Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt Coating in Knik Fairview, Alaska


Tar And Chip Paving installed on an unstable surface could quickly lead to difficulties. There are three Chief options for the Simple setup:

  1. Paving Over Existing Driveway: If your current driveway is in good condition rather than revealing severe fractures or crumbling, hot asphalt mixture can be placed directly within your driveway. 1 aspect is elevation: make sure fences, garage flooring, and other constructions aren't compromised by the higher level of the surface.
  2. Eliminate old driveway, counter into the ground: The existing driveway is completely eliminated (or you may not have a driveway yet) and 4 to 6 inches of warm paving stone is placed right on the ground.
  3. Remove the old driveway and secure it to a solid surface. This is the preferred method. An aggregated stone floor partly replaces part of this hot asphalt mix. Typically 6 to 8 inches of limestone extends under 3 inches of asphalt.

Our Services:

The best time to install Tar And Chip Paving in Knik Fairview

The more asphalt you operate, the more leeway you have. For example, in 40 F, the crews only have 16 minutes to work on 1 1/2 inch thick asphalt. In general, for lean asphalt applications (about 1.5 cm), you need to wait until temperatures are 21 ° C or even higher. Between 50 and 60 F, you'll need to consult with your contractor. The hot mix remains functional during this period, but the time is constrained.

How much does an Tar And Chip Paving price in Knik Fairview?

Take into account the weather vagaries of the climate when choosing the standard of asphalt. The substantial temperature variations that we experience cause appreciable damage to asphalt work.

In addition, it'll be good to distinguish the contractor if you own a recreational vehicle or a van. He might need to adapt the asphalt mixture so as to be more resistant to the burden of heavy vehicles.

The Benefits of Tar And Chip Paving

  • Smooth end;
  • non-slip
  • Simple to maintain
  • watertightness guaranteed
  • withstands the rigors of the Quebec climate quite well (provided it has been set up );
  • prevents the growth of moss;

It'll cost you between $ 3 and $11 per square foot; the price varies depending on the characteristic of the asphalt used and the paving contractor.

For a sustainable Tar And Chip Paving

The life of an asphalt paver can be up to 20 decades, when the very best conditions are met. We are referring to a professional paving builder, a great grade of asphalt as well as an optimal asphalt laying technique.

Tar And Chip Paving in Knik Fairview: cost, quality of work and lifespan


The durability of residential asphalt paving largely depends on the standard of the laying. Indeed, the major causes of deformation or ripping of an asphalt layer are the lack of compaction and a thin foundation. However, the maintenance of the asphalt pavement is also a deciding factor in its own longevity. That is to say, you will have to seal your driveway once in 10 years, at a minimum, so as to maintain its good state.


We advise you to notify your asphalting builder in case you decide to have your driveway asphalt in order to offer your property. It may not be necessary to pay top dollar for laying asphalt , in this case.

Tar And Chip Paving laying: cost and contract

The choice of the asphalt laying contractor is indispensable. In order not to have unpleasant surprises, you'll need to select it carefully.

Guarantee that the paving contractor has liability insurance coverage. A trip to the website of the Office for Consumer Protection (OPC) will allow you to confirm whether an entrepreneur has ever become the subject of complaints.

The following details must be included in the arrangement:

- date of start and end of the work;

- proof of insurance;

- technical details;

- RBQ accreditation number.

You should be aware that a paving builder cannot require you to make a deposit before work has started. But you should agree on the payment provisions and make sure it's about the contract.

A strong base for Tar And Chip Paving- Knik Fairview

Before redoing the asphalt drive to your new residence by a contractor, or obtaining some fundamental knowledge is vital to make sure the job is done. Know first that the lack of compaction and the insufficient depth of the foundation are the two main sources for the deformation or tearing of a layer of asphalt. If it's a new driveway, it must initially be excavated to make room for a coating of crushed stone of sufficient depth. A geotextile membrane is going to be placed under the granular backfill if the dirt turns out to be somewhat loamy (clayey). If you have a new home, it's ideal to wait 6 to 12 months prior to paving your driveway, to enable the soil to settle . In the case of a fix of this entry, a simple replacement of the asphalt coating can be considered in the event the contractor considers that the existing base is adequate. In both scenarios, base redone or base preserved, the whole period of its guarantee has to be the same.

Tar And Chip Paving Knik Fairview Alaska

The weather conditions in our beautiful province may have a disastrous impact on an asphalt driveway, thus the significance of adding a slope with a minimum slope of 2%. This will allow water to drain to the road and decrease the risk of heaving or cracking. This significant detail has to be taken into account when excavating and maintained during backfilling.

If you have a van or recreational vehicle, notify the contractor before the onset of the work: he is going to be able to supply materials so. Some asphalt combinations produce an asphalt which is more resistant to heavy duty vehicles.

The asphalt layer should have an initial thickness of 6.35 to 7.6 cm (2.5 to 3 ) in order to accomplish a thickness of 5 cm (2 in) after being compacted. For optimal stability, the foundation should extend across the surface to be paved by roughly thirty centimeters (a couple inches) on each side. Also mention that the setup of unwanted supports around the foundation is a good way to avoid potential cracks and this asphalting done in cold weather is going to be of poor quality. It's therefore better to await the sunny days to go back before starting work.

A Tar And Chip Paving contract with your contractor in Knik Fairview

To avoid unpleasant surprises, then select your contractor and make sure that the title and address of his company are written on the contract. The beginning and end dates of the job, in addition to proof of this contractor's liability insurance and also the technical details of this project to be carried out, should also be included. No contractor should need a down payment before work starts. To avoid the inconvenience that could cause unforeseen costs, visit the Tar And Chip PavingKnik Fairview website. You will thus have all the resources in hand to successfully finish your asphalt paving project.

Tar And Chip Paving Knik Fairview - Greatest Alaska in Alaska!

For caliber asphalting work , phone on Tar And Chip Paving, Knik Fairview professional team. We have over 20 decades of experience in asphalt laying, resurfacing, maintenance and repair. Consult our Business section to figure out the regions served.

Snow Removal Knik Fairview | Asphalt Knik Fairview
Home >> alaska/knik fairview >> tar and chip paving
Share this...