Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt Coating in Apache Junction, Arizona


Tar And Chip Paving installed on an unstable surface can quickly lead to problems. There are three main options for the basic setup:

  1. Paving Over Existing Driveway: If your current driveway is in good condition rather than showing serious cracks or crumbling, hot asphalt mixture can be placed directly within your driveway. 1 facet is height: make sure fences, garage flooring, and other constructions aren't compromised by the higher level of this surface.
  2. Remove old driveway, peg to the ground: The existing driveway is totally eliminated (or you may not have a driveway yet) and 4 to 6 inches of warm paving stone is put right on the ground.
  3. Remove the old driveway and secure it to a solid surface. This is the preferred method. An aggregated stone floor partly replaces part of this hot asphalt mix.

The more asphalt you work, the more leeway you might have. For example, at 40 F, the crews just have 16 minutes to operate on 1 1/2 inch thick asphalt. In general, for thin asphalt applications (about 1.5 cm), you should wait until temperatures are 21 ° C or higher. Between 50 and 60 F, you ought to speak to your contractor. The hot mix remains functional during this period, but the time is constrained.

How much can an Tar And Chip Paving price in Apache Junction?

Take into account the weather vagaries of our climate when deciding upon the standard of asphalt. The substantial temperature variations that we experience cause considerable damage to asphalt perform.

Furthermore, it will be good to distinguish the contractor should you have a recreational vehicle or a van. He will have to adapt the asphalt mix so as to be more resistant to the burden of heavy vehicles.

The Benefits of Tar And Chip Paving

A driveway paved with asphalt has several benefits:

It will cost you between $ 3 and $11 per square foot; the price fluctuates based on the quality of the asphalt employed along with the paving contractor.

For a sustainable Tar And Chip Paving

The life of an asphalt paver can be around 20 decades, when the best conditions are satisfied. We're referring to a professional paving builder, a good quality of asphalt and an optimal asphalt laying technique.

Tar And Chip Paving in Apache Junction: cost, quality of work and lifespan


The longevity of residential asphalt paving chiefly depends upon the standard of the laying. Indeed, the major causes of deformation or ripping of an asphalt layer are the lack of compaction plus a thin foundation. However, the upkeep of the asphalt sidewalk is also a deciding factor in its longevity. That is to say, you will need to seal your drive once in 10 decades, at a minimum, so as to keep its good state.


We advise you to inform your asphalting contractor in case you decide to get your driveway asphalt in order to sell your property. It might not be essential to pay top dollar for placing asphalt , in such a case.

Tar And Chip Paving laying: cost and contract

The choice of the asphalt laying contractor is essential. In order not to have unpleasant surprises, then you will have to choose it carefully.

Our ensures and Tar And Chip Paving work

Make sure the paving contractor has liability insurance coverage. A trip to the web site of the Office for Consumer Protection (OPC) will allow you to confirm whether an entrepreneur has become the subject of complaints.

These details must be included in the contract:

- date of start and end of the job;

- proof of insurance;

- technical particulars;

- RBQ accreditation number.

You should be aware that a paving builder can't demand you to make a deposit before work has begun. But you should agree on the payment provisions and make sure it is on the contract.

A solid foundation for Tar And Chip Paving- Apache Junction

Prior to estimating the asphalt drive to your new home by a contractor, or acquiring some fundamental knowledge is vital to guarantee that the job is done. Know first that the lack of compaction and the insufficient depth of the base are the two main sources for the deformation or ripping of a coating of asphalt. When it is a new driveway, it must first be excavated to make room for a layer of crushed stone of adequate thickness. A geotextile membrane is going to be placed under the granular backfill if the soil proves to be somewhat loamy (clayey). If you own a new home, it's best to wait 6 to 12 months before paving your driveway, to enable the dirt to settle naturally. In the case of a fix of this entry, an easy replacement of the asphalt coating can be considered in the event the contractor believes that the existing foundation is adequate. In both scenarios, foundation redone or base preserved, the whole period of its warranty must be the same.

Tar And Chip Paving Apache Junction Arizona

The weather conditions in our lovely state may have a devastating effect on an asphalt drive, hence the importance of including a slope with a minimum slope of 2%. This will allow water to drain to the street and decrease the danger of heaving or cracking. This important detail must be taken into consideration when excavating and preserved during backfilling.

In case you have a van or recreational vehicle, notify the contractor prior to the start of the job: he will have the ability to supply materials accordingly. Some asphalt combinations produce an asphalt which is more resistant to heavy-duty vehicles.

The asphalt coating should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 in) so as to accomplish a thickness of 5 cm (2 in) after being compacted. For optimal stability, the base should extend over the surface to be paved by about thirty centimeters (a dozen inches) on each side. Also note that the installation of side supports around the base is a fantastic method to avoid potential cracks and this asphalting done in chilly weather will be of poor quality. It is therefore better to await the bright days to return before starting work.

To avoid unpleasant surprises, then choose your contractor diligently and be certain the name and address of the company are written on the contract. The beginning and finish dates of this job, in addition to evidence of this builder's liability insurance and the technical specifics of the job to be carried out, should also be included. No contractor should need a deposit before work begins. To prevent the inconvenience that might lead to unforeseen expenses, visit the Tar And Chip PavingApache Junction website. You may thus have the tools in hand to successfully finish your asphalt paving project.

Tar And Chip Paving Apache Junction - Best Arizona at Arizona!

For caliber asphalting work , call on Tar And Chip Paving, Apache Junction specialist team. We've got over 20 years of experience in asphalt laying, resurfacing, maintenance and repair. Consult our Business section to find out the regions served.

Snow Removal Apache Junction | Asphalt Apache Junction
Home >> arizona/apache junction >> tar and chip paving
Share this...