Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Options for the asphalt surface in Avondale, Arizona


Tar And Chip Paving installed in an unstable surface can quickly lead to problems. There are three main options for the Simple installation:

  1. Paving Over Existing Driveway: If your current driveway is in good shape rather than showing severe fractures or crumbling, hot asphalt mixture can be placed directly within your driveway. 1 aspect is elevation: make sure fences, garage flooring, and other constructions are not compromised by the greater level of the surface.
  2. Remove old driveway, counter into the floor: The existing driveway is totally removed (or you may not have a driveway yet) and 4 to 6 inches of hot paving stone is put right on the ground.
  3. Remove the old driveway and fasten it to a solid surface. This is actually the preferred method. An aggregated stone flooring partially replaces part of the hot asphalt mixture. Generally 6 to 8 inches of aggregate goes under 3 inches of asphalt.

Our Services:

The best time to install Tar And Chip Paving from Avondale

The longer asphalt you work, the more leeway you might have. By way of instance, at 40 F, the crews only have 16 minutes to operate on 1 1/2 inch thick asphalt. As the asphalt depth increases by 3 inches, the workability time also raises: 46 minutes. In general, for thin asphalt programs (about 1.5 cm), you should wait until temperatures are 21 ° C or even higher. Between 50 and 60 F, then you'll need to consult with your contractor. The hot mix is ​​still functional during this period, however, the time is limited.

How much does an Tar And Chip Paving cost in Avondale?

Take into account the weather vagaries of our climate when deciding upon the quality of asphalt. The significant temperature variations we experience cause considerable damage to asphalt work.

In addition, it will be good to tell the contractor if you have a recreational vehicle or a van. He will have to adapt the asphalt mix so as to be more resistant to the burden of heavy vehicles.

The advantages of Tar And Chip Paving

  • Smooth finish;
  • non invasive
  • easy to maintain
  • watertightness ensured
  • withstands the rigors of this Quebec climate very well (provided it's been set up );
  • prevents the growth of moss;

It will cost you between $ 3 and $11 per square foot; the price fluctuates based on the quality of the asphalt employed along with the paving contractor.

For a sustainable Tar And Chip Paving

The existence of an asphalt paver can be up to 20 years, when the very best conditions are satisfied. We are referring to a professional paving builder, a great quality of asphalt as well as an optimal asphalt laying technique.


The longevity of residential asphalt paving chiefly is dependent on the standard of the placing. Really, the significant causes of deformation or tearing of an asphalt coating are the absence of compaction plus a lean base. On the other hand, the maintenance of the asphalt sidewalk can be a determining factor in its own longevity. That's to say, you will have to seal your driveway once in 10 years, at a minimum, in order to maintain its great state.


We suggest that you inform your asphalting contractor if you choose to have your driveway asphalt in order to offer your property. It might not be essential to pay top dollar for laying asphalt , in this case.

Tar And Chip Paving placing: cost and contract

The option of the asphalt laying contractor is indispensable. In order not to have unpleasant surprises, then you'll have to select it carefully.

Our guarantees and Tar And Chip Paving work

Make sure the paving contractor has liability insurance coverage. A visit to the website of the Office for Consumer Protection (OPC) will allow you to verify whether an entrepreneur has been the subject of complaints.

These details should be included in the contract:

- date of start and finish of the job;

- proof of insurance;

- technical details;

- RBQ certification number.

You should be aware that a paving builder can't demand that you make a deposit before work has begun. But you need to agree on the payment provisions and be sure it is about the contract.

Prior to estimating the asphalt driveway to your new residence by a builder, or obtaining some fundamental knowledge is vital to guarantee that the job is done. Know first that the lack of compaction and the insufficient thickness of the base are the two main causes of the deformation or tearing of a layer of asphalt. If it is a new driveway, then it has to initially be excavated to make room for a coating of crushed stone of adequate depth. A geotextile membrane is going to be placed beneath the granular backfill if the dirt turns out to be very loamy (clayey). If you have a new home, it is best to wait 6 to 12 months prior to paving your drive, to allow the soil to settle . In the case of a fix of the entry, a simple replacement of the asphalt layer can be considered in the event the contractor considers that the existing base is sufficient. In both scenarios, base redone or foundation preserved, the duration of its warranty must be exactly the same.

Tar And Chip Paving Avondale Arizona

The weather conditions in our lovely state may have a devastating effect in an asphalt driveway, hence the significance of adding a slope having a minimum slope of 2%. This will allow water to drain into the road and minimize the danger of heaving or cracking. This significant detail must be taken into account when excavating and maintained during backfilling.

In case you've got a van or recreational vehicle, notify the contractor before the start of the work: he is going to be able to supply materials accordingly. Some asphalt combinations produce an asphalt which is more resistant to heavy duty vehicles.

The asphalt layer should have an initial thickness of 6.35 to 7.6 cm (2.5 to 3 ) in order to accomplish a thickness of at least 5 cm (2 ) after being compacted. For optimal stability, the base should extend across the surface to be paved by about thirty centimeters (a couple inches) on each side. Also note that the setup of side supports around the base is a fantastic method to prevent potential cracks and this asphalting done in cold weather is going to be of poor quality. It's therefore better to await the sunny days to return before beginning work.

To avoid unpleasant surprises, then choose your contractor and be sure the title and address of the business are written on the contract. The start and finish dates of the job, as well as evidence of this builder's liability insurance and the technical specifics of the job to be carried out, should also be included. No contractor should require a deposit before work begins. To avoid the inconvenience that might cause unforeseen costs, take a look at the Tar And Chip PavingAvondale website. You may thus have the resources in hand to successfully complete your asphalt paving project.

Tar And Chip Paving Avondale - Greatest Arizona in Arizona!

For caliber asphalting work , phone on Tar And Chip Paving, Avondale specialist team. Confirm our Business department to figure out the regions served.

Snow Removal Avondale | Asphalt Avondale
Home >> arizona/avondale >> tar and chip paving
Share this...