Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt Coating in Anthem, Arizona


Tar And Chip Paving installed in an unstable surface could quickly lead to problems. There are three Chief choices for the Simple setup:

  1. Paving Over Existing Driveway: If your current driveway is in good condition and not showing serious fractures or crumbling, hot asphalt mix can be laid directly over your driveway. One facet is height: make certain fences, garage floors, and other constructions aren't jeopardized by the higher level of the new surface.
  2. Eliminate old driveway, counter into the ground: The present driveway is completely eliminated (or you may not have a driveway nonetheless ) and 4 to 6 inches of hot paving stone is put right on the ground.
  3. Eliminate the old driveway and fasten it to a solid surface. This is the preferred method. An aggregated stone floor partially replaces part of the hot asphalt mix. Typically 6 to 8 inches of aggregate goes under 3 inches of asphalt.

The more asphalt you work, the more leeway you might have. For instance, at 40 F, the crews only have 16 minutes to operate on 1 1/2 inch thick asphalt. In general, for lean asphalt applications (about 1.5 cm), you need to wait until temperatures are 21 ° C or higher. Between 50 and 60 F, you'll need to speak to your contractor. The hot mix is ​​still functional during this period of time, but the time is limited.

How much can an Tar And Chip Paving price in Anthem?

Take into account the weather vagaries of the climate when deciding upon the quality of asphalt. The substantial temperature variations that we experience cause considerable damage to asphalt work.

In addition, it will be good to distinguish the contractor if you own a recreational vehicle or a van. He might have to adapt the asphalt mix in order to be more resistant to the burden of heavy vehicles.

The advantages of Tar And Chip Paving

  • Smooth finish;
  • non-slip
  • easy to maintain
  • watertightness ensured
  • withstands the rigors of this Quebec climate very well (provided it's been set up );
  • prevents the growth of moss;

It will cost you between $ 3 and $11 per square foot; the price varies depending on the characteristic of the asphalt used along with the paving contractor.

To get a sustainable Tar And Chip Paving

The life of an asphalt paver can be around 20 decades, when the best states are satisfied. We are talking about a professional paving contractor, a great quality of asphalt as well as an optimal asphalt laying technique.


The longevity of residential asphalt paving largely is dependent upon the standard of the placing. Really, the major causes of deformation or tearing of an asphalt coating are the lack of compaction and a lean base. On the other hand, the maintenance of the asphalt pavement is also a determining factor in its longevity. That is to say, you will need to seal your drive once in ten decades, at a minimum, in order to keep its good state.


We suggest that you inform your asphalting builder if you decide to have your driveway asphalt so as to sell your property. It might not be necessary to pay top dollar for laying asphalt , in such a circumstance.

Tar And Chip Paving placing: cost and contract

The choice of the asphalt laying contractor is essential. In order not to have unpleasant surprises, you will have to select it carefully.

Guarantee that the paving contractor has liability insurance coverage. A visit to the web site of the Office for Consumer Protection (OPC) will allow you to confirm whether an entrepreneur has ever been the subject of complaints.

The following details should be included in the contract:

- date of beginning and end of the job;

- proof of insurance;

- technical details;

- RBQ accreditation number.

You should be aware that a paving builder can't demand you to make a deposit before work has begun. But you should agree to the payment terms and be sure it is on the contract.

Prior to estimating the asphalt driveway to your new home by a contractor, or acquiring some fundamental knowledge is vital to guarantee that the job is done. Know first that the lack of compaction and the inadequate depth of the foundation are the two chief causes of the deformation or ripping of a coating of asphalt. When it is a new driveway, then it has to initially be excavated to make room for a coating of crushed stone of sufficient depth. A geotextile membrane is going to be set beneath the granular backfill if the soil turns out to be very loamy (clayey). If you have a new home, it is best to wait 6 to 12 months before paving your drive, to allow the dirt to settle naturally. In the case of a repair of the entry, an easy replacement of the asphalt coating can be considered if the contractor considers that the present foundation is adequate. In both cases, foundation redone or base maintained, the whole period of its guarantee must be exactly the same.

Tar And Chip Paving Anthem Arizona

The weather conditions in our lovely state can have a disastrous impact on an asphalt driveway, hence the significance of including a slope having a minimum slope of 2%. This will allow water to drain to the street and minimize the danger of heaving or cracking. This important detail must be taken into account when excavating and preserved during backfilling.

In case you have a van or recreational vehicle, notify the contractor prior to the onset of the job: he is going to have the ability to provide materials accordingly. Some asphalt combinations produce an asphalt that is more immune to heavy-duty vehicles.

The asphalt layer should have an initial thickness of 6.35 to 7.6 cm (2.5 to 3 in) in order to accomplish a thickness of 5 cm (2 in) after being compacted. For optimum stability, the base should extend over the surface to be paved by roughly thirty centimeters (a couple inches) on each side. Also note that the setup of side supports around the foundation is a fantastic way to avoid possible cracks and this asphalting done in chilly weather is going to be of inferior quality. It's therefore better to await the bright days to go back before beginning work.

To avoid unpleasant surprises, then select your contractor and be certain the name and address of his company are composed about the contract. The beginning and end dates of the work, in addition to proof of this contractor's liability insurance and also the technical details of the project to be completed, should also be included. No contractor should require a deposit before work begins. To prevent the inconvenience that might lead to unforeseen costs, visit the Tar And Chip PavingAnthem site. You will thus have the resources in hand to successfully finish your asphalt paving project.

Tar And Chip Paving Anthem - Greatest Arizona in Arizona!

For caliber asphalting perform , phone on Tar And Chip Paving, Anthem professional team. We have over twenty years of expertise in asphalt laying, resurfacing, maintenance and repair. Consult our Company section to figure out the regions served.

Snow Removal Anthem | Asphalt Anthem
Home >> arizona/anthem >> tar and chip paving
Share this...