and the technical details of this job to be completed, should also be included. No contractor should require a deposit before work starts. To avoid the inconvenience that might lead to unforeseen expenses, take a look at the Tar And Chip PavingMountain Brook website. You may thus have all the resources in hand to successfully complete your asphalt paving project.

Tar And Chip Paving Mountain Brook - Best Alabama at Alabama!

For quality asphalting work , phone on Tar And Chip Paving, Mountain Brook professional team. Consult our Business section to find out the regions served.

Snow Removal Mountain Brook | Asphalt Mountain Brook
Home >> alabama/mountain brook >> tar and chip paving
Share this...