Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt Coating in Scottsboro, Alabama


Tar And Chip Paving installed on an unstable surface can quickly lead to difficulties. There are three main options for the basic installation:

  1. Paving Over Existing Driveway: If your existing driveway is in good shape and not showing severe fractures or crumbling, hot asphalt mixture can be placed directly within your driveway. 1 facet is height: make sure fences, garage flooring, and other structures are not jeopardized by the greater degree of the new surface.
  2. Remove old driveway, counter into the floor: The existing driveway is completely eliminated (or you may not have a driveway yet) and 4 to 6 inches of warm paving stone is put right on the ground.
  3. Remove the old driveway and secure it to a good surface. This is the preferred method. An aggregated stone floor partly replaces part of the hot asphalt mix. Generally 6 to 8 inches of limestone extends under 3 inches of asphalt.

The more asphalt you operate, the more leeway you have. For example, at 40 F, the crews only have 16 minutes to operate on 1 1/2 inch thick asphalt. As the asphalt thickness increases by 3 inches, the workability time also increases: 46 minutes. In general, for lean asphalt programs (approximately 1.5 cm), you should wait until temperatures are 21 ° C or higher. Between 50 and 60 F, you'll need to speak to your contractor. The hot mix is ​​still functional during this period of time, however, the time is constrained.

How much does an Tar And Chip Paving price in Scottsboro?

Consider the weather vagaries of the climate when deciding upon the standard of asphalt. The substantial temperature variations that we experience cause appreciable damage to asphalt perform.

In addition, it will be useful to distinguish the contractor if you have a recreational vehicle or a van. He might need to adapt the asphalt mixture so as to be more immune to the weight of heavy vehicles.

The Benefits of Tar And Chip Paving

A driveway paved with asphalt has several benefits:

It'll cost you between $ 3 and $11 per square foot; the price varies depending on the quality of the asphalt used along with the paving contractor.

For a sustainable Tar And Chip Paving

The life of an asphalt paver may be around 20 decades, when the very best conditions are satisfied. We're talking about a professional paving contractor, a great quality of asphalt as well as an optimal asphalt laying technique.


The durability of residential asphalt paving largely is dependent upon the standard of the placing. Really, the major causes of deformation or ripping of an asphalt coating are the absence of compaction and a thin foundation. However, the maintenance of the asphalt sidewalk is also a determining factor in its longevity. That is to say, you will need to seal your driveway once in 10 decades, at a minimum, so as to maintain its great state.


We suggest that you notify your asphalting builder if you decide to have your driveway asphalt in order to offer your property. It may not be necessary to pay top dollar for placing asphalt , in this circumstance.

Tar And Chip Paving laying: price and contract

The choice of the asphalt laying builder is indispensable. In order not to have unpleasant surprises, then you'll have to select it carefully.

Our ensures and Tar And Chip Paving work

Make sure the paving contractor has liability insurance. A trip to the web site of the Office for Consumer Protection (OPC) will make it possible for you to confirm whether an entrepreneur has ever become the subject of complaints.

These details should be included in the arrangement:

- date of beginning and finish of the work;

- proof of insurance;

- technical particulars;

- RBQ certification number.

You should know that a paving builder cannot demand that you make a down payment before work has started. But you should agree to the payment terms and be sure it is on the contract.

Prior to estimating the asphalt driveway to your new home by a contractor, or acquiring some fundamental knowledge is vital to guarantee that the job is done. Know first that the absence of compaction and the inadequate thickness of the foundation are the two chief sources for the deformation or ripping of a coating of asphalt. When it's a new driveway, it has to first be excavated to make room for a layer of crushed stone of adequate thickness. A geotextile membrane is going to be set under the granular backfill if the dirt proves to be very loamy (clayey). If you own a new house, it is ideal to wait 6 to 12 months prior to paving your driveway, to enable the dirt to settle naturally. In the case of a repair of the entrance, an easy replacement of the asphalt layer can be considered in the event the contractor considers that the existing base is sufficient. In both scenarios, base redone or foundation maintained, the whole period of its warranty must be the same.

Tar And Chip Paving Scottsboro Alabama

The weather conditions in our lovely state can have a devastating effect on an asphalt driveway, hence the significance of adding a slope having a minimum slope of 2%. This will allow water to drain to the road and decrease the danger of heaving or cracking. This significant detail has to be taken into account when excavating and preserved during backfilling.

In case you have a van or recreational vehicle, notify the contractor prior to the onset of the work: he will have the ability to supply materials accordingly. Some asphalt combinations produce an asphalt which is more immune to heavy duty vehicles.

The asphalt coating should have an initial thickness of 6.35 to 7.6 cm (2.5 to 3 ) so as to accomplish a thickness of at least 5 cm (2 ) after being compacted. For optimum stability, the base should extend across the surface to be paved by roughly thirty centimeters (a dozen inches) on each side. Also mention that the setup of unwanted supports around the foundation is a good way to prevent potential cracks and this asphalting done in chilly weather will be of poor quality. It is therefore better to wait for the bright days to go back before starting work.

A Tar And Chip Paving contract with your contractor in Scottsboro

To avoid unpleasant surprises, then select your contractor and be certain that the title and address of his business are composed about the contract. The start and end dates of the job, in addition to evidence of this contractor's liability insurance and the technical details of this job to be completed, should also be included. No contractor should need a deposit before work starts. To avoid the inconvenience that might lead to unforeseen expenses, visit the Tar And Chip PavingScottsboro site. You will thus have all the tools in hand to successfully complete your asphalt paving project.

Tar And Chip Paving Scottsboro - Greatest Alabama at Alabama!

For quality asphalting perform , call on Tar And Chip Paving, Scottsboro professional team. Consult our Company section to find out the regions served.

Snow Removal Scottsboro | Asphalt Scottsboro
Home >> alabama/scottsboro >> tar and chip paving
Share this...