Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Options for the asphalt surface in Phenix City, Alabama


Tar And Chip Paving installed on an unstable surface could quickly lead to problems. There are three Chief options for the Simple setup:

  1. Paving Over Existing Driveway: If your existing driveway is in good condition and not showing severe fractures or crumbling, hot asphalt mix can be laid directly over your driveway. One aspect is elevation: make sure fences, garage floors, and other constructions are not compromised by the higher level of this new surface.
  2. Eliminate old driveway, counter into the floor: The present driveway is totally removed (or you might not have a driveway nonetheless ) and 4 to 6 inches of warm paving stone is placed directly on the ground.
  3. Eliminate the old driveway and fasten it into a solid surface. This is actually the preferred method. An aggregated stone flooring partly replaces part of the hot asphalt mixture.

Our Services:

The best time to install Tar And Chip Paving in Phenix City

The more asphalt you operate, the more leeway you might have. By way of instance, at 40 F, the crews only have 16 minutes to work on 1 1/2 inch thick asphalt. In general, for thin asphalt programs (approximately 1.5 cm), you should wait until temperatures are 21 ° C or higher. Between 50 and 60 F, then you'll need to consult with your contractor. The hot mix is ​​still practical during this period of time, however, the time is limited.

How much can an Tar And Chip Paving cost in Phenix City?

Consider the weather vagaries of the climate when deciding upon the quality of asphalt. The significant temperature variations we experience cause appreciable damage to asphalt perform.

In addition, it will be useful to distinguish the contractor should you own a recreational vehicle or a van. He will have to accommodate the asphalt mix so as to be more resistant to the burden of heavy vehicles.

The advantages of Tar And Chip Paving

A driveway paved with asphalt has several benefits:

It'll cost you between $ 3 and $11 per square foot; the cost varies depending on the quality of the asphalt used and the paving contractor.

For a sustainable Tar And Chip Paving

The life of an asphalt paver may be around 20 years, when the best conditions are met. We're referring to a professional paving builder, a great quality of asphalt as well as also an optimal asphalt laying technique.

Tar And Chip Paving in Phenix City: cost, quality of work and lifespan


The longevity of residential asphalt paving largely is dependent on the standard of the placing. Indeed, the significant causes of deformation or tearing of an asphalt layer are the absence of compaction and a lean base. However, the maintenance of the asphalt sidewalk is also a deciding factor in its own longevity. That's to say, you'll need to seal your driveway once in 10 years, at a minimum, so as to keep its good condition.


We advise you to inform your asphalting contractor in case you choose to get your driveway asphalt so as to sell your property. It might not be necessary to pay top dollar for placing asphalt , in such a circumstance.

Tar And Chip Paving laying: cost and contract

The choice of the asphalt laying builder is indispensable. In order not to have unpleasant surprises, then you'll have to choose it carefully.

Guarantee that the paving contractor has liability insurance. A trip to the website of the Office for Consumer Protection (OPC) will make it possible for you to confirm whether an entrepreneur has ever been the subject of complaints.

The following details should be included in the arrangement:

- date of beginning and finish of the work;

- evidence of insurance;

- technical details;

- RBQ accreditation number.

You ought to know that a paving builder can't require you to make a down payment before work has begun. However, you should agree on the payment terms and make sure it is on the contract.

A strong foundation for Tar And Chip Paving- Phenix City

Prior to estimating the asphalt driveway to your new residence by a contractor, or obtaining some fundamental knowledge is vital to guarantee that the job is done. Know first that the absence of compaction and the inadequate depth of the foundation are the two main causes of the deformation or tearing of a layer of asphalt. When it is a new driveway, it has to first be excavated to make room for a coating of crushed stone of adequate thickness. A geotextile membrane will be set beneath the granular backfill if the dirt turns out to be very loamy (clayey). If you own a new home, it's best to wait for 6 to 12 months prior to paving your drive, to enable the soil to settle . In the case of a fix of the entrance, a simple replacement of the asphalt coating can be considered in the event the contractor considers that the present foundation is adequate. In both cases, base redone or foundation maintained, the whole period of its warranty has to be exactly the same.

Tar And Chip Paving Phenix City Alabama

The weather conditions in our lovely state can have a disastrous impact on an asphalt drive, thus the significance of including a slope with a minimum slope of 2%. This will allow water to drain into the street and minimize the danger of heaving or cracking. This significant detail must be taken into consideration when excavating and preserved during backfilling.

If you have a van or recreational vehicle, notify the contractor prior to the onset of the job: he is going to have the ability to provide materials so. Some asphalt mixtures produce an asphalt which is more immune to heavy duty vehicles.

The asphalt coating should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 ) so as to reach a thickness of 5 cm (2 in) after being compacted. For optimum stability, the base should extend over the surface to be paved by about thirty centimeters (a couple inches) on each side. Also mention that the installation of unwanted supports around the foundation is a good way to avoid possible cracks and this asphalting done in cold weather is going to be of poor quality. It's therefore far better to wait for the bright days to return before beginning work.

To avoid unpleasant surprises, then select your contractor diligently and be sure that the name and address of his business are composed about the contract. The beginning and end dates of this work, as well as evidence of this builder's liability insurance and also the technical details of this project to be completed, should also be included. No contractor should require a down payment before work starts. To avoid the inconvenience that could lead to unforeseen expenses, visit the Tar And Chip PavingPhenix City website. You may thus have the resources in hand to successfully complete your asphalt paving project.

Tar And Chip Paving Phenix City - Greatest Alabama at Alabama!

For quality asphalting perform , call on Tar And Chip Paving, Phenix City specialist team. We've got more than 20 years of expertise in asphalt laying, resurfacing, maintenance and repair. Consult our Company department to find out the regions served.

Snow Removal Phenix City | Asphalt Phenix City
Home >> alabama/phenix city >> tar and chip paving
Share this...