Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Options for the asphalt surface in Sylacauga, Alabama


Tar And Chip Paving installed in an unstable surface could quickly lead to problems. There are 3 Chief options for the Simple setup:

  1. Paving Over Existing Driveway: If your current driveway is in good condition and not revealing serious fractures or crumbling, hot asphalt mixture can be placed directly within your driveway. One aspect is height: make sure fences, garage flooring, and other constructions are not compromised by the greater level of the new surface.
  2. Remove old driveway, peg to the floor: The present driveway is completely eliminated (or you may not have a driveway nonetheless ) and 4 to 6 inches of warm paving stone is put directly on the ground.
  3. Eliminate the old driveway and fasten it into a solid surface. This is actually the preferred method. An aggregated stone flooring partially replaces part of the hot asphalt mix. Generally 6 to 8 inches of limestone goes under 3 inches of asphalt.

Our Services:

The best time to install Tar And Chip Paving in Sylacauga

The longer asphalt you work, the more leeway you might have. By way of example, in 40 F, the crews only have 16 minutes to operate on 1 1/2 inch thick asphalt. As the asphalt depth increases by 3 inches, the workability time also increases: 46 minutes. Generally, for lean asphalt programs (about 1.5 cm), you should wait until temperatures are 21 ° C or higher. Between 50 and 60 F, then you ought to speak to your contractor. The hot mix remains practical during this period of time, but the time is constrained.

How much does an Tar And Chip Paving price in Sylacauga?

Take into account the weather vagaries of our climate when deciding upon the quality of asphalt. The significant temperature variations that we experience cause appreciable damage to asphalt work.

Furthermore, it will be good to distinguish the contractor should you have a recreational vehicle or a van. He will have to adapt the asphalt mixture so as to be more immune to the weight of heavy vehicles.

The advantages of Tar And Chip Paving

A driveway paved with asphalt has several benefits:

It will cost you between $ 3 and $11 per square foot; the price fluctuates based on the characteristic of the asphalt employed along with the paving contractor.

To get a sustainable Tar And Chip Paving

The existence of an asphalt paver may be around 20 years, when the best states are satisfied. We're referring to a professional paving builder, a good grade of asphalt and an optimal asphalt laying technique.

Tar And Chip Paving in Sylacauga: price, quality of work and lifespan


The longevity of residential asphalt paving largely depends upon the standard of the laying. Indeed, the major causes of deformation or ripping of an asphalt layer are the absence of compaction and a thin foundation. On the other hand, the upkeep of the asphalt pavement is also a determining factor in its own longevity. That's to say, you'll need to seal your driveway once in ten years, at a minimum, in order to maintain its good state.


We suggest that you inform your asphalting contractor in case you choose to have your driveway asphalt in order to sell your property. It may not be essential to pay top dollar for laying asphalt , in this case.

Tar And Chip Paving placing: cost and contract

The choice of the asphalt laying builder is indispensable. In order not to have unpleasant surprises, then you'll need to choose it carefully.

Guarantee that the paving contractor has liability insurance coverage. A trip to the web site of the Office for Consumer Protection (OPC) will allow you to confirm whether an entrepreneur has ever been the subject of complaints.

These details must be included in the contract:

- date of start and finish of the work;

- proof of insurance;

- technical particulars;

- RBQ accreditation number.

You should know that a paving builder can't demand that you make a deposit before work has started. But you should agree to the payment provisions and be sure it is about the contract.

Before redoing the asphalt drive to your new residence by a contractor, or acquiring some basic knowledge is imperative to guarantee that the job is well done. Know first that the absence of compaction and the insufficient thickness of the foundation are the two main causes of the deformation or ripping of a layer of asphalt. If it is a new driveway, then it must first be excavated to make room for a coating of crushed stone of adequate depth. A geotextile membrane is going to be set beneath the granular backfill if the dirt turns out to be very loamy (clayey). If you own a new home, it is best to wait 6 to 12 months prior to paving your driveway, to allow the soil to settle naturally. In the event of a fix of the entrance, an easy replacement of the asphalt layer can be considered if the contractor considers that the present foundation is adequate. In both cases, foundation redone or base preserved, the duration of its guarantee has to be exactly the same.

Tar And Chip Paving Sylacauga Alabama

The weather conditions in our lovely state can have a disastrous impact on an asphalt driveway, thus the significance of adding a slope having a minimum slope of 2%. This will allow water to drain into the street and decrease the danger of heaving or cracking. This important detail must be taken into account when excavating and preserved during backfilling.

If you've got a van or recreational vehicle, notify the builder before the start of the job: he is going to have the ability to provide materials so. Some asphalt combinations produce an asphalt which is more resistant to heavy duty vehicles.

The asphalt coating should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 in) in order to reach a thickness of 5 cm (2 in) after being compacted. For optimum stability, the base should extend across the surface to be paved by about thirty centimeters (a dozen inches) on each side. Also note that the setup of unwanted supports around the base is a good method to prevent potential cracks and that asphalting done in cold weather will be of inferior quality. It's therefore far better to await the bright days to return before starting work.

A Tar And Chip Paving contract with your contractor in Sylacauga

To avoid unpleasant surprises, then choose your contractor diligently and make sure the name and address of his company are written about the contract. The beginning and finish dates of the job, in addition to proof of the builder's liability insurance and the technical details of this job to be carried out, should also be included. No contractor should need a down payment before work begins. To avoid the inconvenience that might lead to unforeseen costs, visit the Tar And Chip PavingSylacauga website. You may thus have the tools in hand to successfully complete your asphalt paving project.

Tar And Chip Paving Sylacauga - Best Alabama at Alabama!

For quality asphalting perform , phone on Tar And Chip Paving, Sylacauga specialist team. Consult our Company department to find out the regions served.

Snow Removal Sylacauga | Asphalt Sylacauga
Home >> alabama/sylacauga >> tar and chip paving
Share this...