Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt Coating in Troy, Alabama


Tar And Chip Paving installed in an unstable surface can quickly lead to problems. There are 3 main options for the Simple setup:

  1. Paving Over Existing Driveway: If your current driveway is in good shape and not showing severe cracks or crumbling, hot asphalt mixture can be placed directly within your driveway. One facet is height: make sure fences, garage floors, and other structures are not compromised by the higher level of the new surface.
  2. Remove old driveway, counter into the ground: The existing driveway is completely eliminated (or you might not have a driveway yet) and 4 to 6 inches of hot paving stone is placed directly on the ground.
  3. Remove the old driveway and fasten it to a solid surface. This is the preferred method. An aggregated stone flooring partly replaces part of the hot asphalt mix. Typically 6 to 8 inches of aggregate goes under 3 inches of asphalt.

Our Services:

The best time to install Tar And Chip Paving from Troy

The more asphalt you work, the more leeway you might have. For example, at 40 F, the crews only have 16 minutes to work on 1 1/2 inch thick asphalt. As the asphalt thickness increases by 3 inches, the workability time also raises: 46 minutes. Generally, for thin asphalt programs (about 1.5 cm), you need to wait until temperatures are 21 ° C or higher. Between 50 and 60 F, you'll need to speak to your contractor. The hot mix is ​​still functional during this period of time, however, the time is constrained.

How much does an Tar And Chip Paving cost in Troy?

Take into account the weather vagaries of our climate when deciding upon the quality of asphalt. The significant temperature variations that we experience cause considerable damage to asphalt work.

Furthermore, it will be good to distinguish the contractor should you have a recreational vehicle or even a van. He might have to adapt the asphalt mix so as to be more resistant to the weight of heavy vehicles.

The advantages of Tar And Chip Paving

  • Smooth finish;
  • non invasive
  • Simple to Keep
  • watertightness guaranteed
  • withstands the rigors of this Quebec climate quite well (provided it's been set up );
  • prevents the growth of moss;

It'll cost you between $ 3 and $11 per square foot; the price fluctuates based on the characteristic of the asphalt employed and the paving contractor.

For a sustainable Tar And Chip Paving

The existence of an asphalt paver can be around 20 years, when the best states are met. We're referring to a professional paving contractor, a great grade of asphalt as well as an optimal asphalt laying technique.

Tar And Chip Paving in Troy: price, quality of work and lifespan


The durability of residential asphalt paving chiefly is dependent upon the standard of the laying. Really, the major causes of deformation or ripping of an asphalt layer are the lack of compaction plus a thin foundation. However, the upkeep of the asphalt sidewalk can be a determining factor in its own longevity. That's to say, you will have to seal your drive once in 10 decades, at a minimum, so as to keep its great condition.


We advise you to notify your asphalting builder if you choose to have your driveway asphalt so as to offer your property. It might not be necessary to pay top dollar for placing asphalt , in this case.

Tar And Chip Paving laying: price and contract

The choice of the asphalt laying builder is indispensable. In order to not have unpleasant surprises, then you will need to select it carefully.

Guarantee that the paving contractor has liability insurance. A visit to the website of the Office for Consumer Protection (OPC) will allow you to confirm whether an entrepreneur has been the subject of complaints.

These details must be included in the arrangement:

- date of start and finish of the work;

- evidence of insurance;

- technical details;

- RBQ certification number.

You ought to know that a paving contractor cannot require that you make a down payment before work has begun. But you should agree to the payment provisions and be sure it is on the contract.

A solid base for Tar And Chip Paving- Troy

Prior to estimating the asphalt drive to your new residence by a builder, or acquiring some fundamental knowledge is vital to make sure the job is done. Know first that the lack of compaction and the inadequate thickness of the base are the two chief causes of the deformation or tearing of a coating of asphalt. When it is a new driveway, it must initially be excavated to make room for a layer of crushed stone of adequate depth. A geotextile membrane is going to be placed under the granular backfill if the dirt turns out to be very loamy (clayey). If you own a new house, it is ideal to wait for 6 to 12 months before paving your driveway, to enable the dirt to settle . In the event of a repair of this entry, an easy replacement of the asphalt layer can be considered in the event the contractor believes that the existing base is sufficient. In both cases, foundation redone or foundation preserved, the whole period of its guarantee has to be exactly the same.

Tar And Chip Paving Troy Alabama

The weather conditions in our beautiful province may have a devastating effect on an asphalt driveway, hence the importance of including a slope having a minimum slope of 2%. This will enable water to drain to the road and decrease the danger of heaving or cracking. This important detail has to be taken into account when excavating and maintained during backfilling.

If you have a van or recreational vehicle, notify the builder prior to the start of the work: he is going to be able to provide materials so. Some asphalt mixtures produce an asphalt which is more immune to heavy duty vehicles.

The asphalt layer should have an initial thickness of 6.35 to 7.6 cm (2.5 to 3 in) in order to reach a thickness of at least 5 cm (2 in) after being compacted. For optimum stability, the foundation should extend across the surface to be paved by roughly thirty centimeters (a couple inches) on each side. Also mention that the installation of unwanted supports around the base is a good method to avoid possible cracks and that asphalting done in cold weather is going to be of inferior quality. It's therefore better to wait for the sunny days to return before beginning work.

To avoid unpleasant surprises, then select your contractor diligently and be certain the title and address of the company are written about the contract. The beginning and finish dates of the job, as well as proof of this contractor's liability insurance and the technical details of this job to be carried out, should also be included. No contractor should need a down payment before work starts. To prevent the inconvenience that could lead to unforeseen expenses, visit the Tar And Chip PavingTroy website. You may thus have the resources in hand to successfully complete your asphalt paving project.

Tar And Chip Paving Troy - Greatest Alabama at Alabama!

For caliber asphalting perform , phone on Tar And Chip Paving, Troy professional team. We have over twenty years of experience in asphalt laying, resurfacing, maintenance and repair. Confirm our Company department to figure out the regions served.

Snow Removal Troy | Asphalt Troy
Home >> alabama/troy >> tar and chip paving
Share this...