Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Options for the asphalt surface in Selma, Alabama


Tar And Chip Paving installed in an unstable surface could quickly lead to difficulties. There are three Chief choices for the Simple setup:

  1. Paving Over Existing Driveway: If your existing driveway is in good condition and not showing serious cracks or crumbling, hot asphalt mixture can be placed directly within your driveway. One facet is height: make certain fences, garage flooring, and other constructions aren't compromised by the greater degree of this surface.
  2. Eliminate old driveway, counter into the floor: The existing driveway is totally eliminated (or you might not have a driveway nonetheless ) and 4 to 6 inches of warm paving stone is put directly on the ground.
  3. Remove the old driveway and secure it into a good surface. This is actually the preferred method. An aggregated stone floor partially replaces part of the hot asphalt mix.

Our Services:

The best time to install Tar And Chip Paving from Selma

The longer asphalt you work, the more leeway you might have. For instance, in 40 F, the crews just have 16 minutes to operate on 1 1/2 inch thick asphalt. In general, for lean asphalt programs (approximately 1.5 cm), you should wait until temperatures are 21 ° C or higher. Between 50 and 60 F, then you ought to speak to your contractor. The hot mix remains functional in this period of time, but the time is limited.

How much does an Tar And Chip Paving price in Selma?

Take into account the weather vagaries of our climate when choosing the quality of asphalt. The substantial temperature variations that we experience cause appreciable damage to asphalt work.

Furthermore, it'll be good to distinguish the contractor if you have a recreational vehicle or a van. He might need to accommodate the asphalt mixture so as to be more resistant to the burden of heavy vehicles.

The Benefits of Tar And Chip Paving

A driveway paved with asphalt has several advantages:

It will cost you between $ 3 and $11 per square foot; the price fluctuates based on the quality of the asphalt used and the paving contractor.

For a sustainable Tar And Chip Paving

The existence of an asphalt paver may be around 20 years, when the best states are satisfied. We're talking about a professional paving contractor, a great quality of asphalt as well as also an optimal asphalt laying technique.


The durability of residential asphalt paving largely is dependent on the standard of the placing. Really, the major causes of deformation or tearing of an asphalt coating are the absence of compaction and a lean base. On the other hand, the maintenance of the asphalt sidewalk is also a deciding factor in its own longevity. That is to say, you'll have to seal your driveway once in 10 decades, at a minimum, in order to keep its great state.


We advise you to notify your asphalting contractor if you choose to get your driveway asphalt so as to sell your property. It might not be necessary to pay top dollar for placing asphalt , in such a circumstance.

Tar And Chip Paving placing: cost and contract

The option of the asphalt laying builder is essential. In order to not have unpleasant surprises, then you'll need to choose it carefully.

Our guarantees and Tar And Chip Paving work

Make sure the paving contractor has liability insurance. A trip to the web site of the Office for Consumer Protection (OPC) will allow you to confirm whether an entrepreneur has become the subject of complaints.

These details should be included in the contract:

- date of beginning and finish of the work;

- proof of insurance;

- technical details;

- RBQ certification number.

You should be aware that a paving contractor cannot demand you to make a deposit before work has started. However, you should agree on the payment terms and be sure it is about the contract.

Prior to estimating the asphalt driveway to your new home by a builder, or obtaining some basic knowledge is vital to guarantee that the job is done. Know first that the lack of compaction and the inadequate thickness of the base are the two main causes of the deformation or tearing of a coating of asphalt. If it's a new driveway, then it must first be excavated to make room for a coating of crushed stone of sufficient depth. A geotextile membrane is going to be placed under the granular backfill if the dirt turns out to be very loamy (clayey). If you own a new home, it's best to wait for 6 to 12 months before paving your driveway, to allow the soil to settle naturally. In the case of a repair of this entry, an easy replacement of the asphalt coating can be considered in the event the contractor believes that the existing base is adequate. In both cases, foundation redone or base maintained, the whole period of its warranty must be exactly the same.

Tar And Chip Paving Selma Alabama

The weather conditions in our lovely state may have a disastrous impact in an asphalt drive, hence the importance of including a slope with a minimum slope of 2%. This will enable water to drain to the street and minimize the risk of heaving or cracking. This significant detail has to be taken into consideration when excavating and maintained during backfilling.

If you've got a van or recreational vehicle, notify the contractor before the onset of the work: he is going to be able to provide materials so. Some asphalt combinations produce an asphalt which is more resistant to heavy-duty vehicles.

The asphalt layer should have an initial thickness of 6.35 to 7.6 cm (2.5 to 3 ) so as to accomplish a thickness of 5 cm (2 in) after being compacted. For optimal stability, the foundation should extend over the surface to be paved by about thirty centimeters (a dozen inches) on each side. Also mention that the setup of side supports around the base is a good way to prevent potential cracks and that asphalting done in cold weather will be of poor quality. It is therefore far better to await the sunny days to return before beginning work.

To avoid unpleasant surprises, select your contractor diligently and be sure that the title and address of his company are composed on the contract. The start and finish dates of the job, in addition to evidence of the contractor's liability insurance and the technical specifics of the job to be completed, should also be included. No contractor should need a deposit before work starts. To prevent the inconvenience that might lead to unforeseen expenses, take a look at the Tar And Chip PavingSelma website. You may thus have all the resources in hand to successfully complete your asphalt paving project.

Tar And Chip Paving Selma - Best Alabama in Alabama!

For caliber asphalting work , call on Tar And Chip Paving, Selma professional team. We have more than 20 decades of experience in asphalt laying, resurfacing, maintenance and repair. Consult our Business section to figure out the regions served.

Snow Removal Selma | Asphalt Selma
Home >> alabama/selma >> tar and chip paving
Share this...