Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Options for the asphalt surface in Northport, Alabama


Tar And Chip Paving installed on an unstable surface can quickly lead to difficulties. There are three Chief options for the basic setup:

  1. Paving Over Existing Driveway: If your existing driveway is in good shape and not showing serious cracks or crumbling, hot asphalt mix can be placed directly within your driveway. One facet is height: make certain fences, garage floors, and other structures aren't compromised by the greater level of the surface.
  2. Eliminate old driveway, counter into the ground: The existing driveway is totally removed (or you might not have a driveway yet) and 4 to 6 inches of hot paving stone is put directly on the ground.
  3. Remove the old driveway and fasten it into a good surface. This is the preferred method. An aggregated stone floor partly replaces part of the hot asphalt mix. Typically 6 to 8 inches of aggregate goes under 3 inches of asphalt.

The longer asphalt you operate, the more leeway you have. By way of example, at 40 F, the crews only have 16 minutes to work on 1 1/2 inch thick asphalt. As the asphalt depth increases by 3 inches, the workability time also raises: 46 minutes. In general, for lean asphalt applications (approximately 1.5 cm), you should wait until temperatures are 21 ° C or even higher. Between 50 and 60 F, you ought to speak to your contractor. The hot mix is ​​still practical during this period, however, the time is constrained.

How much does an Tar And Chip Paving cost in Northport?

Consider the weather vagaries of the climate when deciding upon the standard of asphalt. The significant temperature variations we experience cause appreciable damage to asphalt perform.

Furthermore, it will be useful to tell the contractor should you have a recreational vehicle or a van. He will have to adapt the asphalt mix so as to be more resistant to the burden of heavy vehicles.

The advantages of Tar And Chip Paving

  • Smooth end;
  • non invasive
  • easy to Keep
  • watertightness ensured
  • withstands the rigors of this Quebec climate very well (provided it's been installed );
  • prevents the growth of moss;

It will cost you between $ 3 and $11 per square foot; the price varies depending on the characteristic of the asphalt employed and the paving contractor.

To get a sustainable Tar And Chip Paving

The life of an asphalt paver may be up to 20 years, when the best states are satisfied. We're referring to a professional paving contractor, a great quality of asphalt as well as also an optimal asphalt laying technique.


The durability of residential asphalt paving largely depends on the quality of the placing. Indeed, the significant causes of deformation or tearing of an asphalt layer are the lack of compaction and a thin foundation. On the other hand, the maintenance of the asphalt sidewalk is also a determining factor in its own longevity. That's to say, you will need to seal your drive once in 10 decades, at a minimum, in order to keep its great condition.


We advise you to notify your asphalting contractor in case you decide to have your driveway asphalt in order to offer your property. It may not be essential to pay top dollar for placing asphalt , in this circumstance.

Tar And Chip Paving placing: cost and contract

The option of the asphalt laying contractor is indispensable. In order not to have unpleasant surprises, then you will have to select it carefully.

Our ensures and Tar And Chip Paving work

Guarantee that the paving contractor has liability insurance. A visit to the website of the Office for Consumer Protection (OPC) will make it possible for you to verify whether an entrepreneur has ever been the subject of complaints.

These details must be included in the arrangement:

- date of start and finish of the job;

- evidence of insurance;

- technical particulars;

- RBQ accreditation number.

You should know that a paving builder can't demand you to make a deposit before work has begun. However, you need to agree to the payment provisions and make sure it's on the contract.

Before redoing the asphalt drive to your new residence by a contractor, or obtaining some basic knowledge is vital to make sure the job is done. Know first that the lack of compaction and the insufficient depth of the base are the two chief sources for the deformation or tearing of a layer of asphalt. If it is a new driveway, it has to initially be excavated to make room for a layer of crushed stone of sufficient depth. A geotextile membrane is going to be placed under the granular backfill if the dirt proves to be somewhat loamy (clayey). If you own a new home, it is best to wait 6 to 12 months before paving your driveway, to enable the soil to settle . In the event of a fix of this entry, a simple replacement of the asphalt layer can be considered if the contractor considers that the present base is sufficient. In both scenarios, base redone or base preserved, the whole period of its warranty must be exactly the same.

Tar And Chip Paving Northport Alabama

The weather conditions in our lovely state may have a devastating effect in an asphalt driveway, hence the importance of adding a slope with a minimum slope of 2%. This will enable water to drain to the road and decrease the danger of heaving or cracking. This significant detail has to be taken into consideration when excavating and maintained during backfilling.

In case you have a van or recreational vehicle, notify the builder prior to the start of the job: he is going to be able to provide materials so. Some asphalt mixtures produce an asphalt which is more immune to heavy-duty vehicles.

The asphalt layer should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 in) in order to accomplish a thickness of 5 cm (2 ) after being compacted. For optimum stability, the foundation should extend over the surface to be paved by about thirty centimeters (a dozen inches) on each side. Also note that the installation of side supports around the foundation is a fantastic way to avoid possible cracks and this asphalting done in chilly weather is going to be of poor quality. It's therefore better to await the bright days to return before starting work.

To avoid unpleasant surprises, then choose your contractor diligently and be sure that the title and address of the company are composed on the contract. The beginning and end dates of this work, in addition to proof of this contractor's liability insurance and also the technical specifics of the job to be completed, should also be included. No contractor should need a down payment before work starts. To avoid the inconvenience that might lead to unforeseen expenses, take a look at the Tar And Chip PavingNorthport website. You will thus have all the resources in hand to successfully finish your asphalt paving project.

Tar And Chip Paving Northport - Greatest Alabama at Alabama!

For caliber asphalting perform , phone on Tar And Chip Paving, Northport professional team. We've got over twenty decades of experience in asphalt laying, resurfacing, maintenance and repair. Confirm our Business section to figure out the regions served.

Snow Removal Northport | Asphalt Northport
Home >> alabama/northport >> tar and chip paving
Share this...