Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt Coating in Drexel Heights, Arizona


Tar And Chip Paving installed in an unstable surface could quickly lead to problems. There are three main options for the Simple installation:

  1. Paving Over Existing Driveway: If your current driveway is in good shape rather than revealing serious cracks or crumbling, hot asphalt mixture can be placed directly within your driveway. One facet is elevation: make certain fences, garage floors, and other structures aren't jeopardized by the greater degree of the surface.
  2. Eliminate old driveway, counter into the floor: The existing driveway is completely eliminated (or you may not have a driveway yet) and 4 to 6 inches of warm paving stone is put directly on the ground.
  3. Remove the old driveway and fasten it to a good surface. This is the preferred method. An aggregated stone floor partially replaces part of the hot asphalt mixture.

The longer asphalt you work, the more leeway you might have. By way of example, in 40 F, the crews only have 16 minutes to operate on 1 1/2 inch thick asphalt. As the asphalt depth increases by 3 inches, the workability time also raises: 46 minutes. Generally, for thin asphalt applications (approximately 1.5 cm), you need to wait until temperatures are 21 ° C or even higher. Between 50 and 60 F, you'll need to speak to your contractor. The hot mix is ​​still practical in this period, but the time is constrained.

How much can an Tar And Chip Paving cost in Drexel Heights?

Consider the weather vagaries of our climate when deciding upon the standard of asphalt. The substantial temperature variations that we experience cause appreciable damage to asphalt work.

Furthermore, it will be useful to distinguish the contractor if you have a recreational vehicle or even a van. He will need to accommodate the asphalt mixture in order to be more resistant to the burden of heavy vehicles.

The Benefits of Tar And Chip Paving

  • Smooth finish;
  • non invasive
  • Simple to Keep
  • watertightness guaranteed
  • withstands the rigors of the Quebec climate very well (provided it has been installed );
  • prevents the growth of moss;

It'll cost you between $ 3 and $11 per square foot; the price fluctuates based on the quality of the asphalt used and the paving contractor.

To get a sustainable Tar And Chip Paving

The existence of an asphalt paver can be around 20 decades, when the best conditions are satisfied. We're talking about a professional paving contractor, a good quality of asphalt as well as an optimal asphalt laying technique.


The longevity of residential asphalt paving chiefly depends upon the standard of the placing. Indeed, the significant causes of deformation or tearing of an asphalt coating are the absence of compaction plus a thin foundation. However, the maintenance of the asphalt sidewalk can be a determining factor in its longevity. That's to say, you will have to seal your driveway once in 10 years, at a minimum, so as to keep its good state.


We suggest that you notify your asphalting contractor in case you choose to get your driveway asphalt in order to offer your property. It might not be essential to pay top dollar for placing asphalt , in such a case.

Tar And Chip Paving laying: price and contract

The option of the asphalt laying builder is essential. In order not to have unpleasant surprises, then you will have to choose it carefully.

Our ensures and Tar And Chip Paving work

Make sure the paving contractor has liability insurance. A visit to the web site of the Office for Consumer Protection (OPC) will allow you to verify whether an entrepreneur has ever been the subject of complaints.

These details must be included in the contract:

- date of start and finish of the job;

- proof of insurance;

- technical details;

- RBQ accreditation number.

You should know that a paving builder cannot require you to make a down payment before work has begun. But you should agree on the payment provisions and make sure it's about the contract.

Before redoing the asphalt driveway to your new home by a contractor, or acquiring some fundamental knowledge is vital to make sure the job is done. Know first that the lack of compaction and the insufficient thickness of the foundation are the two main sources for the deformation or ripping of a coating of asphalt. When it's a new driveway, then it has to initially be excavated to make room for a layer of crushed stone of adequate depth. A geotextile membrane will be placed under the granular backfill if the soil turns out to be very loamy (clayey). If you have a new house, it's ideal to wait 6 to 12 months prior to paving your driveway, to enable the dirt to settle . In the case of a fix of this entry, a simple replacement of the asphalt layer can be considered in the event the contractor believes that the existing foundation is sufficient. In both scenarios, foundation redone or base maintained, the whole period of its guarantee must be the same.

Tar And Chip Paving Drexel Heights Arizona

The weather conditions in our beautiful province can have a disastrous impact on an asphalt drive, thus the importance of adding a slope with a minimum slope of 2%. This will allow water to drain into the street and decrease the danger of heaving or cracking. This significant detail must be taken into account when excavating and maintained during backfilling.

If you have a van or recreational vehicle, notify the builder prior to the onset of the job: he will have the ability to provide materials accordingly. Some asphalt combinations produce an asphalt which is more immune to heavy duty vehicles.

The asphalt layer should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 ) so as to accomplish a thickness of at least 5 cm (2 in) after being compacted. For optimal stability, the foundation should extend across the surface to be paved by roughly thirty centimeters (a dozen inches) on each side. Also note that the installation of unwanted supports around the base is a good way to prevent potential cracks and that asphalting done in chilly weather is going to be of poor quality. It's therefore far better to wait for the bright days to go back before starting work.

To avoid unpleasant surprises, then select your contractor and make sure that the name and address of the company are composed on the contract. The beginning and finish dates of the job, as well as proof of this contractor's liability insurance and also the technical specifics of this project to be carried out, should also be included. No contractor should require a deposit before work starts. To prevent the inconvenience that could cause unforeseen costs, take a look at the Tar And Chip PavingDrexel Heights website. You may thus have the tools in hand to successfully finish your asphalt paving project.

Tar And Chip Paving Drexel Heights - Best Arizona in Arizona!

For caliber asphalting perform , phone on Tar And Chip Paving, Drexel Heights specialist team. Consult our Business section to find out the regions served.

Snow Removal Drexel Heights | Asphalt Drexel Heights
Home >> arizona/drexel heights >> tar and chip paving
Share this...