Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt surface in Florence, Arizona


Tar And Chip Paving installed on an unstable surface can quickly lead to problems. There are three main choices for the basic installation:

  1. Paving Over Existing Driveway: If your existing driveway is in good shape rather than revealing serious cracks or crumbling, hot asphalt mix can be placed directly within your driveway. 1 facet is height: make sure fences, garage floors, and other structures are not jeopardized by the greater level of the surface.
  2. Eliminate old driveway, counter into the ground: The existing driveway is completely removed (or you might not have a driveway nonetheless ) and 4 to 6 inches of warm paving stone is put right on the ground.
  3. Remove the old driveway and secure it into a good surface. This is actually the preferred method. An aggregated stone floor partly replaces part of the hot asphalt mix. Typically 6 to 8 inches of limestone extends under 3 inches of asphalt.

Our Services:

The best time to install Tar And Chip Paving in Florence

The more asphalt you work, the more leeway you might have. For example, at 40 F, the crews just have 16 minutes to work on 1 1/2 inch thick asphalt. In general, for lean asphalt programs (about 1.5 cm), you need to wait until temperatures are 21 ° C or higher. Between 50 and 60 F, then you ought to consult with your contractor. The hot mix is ​​still practical in this period, however, the time is constrained.

How much does an Tar And Chip Paving price in Florence?

Take into account the weather vagaries of our climate when choosing the quality of asphalt. The significant temperature variations that we experience cause appreciable damage to asphalt perform.

In addition, it'll be good to tell the contractor should you own a recreational vehicle or even a van. He might need to accommodate the asphalt mixture so as to be more immune to the burden of heavy vehicles.

The Benefits of Tar And Chip Paving

  • Smooth finish;
  • non-slip
  • easy to maintain
  • watertightness guaranteed
  • withstands the rigors of the Quebec climate very well (provided it's been set up optimally);
  • prevents the growth of moss;

It will cost you between $ 3 and $11 per square foot; the cost varies depending on the characteristic of the asphalt employed along with the paving contractor.

To get a sustainable Tar And Chip Paving

The existence of an asphalt paver may be around 20 decades, when the very best conditions are met. We're talking about a professional paving builder, a great quality of asphalt as well as also an optimal asphalt laying technique.


The durability of residential asphalt paving chiefly is dependent on the standard of the laying. Really, the major causes of deformation or ripping of an asphalt coating are the absence of compaction and a lean base. On the other hand, the maintenance of the asphalt sidewalk can be a deciding factor in its longevity. That is to say, you will have to seal your driveway once in ten decades, at a minimum, so as to maintain its good state.


We advise you to notify your asphalting builder in case you choose to have your driveway asphalt in order to offer your property. It might not be necessary to pay top dollar for laying asphalt , in this circumstance.

Tar And Chip Paving laying: cost and contract

The choice of the asphalt laying builder is indispensable. In order not to have unpleasant surprises, you'll need to choose it carefully.

Our ensures and Tar And Chip Paving work

Guarantee that the paving contractor has liability insurance. A visit to the website of the Office for Consumer Protection (OPC) will make it possible for you to verify whether an entrepreneur has ever become the subject of complaints.

These details should be included in the contract:

- date of beginning and end of the job;

- evidence of insurance;

- technical details;

- RBQ accreditation number.

You should know that a paving builder cannot demand you to make a down payment before work has started. But you should agree to the payment terms and make sure it's on the contract.

A solid base for Tar And Chip Paving- Florence

Before redoing the asphalt drive to your new home by a builder, or obtaining some basic knowledge is imperative to make sure the job is well done. Know first that the lack of compaction and the insufficient depth of the base are the two chief causes of the deformation or tearing of a coating of asphalt. When it is a new driveway, it has to initially be excavated to make room for a layer of crushed stone of sufficient thickness. A geotextile membrane is going to be set under the granular backfill if the dirt proves to be somewhat loamy (clayey). If you have a new home, it's best to wait for 6 to 12 months before paving your drive, to enable the dirt to settle . In the event of a fix of this entrance, an easy replacement of the asphalt layer can be considered if the contractor considers that the present foundation is adequate. In both scenarios, base redone or foundation preserved, the whole period of its warranty must be exactly the same.

Tar And Chip Paving Florence Arizona

The weather conditions in our beautiful province can have a disastrous impact on an asphalt driveway, thus the significance of adding a slope having a minimum slope of 2%. This will enable water to drain to the street and decrease the danger of heaving or cracking. This significant detail must be taken into account when excavating and maintained during backfilling.

If you've got a van or recreational vehicle, notify the builder before the start of the job: he is going to be able to supply materials so. Some asphalt mixtures produce an asphalt which is more immune to heavy-duty vehicles.

The asphalt coating should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 in) so as to accomplish a thickness of 5 cm (2 ) after being compacted. For optimum stability, the foundation should extend over the surface to be paved by roughly thirty centimeters (a couple inches) on each side. Also mention that the setup of side supports around the base is a fantastic method to avoid potential cracks and this asphalting done in chilly weather will be of inferior quality. It's therefore better to await the bright days to go back before beginning work.

To avoid unpleasant surprises, choose your contractor diligently and be certain the name and address of the company are written about the contract. The beginning and end dates of the job, in addition to proof of the builder's liability insurance and also the technical specifics of this job to be carried out, should also be included. No contractor should need a deposit before work begins. To prevent the inconvenience that might cause unforeseen expenses, take a look at the Tar And Chip PavingFlorence site. You will thus have all the resources in hand to successfully finish your asphalt paving project.

Tar And Chip Paving Florence - Greatest Arizona at Arizona!

For quality asphalting perform , call on Tar And Chip Paving, Florence professional team. Consult our Business section to figure out the regions served.

Snow Removal Florence | Asphalt Florence
Home >> arizona/florence >> tar and chip paving
Share this...