Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Asphalt- Options for the asphalt surface in College, Alaska


Asphalt installed in an unstable surface can quickly lead to difficulties. There are three Chief choices for the basic setup:

  1. Paving Over Existing Driveway: If your current driveway is in good condition rather than revealing severe cracks or crumbling, hot asphalt mix can be placed directly within your driveway. 1 facet is elevation: make sure fences, garage flooring, and other structures are not compromised by the higher degree of this new surface.
  2. Remove old driveway, peg to the floor: The existing driveway is totally removed (or you might not have a driveway nonetheless ) and 4 to 6 inches of hot paving stone is put directly on the ground.
  3. Eliminate the old driveway and secure it to a good surface. This is the preferred method. An aggregated stone flooring partially replaces part of this hot asphalt mix.

Our Services:

The best time to install Asphalt from College

The longer asphalt you operate, the more leeway you have. For instance, at 40 F, the crews just have 16 minutes to work on 1 1/2 inch thick asphalt. Generally, for lean asphalt applications (about 1.5 cm), you should wait until temperatures are 21 ° C or even higher. Between 50 and 60 F, you'll need to consult with your contractor. The hot mix remains functional in this period of time, however, the time is limited.

How much does an Asphalt cost in College?

Take into account the weather vagaries of the climate when deciding upon the standard of asphalt. The significant temperature variations that we experience cause appreciable damage to asphalt perform.

In addition, it'll be good to tell the contractor if you have a recreational vehicle or a van. He might have to accommodate the asphalt mix so as to be more resistant to the weight of heavy vehicles.

The advantages of Asphalt

  • Smooth end;
  • non invasive
  • Simple to maintain
  • watertightness ensured
  • withstands the rigors of the Quebec climate very well (provided it's been set up optimally);
  • prevents the growth of moss;

It will cost you between $ 3 and $11 per square foot; the cost varies depending on the quality of the asphalt employed and the paving contractor.

To get a sustainable Asphalt

The life of an asphalt paver may be up to 20 years, when the very best states are satisfied. We're referring to a professional paving contractor, a good quality of asphalt and an optimal asphalt laying technique.

Asphalt in College: cost, quality of work and lifespan


The durability of residential asphalt paving largely is dependent upon the standard of the laying. Really, the major causes of deformation or tearing of an asphalt layer are the lack of compaction plus a thin foundation. However, the upkeep of the asphalt pavement is also a deciding factor in its own longevity. That is to say, you'll need to seal your drive once in 10 years, at a minimum, in order to maintain its great state.


We advise you to notify your asphalting builder in case you choose to have your driveway asphalt so as to offer your property. It might not be necessary to pay top dollar for placing asphalt , in such a circumstance.

Asphalt placing: price and contract

The option of the asphalt laying contractor is indispensable. In order to not have unpleasant surprises, you will need to choose it carefully.

Guarantee that the paving contractor has liability insurance coverage. A visit to the web site of the Office for Consumer Protection (OPC) will make it possible for you to confirm whether an entrepreneur has ever become the subject of complaints.

The following details must be included in the arrangement:

- date of start and finish of the job;

- evidence of insurance;

- technical details;

- RBQ accreditation number.

You ought to be aware that a paving builder cannot require you to make a down payment before work has started. But you should agree to the payment terms and be sure it is on the contract.

Prior to estimating the asphalt drive to your new residence by a builder, or obtaining some basic knowledge is vital to guarantee that the job is done. Know first that the lack of compaction and the insufficient depth of the foundation are the two chief sources for the deformation or ripping of a layer of asphalt. When it is a new driveway, then it has to initially be excavated to make room for a coating of crushed stone of sufficient depth. A geotextile membrane will be set under the granular backfill if the dirt turns out to be very loamy (clayey). If you have a new home, it is ideal to wait for 6 to 12 months before paving your driveway, to enable the dirt to settle . In the event of a repair of the entrance, a simple replacement of the asphalt coating can be considered in the event the contractor considers that the present foundation is sufficient. In both cases, base redone or foundation maintained, the whole period of its guarantee has to be the same.

Asphalt College Alaska

The weather conditions in our lovely state may have a devastating effect in an asphalt driveway, hence the significance of including a slope having a minimum slope of 2%. This will allow water to drain to the street and minimize the risk of heaving or cracking. This significant detail must be taken into account when excavating and preserved during backfilling.

In case you have a van or recreational vehicle, notify the builder prior to the start of the work: he will have the ability to provide materials accordingly. Some asphalt mixtures produce an asphalt which is more resistant to heavy-duty vehicles.

The asphalt coating should have an initial thickness of 6.35 to 7.6 cm (2.5 to 3 ) so as to reach a thickness of 5 cm (2 in) after being compacted. For optimal stability, the base should extend over the surface to be paved by about thirty centimeters (a dozen inches) on each side. Also note that the setup of unwanted supports around the base is a fantastic method to avoid potential cracks and that asphalting done in cold weather will be of poor quality. It's therefore far better to wait for the sunny days to go back before beginning work.

A Asphalt contract with your contractor in College

To avoid unpleasant surprises, then choose your contractor and be sure the name and address of the business are composed on the contract. The start and end dates of this work, as well as evidence of the builder's liability insurance and the technical details of this job to be completed, should also be included. No contractor should require a down payment before work starts. To prevent the inconvenience that could cause unforeseen expenses, visit the AsphaltCollege website. You will thus have all the resources in hand to successfully complete your asphalt paving project.

Asphalt College - Best Alaska at Alaska!

For caliber asphalting work , call on Asphalt, College professional team. We have over 20 decades of experience in asphalt laying, resurfacing, maintenance and repair. Consult our Company department to figure out the regions served.

Tar And Chip Paving College | Parking Lot Repair And Striping College
Home >> alaska/college >> asphalt
Share this...