Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt Coating in Camp Verde, Arizona


Tar And Chip Paving installed in an unstable surface could quickly lead to problems. There are 3 Chief options for the basic installation:

  1. Paving Over Existing Driveway: If your existing driveway is in good condition rather than showing severe cracks or crumbling, hot asphalt mix can be placed directly within your driveway. 1 facet is elevation: make sure fences, garage floors, and other structures aren't compromised by the greater degree of the surface.
  2. Eliminate old driveway, counter into the ground: The present driveway is totally eliminated (or you may not have a driveway yet) and 4 to 6 inches of warm paving stone is placed right on the ground.
  3. Remove the old driveway and fasten it into a good surface. This is the preferred method. An aggregated stone flooring partly replaces part of the hot asphalt mixture.

The more asphalt you operate, the more leeway you might have. For example, at 40 F, the crews just have 16 minutes to operate on 1 1/2 inch thick asphalt. As the asphalt depth increases by 3 inches, the workability time also raises: 46 minutes. Generally, for thin asphalt programs (about 1.5 cm), you need to wait until temperatures are 21 ° C or higher. Between 50 and 60 F, then you ought to speak to your contractor. The hot mix remains functional during this period of time, however, the time is limited.

How much does an Tar And Chip Paving cost in Camp Verde?

Take into account the weather vagaries of our climate when deciding upon the standard of asphalt. The substantial temperature variations we experience cause appreciable damage to asphalt work.

In addition, it'll be good to tell the contractor if you own a recreational vehicle or even a van. He will need to adapt the asphalt mixture so as to be more resistant to the burden of heavy vehicles.

The advantages of Tar And Chip Paving

A driveway paved with asphalt has several advantages:

It will cost you between $ 3 and $11 per square foot; the price varies depending on the characteristic of the asphalt employed along with the paving contractor.

To get a sustainable Tar And Chip Paving

The life of an asphalt paver may be around 20 years, when the best conditions are satisfied. We're talking about a professional paving builder, a good quality of asphalt as well as also an optimal asphalt laying technique.


The durability of residential asphalt paving largely is dependent upon the standard of the placing. Indeed, the significant causes of deformation or ripping of an asphalt coating are the lack of compaction plus a lean base. However, the maintenance of the asphalt sidewalk is also a determining factor in its longevity. That's to say, you'll need to seal your drive once in ten years, at a minimum, in order to keep its great condition.


We advise you to notify your asphalting builder in case you decide to have your driveway asphalt so as to sell your property. It may not be necessary to pay top dollar for laying asphalt , in such a circumstance.

Tar And Chip Paving placing: price and contract

The option of the asphalt laying builder is indispensable. In order not to have unpleasant surprises, then you'll need to select it carefully.

Guarantee that the paving contractor has liability insurance coverage. A trip to the website of the Office for Consumer Protection (OPC) will allow you to verify whether an entrepreneur has been the subject of complaints.

These details must be included in the contract:

- date of start and finish of the job;

- proof of insurance;

- technical particulars;

- RBQ certification number.

You ought to be aware that a paving builder cannot require you to make a down payment before work has started. But you should agree on the payment terms and be sure it is about the contract.

Prior to estimating the asphalt drive to your new residence by a contractor, or acquiring some basic knowledge is imperative to make sure the job is done. Know first that the absence of compaction and the insufficient thickness of the foundation are the two chief sources for the deformation or tearing of a layer of asphalt. If it is a new driveway, it must first be excavated to make room for a layer of crushed stone of adequate thickness. A geotextile membrane is going to be placed under the granular backfill if the dirt proves to be very loamy (clayey). If you own a new house, it's best to wait for 6 to 12 months prior to paving your driveway, to allow the dirt to settle naturally. In the event of a repair of the entry, a simple replacement of the asphalt layer can be considered in the event the contractor considers that the present base is adequate. In both cases, base redone or base maintained, the whole period of its guarantee has to be the same.

Tar And Chip Paving Camp Verde Arizona

The weather conditions in our lovely state can have a devastating effect on an asphalt drive, hence the importance of adding a slope having a minimum slope of 2%. This will enable water to drain into the street and minimize the risk of heaving or cracking. This significant detail must be taken into account when excavating and preserved during backfilling.

In case you have a van or recreational vehicle, notify the builder prior to the onset of the job: he will have the ability to supply materials so. Some asphalt combinations produce an asphalt that is more immune to heavy-duty vehicles.

The asphalt layer should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 in) in order to accomplish a thickness of 5 cm (2 in) after being compacted. For optimal stability, the base should extend over the surface to be paved by roughly thirty centimeters (a couple inches) on each side. Also note that the installation of unwanted supports around the base is a good method to prevent potential cracks and this asphalting done in chilly weather will be of poor quality. It is therefore better to wait for the bright days to go back before beginning work.

To avoid unpleasant surprises, then choose your contractor and be certain the title and address of the business are written about the contract. The beginning and end dates of this job, as well as proof of this contractor's liability insurance and also the technical details of the job to be carried out, should also be included. No contractor should require a down payment before work starts. To prevent the inconvenience that might lead to unforeseen costs, take a look at the Tar And Chip PavingCamp Verde website. You may thus have the tools in hand to successfully complete your asphalt paving project.

Tar And Chip Paving Camp Verde - Best Arizona at Arizona!

For caliber asphalting perform , phone on Tar And Chip Paving, Camp Verde specialist team. Confirm our Business department to figure out the regions served.

Snow Removal Camp Verde | Asphalt Camp Verde
Home >> arizona/camp verde >> tar and chip paving
Share this...