Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt Coating in Pleasant Grove, Alabama


Tar And Chip Paving installed on an unstable surface can quickly lead to problems. There are three main options for the basic setup:

  1. Paving Over Existing Driveway: If your current driveway is in good condition rather than showing severe cracks or crumbling, hot asphalt mixture can be laid directly over your driveway. 1 aspect is elevation: make sure fences, garage floors, and other constructions are not compromised by the higher degree of this surface.
  2. Remove old driveway, peg to the floor: The present driveway is totally eliminated (or you may not have a driveway yet) and 4 to 6 inches of hot paving stone is put right on the ground.
  3. Eliminate the old driveway and fasten it into a solid surface. This is the preferred method. An aggregated stone floor partially replaces part of the hot asphalt mix. Generally 6 to 8 inches of limestone extends under 3 inches of asphalt.

The more asphalt you work, the more leeway you have. By way of example, at 40 F, the crews only have 16 minutes to work on 1 1/2 inch thick asphalt. As the asphalt thickness increases by 3 inches, the workability time also raises: 46 minutes. In general, for thin asphalt programs (about 1.5 cm), you should wait until temperatures are 21 ° C or even higher. Between 50 and 60 F, then you'll need to speak to your contractor. The hot mix remains practical during this period of time, however, the time is constrained.

How much can an Tar And Chip Paving cost in Pleasant Grove?

Consider the weather vagaries of our climate when deciding upon the standard of asphalt. The significant temperature variations that we experience cause appreciable damage to asphalt work.

Furthermore, it will be good to distinguish the contractor if you own a recreational vehicle or even a van. He might need to adapt the asphalt mixture so as to be more resistant to the burden of heavy vehicles.

The advantages of Tar And Chip Paving

  • Smooth end;
  • non invasive
  • easy to Keep
  • watertightness ensured
  • withstands the rigors of this Quebec climate quite well (provided it's been set up );
  • prevents the growth of moss;

It will cost you between $ 3 and $11 per square foot; the price varies depending on the quality of the asphalt used and the paving contractor.

For a sustainable Tar And Chip Paving

The life of an asphalt paver can be around 20 years, when the best conditions are satisfied. We are talking about a professional paving builder, a great quality of asphalt and also an optimal asphalt laying technique.

Tar And Chip Paving in Pleasant Grove: price, quality of work and lifespan


The durability of residential asphalt paving chiefly depends on the quality of the laying. Indeed, the major causes of deformation or tearing of an asphalt layer are the lack of compaction plus a thin foundation. However, the upkeep of the asphalt pavement can be a determining factor in its own longevity. That's to say, you'll need to seal your driveway once in ten years, at a minimum, in order to keep its good state.


We advise you to notify your asphalting builder in case you decide to have your driveway asphalt so as to sell your property. It may not be necessary to pay top dollar for placing asphalt , in this circumstance.

Tar And Chip Paving laying: price and contract

The choice of the asphalt laying builder is indispensable. In order not to have unpleasant surprises, you'll have to choose it carefully.

Make sure the paving contractor has liability insurance coverage. A trip to the website of the Office for Consumer Protection (OPC) will make it possible for you to verify whether an entrepreneur has ever been the subject of complaints.

The following details must be included in the contract:

- date of beginning and finish of the job;

- evidence of insurance;

- technical particulars;

- RBQ certification number.

You should know that a paving builder cannot require that you make a deposit before work has begun. But you need to agree to the payment terms and be sure it is about the contract.

A solid foundation for Tar And Chip Paving- Pleasant Grove

Prior to estimating the asphalt drive to your new home by a contractor, or acquiring some fundamental knowledge is imperative to guarantee that the job is done. Know first that the lack of compaction and the inadequate depth of the foundation are the two main causes of the deformation or tearing of a coating of asphalt. If it is a new driveway, it must initially be excavated to make room for a coating of crushed stone of adequate thickness. A geotextile membrane is going to be placed under the granular backfill if the dirt proves to be very loamy (clayey). If you have a new home, it's ideal to wait 6 to 12 months before paving your driveway, to allow the soil to settle naturally. In the case of a fix of the entrance, an easy replacement of the asphalt coating can be considered in the event the contractor considers that the present foundation is sufficient. In both cases, base redone or foundation maintained, the duration of its guarantee has to be the same.

Tar And Chip Paving Pleasant Grove Alabama

The weather conditions in our beautiful province may have a devastating effect in an asphalt driveway, hence the importance of including a slope having a minimum slope of 2%. This will allow water to drain to the road and minimize the danger of heaving or cracking. This important detail must be taken into consideration when excavating and preserved during backfilling.

In case you have a van or recreational vehicle, notify the contractor prior to the start of the work: he is going to be able to supply materials accordingly. Some asphalt combinations produce an asphalt which is more resistant to heavy duty vehicles.

The asphalt coating should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 in) in order to reach a thickness of at least 5 cm (2 ) after being compacted. For optimal stability, the foundation should extend over the surface to be paved by about thirty centimeters (a couple inches) on each side. Also mention that the installation of unwanted supports around the foundation is a good way to prevent potential cracks and that asphalting done in chilly weather is going to be of poor quality. It's therefore far better to await the sunny days to return before starting work.

To avoid unpleasant surprises, choose your contractor and be certain the name and address of the company are composed about the contract. The beginning and finish dates of the job, as well as proof of the contractor's liability insurance and the technical specifics of the project to be carried out, should also be included. No contractor should require a deposit before work begins. To avoid the inconvenience that might cause unforeseen expenses, visit the Tar And Chip PavingPleasant Grove website. You will thus have all the resources in hand to successfully complete your asphalt paving project.

Tar And Chip Paving Pleasant Grove - Greatest Alabama at Alabama!

For caliber asphalting perform , phone on Tar And Chip Paving, Pleasant Grove professional team. We've got over 20 decades of expertise in asphalt laying, resurfacing, maintenance and repair. Consult our Business section to figure out the regions served.

Snow Removal Pleasant Grove | Asphalt Pleasant Grove
Home >> alabama/pleasant grove >> tar and chip paving
Share this...