Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Options for the asphalt surface in Pelham, Alabama


Tar And Chip Paving installed in an unstable surface can quickly lead to difficulties. There are 3 main choices for the Simple installation:

  1. Paving Over Existing Driveway: If your current driveway is in good condition and not showing severe cracks or crumbling, hot asphalt mix can be placed directly within your driveway. One aspect is height: make certain fences, garage flooring, and other structures are not jeopardized by the higher degree of this new surface.
  2. Remove old driveway, peg to the ground: The present driveway is totally removed (or you may not have a driveway yet) and 4 to 6 inches of hot paving stone is put directly on the ground.
  3. Eliminate the old driveway and fasten it into a solid surface. This is actually the preferred method. An aggregated stone flooring partially replaces part of the hot asphalt mix.

The longer asphalt you work, the more leeway you might have. For instance, at 40 F, the crews just have 16 minutes to operate on 1 1/2 inch thick asphalt. In general, for thin asphalt applications (approximately 1.5 cm), you need to wait until temperatures are 21 ° C or even higher. Between 50 and 60 F, then you'll need to speak to your contractor. The hot mix remains functional in this period of time, however, the time is constrained.

How much can an Tar And Chip Paving cost in Pelham?

Consider the weather vagaries of our climate when choosing the standard of asphalt. The significant temperature variations that we experience cause appreciable damage to asphalt work.

Furthermore, it will be useful to distinguish the contractor should you have a recreational vehicle or even a van. He might need to adapt the asphalt mixture so as to be more immune to the weight of heavy vehicles.

The advantages of Tar And Chip Paving

A driveway paved with asphalt has several benefits:

It will cost you between $ 3 and $11 per square foot; the cost fluctuates based on the quality of the asphalt employed and the paving contractor.

To get a sustainable Tar And Chip Paving

The existence of an asphalt paver can be up to 20 years, when the very best conditions are satisfied. We are referring to a professional paving contractor, a good grade of asphalt as well as an optimal asphalt laying technique.


The durability of residential asphalt paving chiefly depends upon the quality of the laying. Indeed, the major causes of deformation or ripping of an asphalt layer are the lack of compaction and a thin foundation. On the other hand, the upkeep of the asphalt sidewalk can be a deciding factor in its longevity. That is to say, you'll have to seal your driveway once in ten decades, at a minimum, so as to maintain its good condition.


We advise you to notify your asphalting contractor if you choose to get your driveway asphalt so as to offer your property. It may not be essential to pay top dollar for laying asphalt , in this case.

Tar And Chip Paving laying: cost and contract

The option of the asphalt laying builder is indispensable. In order not to have unpleasant surprises, then you will have to choose it carefully.

Guarantee that the paving contractor has liability insurance coverage. A trip to the website of the Office for Consumer Protection (OPC) will allow you to verify whether an entrepreneur has ever been the subject of complaints.

These details must be included in the arrangement:

- date of start and end of the job;

- proof of insurance;

- technical particulars;

- RBQ certification number.

You ought to be aware that a paving builder can't require that you make a deposit before work has begun. But you need to agree on the payment provisions and make sure it is about the contract.

A solid foundation for Tar And Chip Paving- Pelham

Before redoing the asphalt drive to your new home by a contractor, or acquiring some fundamental knowledge is imperative to guarantee that the job is done. Know first that the absence of compaction and the inadequate depth of the base are the two chief causes of the deformation or ripping of a layer of asphalt. If it's a new driveway, it has to first be excavated to make room for a coating of crushed stone of adequate thickness. A geotextile membrane is going to be set under the granular backfill if the soil turns out to be very loamy (clayey). If you have a new house, it is best to wait for 6 to 12 months before paving your driveway, to allow the dirt to settle naturally. In the event of a fix of this entry, an easy replacement of the asphalt coating can be considered if the contractor believes that the present foundation is sufficient. In both scenarios, base redone or base preserved, the duration of its guarantee must be exactly the same.

Tar And Chip Paving Pelham Alabama

The weather conditions in our beautiful province may have a devastating effect in an asphalt driveway, thus the significance of adding a slope with a minimum slope of 2%. This will enable water to drain into the road and minimize the danger of heaving or cracking. This important detail must be taken into account when excavating and preserved during backfilling.

If you have a van or recreational vehicle, notify the builder prior to the onset of the work: he is going to be able to supply materials accordingly. Some asphalt combinations produce an asphalt that is more resistant to heavy duty vehicles.

The asphalt coating should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 ) so as to reach a thickness of 5 cm (2 in) after being compacted. For optimum stability, the foundation should extend over the surface to be paved by roughly thirty centimeters (a dozen inches) on each side. Also mention that the installation of unwanted supports around the foundation is a fantastic way to avoid potential cracks and this asphalting done in chilly weather is going to be of poor quality. It's therefore better to wait for the bright days to return before starting work.

A Tar And Chip Paving contract with your contractor in Pelham

To avoid unpleasant surprises, then choose your contractor and be certain that the name and address of his company are composed about the contract. The beginning and finish dates of the job, in addition to evidence of this builder's liability insurance and the technical details of the project to be completed, should also be included. No contractor should need a deposit before work starts. To avoid the inconvenience that could cause unforeseen costs, take a look at the Tar And Chip PavingPelham website. You may thus have all the resources in hand to successfully finish your asphalt paving project.

Tar And Chip Paving Pelham - Best Alabama in Alabama!

For caliber asphalting work , call on Tar And Chip Paving, Pelham professional team. We've got more than 20 years of experience in asphalt laying, resurfacing, maintenance and repair. Consult our Business department to find out the regions served.

Snow Removal Pelham | Asphalt Pelham
Home >> alabama/pelham >> tar and chip paving
Share this...