Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt surface in Arizona City, Arizona


Tar And Chip Paving installed on an unstable surface could quickly lead to difficulties. There are 3 Chief choices for the basic installation:

  1. Paving Over Existing Driveway: If your existing driveway is in good condition rather than showing serious fractures or crumbling, hot asphalt mix can be laid directly over your driveway. 1 aspect is height: make sure fences, garage floors, and other structures aren't jeopardized by the higher degree of this surface.
  2. Remove old driveway, counter into the ground: The present driveway is totally removed (or you may not have a driveway yet) and 4 to 6 inches of warm paving stone is put directly on the ground.
  3. Eliminate the old driveway and secure it into a solid surface. This is the preferred method. An aggregated stone flooring partially replaces part of this hot asphalt mix. Typically 6 to 8 inches of aggregate extends under 3 inches of asphalt.

Our Services:

The best time to install Tar And Chip Paving in Arizona City

The longer asphalt you work, the more leeway you might have. For instance, at 40 F, the crews just have 16 minutes to operate on 1 1/2 inch thick asphalt. As the asphalt depth increases by 3 inches, the workability time also increases: 46 minutes. In general, for lean asphalt programs (approximately 1.5 cm), you should wait until temperatures are 21 ° C or even higher. Between 50 and 60 F, then you'll need to speak to your contractor. The hot mix remains functional during this period, however, the time is constrained.

How much can an Tar And Chip Paving price in Arizona City?

Consider the weather vagaries of the climate when deciding upon the standard of asphalt. The substantial temperature variations we experience cause considerable damage to asphalt work.

Furthermore, it will be good to distinguish the contractor if you have a recreational vehicle or a van. He might have to accommodate the asphalt mixture so as to be more resistant to the weight of heavy vehicles.

The advantages of Tar And Chip Paving

  • Smooth finish;
  • non invasive
  • Simple to maintain
  • watertightness guaranteed
  • withstands the rigors of this Quebec climate quite well (provided it's been installed );
  • prevents the growth of moss;

It'll cost you between $ 3 and $11 per square foot; the cost fluctuates based on the characteristic of the asphalt used and the paving contractor.

To get a sustainable Tar And Chip Paving

The existence of an asphalt paver can be up to 20 years, when the best conditions are met. We're talking about a professional paving builder, a good grade of asphalt and also an optimal asphalt laying technique.


The longevity of residential asphalt paving chiefly is dependent upon the standard of the placing. Indeed, the significant causes of deformation or ripping of an asphalt coating are the absence of compaction plus a thin foundation. However, the upkeep of the asphalt pavement can be a deciding factor in its longevity. That is to say, you'll have to seal your drive once in 10 years, at a minimum, so as to maintain its great condition.


We advise you to inform your asphalting contractor in case you choose to have your driveway asphalt so as to sell your property. It might not be necessary to pay top dollar for laying asphalt , in such a circumstance.

Tar And Chip Paving placing: cost and contract

The option of the asphalt laying contractor is essential. In order to not have unpleasant surprises, you will need to choose it carefully.

Our ensures and Tar And Chip Paving work

Guarantee that the paving contractor has liability insurance. A visit to the web site of the Office for Consumer Protection (OPC) will allow you to verify whether an entrepreneur has been the subject of complaints.

These details must be included in the contract:

- date of beginning and end of the work;

- proof of insurance;

- technical details;

- RBQ accreditation number.

You should know that a paving builder cannot demand you to make a deposit before work has begun. However, you need to agree to the payment terms and be sure it's on the contract.

Before redoing the asphalt drive to your new residence by a contractor, or acquiring some fundamental knowledge is imperative to guarantee that the job is done. Know first that the lack of compaction and the inadequate thickness of the foundation are the two main causes of the deformation or tearing of a layer of asphalt. If it's a new driveway, it must first be excavated to make room for a layer of crushed stone of sufficient depth. A geotextile membrane will be placed under the granular backfill if the soil proves to be very loamy (clayey). If you own a new home, it is ideal to wait for 6 to 12 months before paving your driveway, to enable the dirt to settle naturally. In the case of a fix of this entrance, an easy replacement of the asphalt layer can be considered if the contractor considers that the present base is adequate. In both scenarios, base redone or base maintained, the duration of its warranty must be exactly the same.

Tar And Chip Paving Arizona City Arizona

The weather conditions in our beautiful province may have a disastrous impact on an asphalt driveway, thus the significance of adding a slope with a minimum slope of 2%. This will allow water to drain to the road and minimize the danger of heaving or cracking. This significant detail must be taken into account when excavating and preserved during backfilling.

In case you've got a van or recreational vehicle, notify the builder prior to the start of the work: he is going to be able to supply materials so. Some asphalt combinations produce an asphalt that is more resistant to heavy duty vehicles.

The asphalt layer should have an initial thickness of 6.35 to 7.6 cm (2.5 to 3 ) in order to accomplish a thickness of 5 cm (2 ) after being compacted. For optimum stability, the foundation should extend across the surface to be paved by roughly thirty centimeters (a couple inches) on each side. Also mention that the setup of side supports around the foundation is a good method to avoid possible cracks and that asphalting done in chilly weather will be of inferior quality. It is therefore far better to await the bright days to return before starting work.

A Tar And Chip Paving contract with your contractor in Arizona City

To avoid unpleasant surprises, select your contractor diligently and be sure the name and address of the business are composed on the contract. The start and end dates of the work, in addition to evidence of the contractor's liability insurance and the technical specifics of the job to be carried out, should also be included. No contractor should require a deposit before work begins. To prevent the inconvenience that could lead to unforeseen expenses, take a look at the Tar And Chip PavingArizona City website. You may thus have all the resources in hand to successfully finish your asphalt paving project.

Tar And Chip Paving Arizona City - Greatest Arizona in Arizona!

For quality asphalting perform , phone on Tar And Chip Paving, Arizona City professional team. We've got more than twenty decades of experience in asphalt laying, resurfacing, maintenance and repair. Confirm our Business department to find out the regions served.

Snow Removal Arizona City | Asphalt Arizona City
Home >> arizona/arizona city >> tar and chip paving
Share this...