Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt Coating in Ozark, Alabama


Tar And Chip Paving installed in an unstable surface could quickly lead to difficulties. There are 3 main choices for the basic setup:

  1. Paving Over Existing Driveway: If your existing driveway is in good shape and not revealing severe fractures or crumbling, hot asphalt mix can be laid directly over your driveway. 1 facet is height: make certain fences, garage floors, and other structures are not jeopardized by the greater degree of this new surface.
  2. Eliminate old driveway, counter into the ground: The present driveway is completely eliminated (or you might not have a driveway yet) and 4 to 6 inches of hot paving stone is placed right on the ground.
  3. Remove the old driveway and secure it into a good surface. This is the preferred method. An aggregated stone floor partly replaces part of the hot asphalt mixture. Typically 6 to 8 inches of aggregate extends under 3 inches of asphalt.

Our Services:

The best time to install Tar And Chip Paving from Ozark

The more asphalt you operate, the more leeway you might have. By way of example, in 40 F, the crews only have 16 minutes to operate on 1 1/2 inch thick asphalt. Generally, for lean asphalt programs (about 1.5 cm), you should wait until temperatures are 21 ° C or higher. Between 50 and 60 F, then you'll need to speak to your contractor. The hot mix is ​​still functional during this period, however, the time is limited.

How much does an Tar And Chip Paving cost in Ozark?

Take into account the weather vagaries of the climate when choosing the quality of asphalt. The substantial temperature variations that we experience cause appreciable damage to asphalt perform.

Furthermore, it will be useful to distinguish the contractor if you have a recreational vehicle or a van. He will need to adapt the asphalt mixture so as to be more immune to the weight of heavy vehicles.

The Benefits of Tar And Chip Paving

A driveway paved with asphalt has several benefits:

It'll cost you between $ 3 and $11 per square foot; the price varies depending on the quality of the asphalt employed along with the paving contractor.

For a sustainable Tar And Chip Paving

The life of an asphalt paver can be up to 20 decades, when the best conditions are met. We are talking about a professional paving builder, a good grade of asphalt as well as an optimal asphalt laying technique.


The longevity of residential asphalt paving chiefly depends on the standard of the laying. Indeed, the major causes of deformation or tearing of an asphalt coating are the lack of compaction plus a lean base. On the other hand, the upkeep of the asphalt pavement is also a deciding factor in its longevity. That's to say, you'll need to seal your driveway once in ten years, at a minimum, in order to keep its great state.


We advise you to notify your asphalting contractor in case you choose to have your driveway asphalt in order to offer your property. It may not be essential to pay top dollar for laying asphalt , in this circumstance.

Tar And Chip Paving placing: cost and contract

The option of the asphalt laying contractor is essential. In order to not have unpleasant surprises, you'll need to choose it carefully.

Our guarantees and Tar And Chip Paving work

Make sure the paving contractor has liability insurance. A visit to the web site of the Office for Consumer Protection (OPC) will allow you to confirm whether an entrepreneur has ever become the subject of complaints.

The following details must be included in the contract:

- date of start and end of the work;

- evidence of insurance;

- technical particulars;

- RBQ accreditation number.

You should be aware that a paving builder cannot require you to make a down payment before work has started. But you should agree on the payment provisions and be sure it is about the contract.

A solid base for Tar And Chip Paving- Ozark

Before redoing the asphalt drive to your new home by a contractor, or obtaining some basic knowledge is imperative to make sure the job is well done. Know first that the absence of compaction and the inadequate depth of the base are the two chief sources for the deformation or tearing of a layer of asphalt. When it's a new driveway, it has to initially be excavated to make room for a coating of crushed stone of adequate depth. A geotextile membrane is going to be placed under the granular backfill if the dirt turns out to be very loamy (clayey). If you own a new house, it is ideal to wait 6 to 12 months prior to paving your driveway, to allow the dirt to settle . In the event of a fix of this entry, an easy replacement of the asphalt coating can be considered if the contractor considers that the present base is sufficient. In both scenarios, base redone or foundation preserved, the duration of its warranty has to be the same.

Tar And Chip Paving Ozark Alabama

The weather conditions in our lovely state can have a disastrous impact on an asphalt driveway, hence the significance of including a slope with a minimum slope of 2%. This will allow water to drain to the street and decrease the danger of heaving or cracking. This important detail must be taken into account when excavating and preserved during backfilling.

In case you have a van or recreational vehicle, notify the builder before the start of the job: he is going to have the ability to provide materials accordingly. Some asphalt mixtures produce an asphalt that is more immune to heavy duty vehicles.

The asphalt layer should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 ) in order to reach a thickness of at least 5 cm (2 in) after being compacted. For optimum stability, the base should extend across the surface to be paved by roughly thirty centimeters (a couple inches) on each side. Also mention that the installation of unwanted supports around the base is a fantastic method to avoid possible cracks and that asphalting done in chilly weather will be of inferior quality. It is therefore far better to wait for the bright days to return before beginning work.

A Tar And Chip Paving contract with your builder in Ozark

To avoid unpleasant surprises, select your contractor and be sure that the title and address of his business are written about the contract. The start and end dates of this work, as well as proof of the builder's liability insurance and the technical details of the job to be carried out, should also be included. No contractor should need a down payment before work begins. To avoid the inconvenience that might lead to unforeseen costs, visit the Tar And Chip PavingOzark site. You may thus have the tools in hand to successfully complete your asphalt paving project.

Tar And Chip Paving Ozark - Greatest Alabama at Alabama!

For quality asphalting perform , phone on Tar And Chip Paving, Ozark professional team. Consult our Company department to figure out the regions served.

Snow Removal Ozark | Asphalt Ozark
Home >> alabama/ozark >> tar and chip paving
Share this...