Easy and Trusted Asphalt

Call Us Today: 1240.226.2848

Tar And Chip Paving- Alternatives for the asphalt Coating in Silver Spring, Maryland


Tar And Chip Paving installed on an unstable surface could quickly lead to problems. There are 3 Chief choices for the basic setup:

  1. Paving Over Existing Driveway: If your current driveway is in good condition rather than showing severe fractures or crumbling, hot asphalt mix can be placed directly within your driveway. 1 aspect is elevation: make sure fences, garage floors, and other structures are not compromised by the greater degree of this new surface.
  2. Eliminate old driveway, counter into the ground: The existing driveway is completely eliminated (or you might not have a driveway nonetheless ) and 4 to 6 inches of warm paving stone is placed directly on the ground.
  3. Eliminate the old driveway and secure it to a good surface. This is the preferred method. An aggregated stone flooring partially replaces part of this hot asphalt mixture.

Our Services:

The best time to install Tar And Chip Paving from Silver Spring

The longer asphalt you operate, the more leeway you might have. For instance, in 40 F, the crews just have 16 minutes to operate on 1 1/2 inch thick asphalt. As the asphalt depth increases by 3 inches, the workability time also raises: 46 minutes. Generally, for lean asphalt programs (about 1.5 cm), you should wait until temperatures are 21 ° C or even higher. Between 50 and 60 F, you ought to speak to your contractor. The hot mix remains practical in this period, however, the time is limited.

How much can an Tar And Chip Paving price in Silver Spring?

Take into account the weather vagaries of our climate when deciding upon the standard of asphalt. The significant temperature variations that we experience cause appreciable damage to asphalt perform.

In addition, it'll be useful to distinguish the contractor should you own a recreational vehicle or a van. He will need to accommodate the asphalt mix so as to be more resistant to the burden of heavy vehicles.

The advantages of Tar And Chip Paving

  • Smooth finish;
  • non-slip
  • easy to Keep
  • watertightness guaranteed
  • withstands the rigors of the Quebec climate very well (provided it has been set up );
  • prevents the growth of moss;

It'll cost you between $ 3 and $11 per square foot; the cost varies depending on the quality of the asphalt used and the paving contractor.

To get a sustainable Tar And Chip Paving

The life of an asphalt paver can be up to 20 years, when the very best states are met. We are talking about a professional paving builder, a great quality of asphalt as well as also an optimal asphalt laying technique.

Tar And Chip Paving in Silver Spring: price, quality of work and lifespan


The longevity of residential asphalt paving largely depends upon the standard of the laying. Indeed, the significant causes of deformation or ripping of an asphalt layer are the absence of compaction plus a lean base. However, the upkeep of the asphalt pavement can be a deciding factor in its longevity. That is to say, you will have to seal your driveway once in 10 decades, at a minimum, so as to keep its good condition.


We suggest that you notify your asphalting contractor in case you choose to have your driveway asphalt so as to sell your property. It may not be essential to pay top dollar for laying asphalt , in this case.

Tar And Chip Paving laying: price and contract

The option of the asphalt laying builder is essential. In order not to have unpleasant surprises, then you'll need to choose it carefully.

Make sure the paving contractor has liability insurance. A visit to the website of the Office for Consumer Protection (OPC) will allow you to confirm whether an entrepreneur has become the subject of complaints.

The following details must be included in the contract:

- date of beginning and finish of the work;

- evidence of insurance;

- technical particulars;

- RBQ accreditation number.

You should know that a paving builder cannot demand that you make a deposit before work has begun. But you need to agree to the payment terms and make sure it's on the contract.

Before redoing the asphalt drive to your new residence by a builder, or acquiring some fundamental knowledge is imperative to guarantee that the job is done. Know first that the absence of compaction and the inadequate depth of the base are the two main causes of the deformation or tearing of a coating of asphalt. If it's a new driveway, it must initially be excavated to make room for a coating of crushed stone of adequate depth. A geotextile membrane will be set under the granular backfill if the soil proves to be somewhat loamy (clayey). If you have a new home, it is ideal to wait for 6 to 12 months prior to paving your drive, to enable the soil to settle . In the event of a fix of this entry, a simple replacement of the asphalt layer can be considered in the event the contractor considers that the existing base is adequate. In both cases, base redone or base preserved, the whole period of its warranty has to be the same.

Tar And Chip Paving Silver Spring Maryland

The weather conditions in our beautiful province can have a disastrous impact on an asphalt drive, thus the importance of adding a slope with a minimum slope of 2%. This will allow water to drain into the street and decrease the danger of heaving or cracking. This significant detail must be taken into consideration when excavating and maintained during backfilling.

In case you've got a van or recreational vehicle, notify the contractor before the start of the job: he is going to be able to provide materials accordingly. Some asphalt combinations produce an asphalt which is more immune to heavy-duty vehicles.

The asphalt layer should have a first thickness of 6.35 to 7.6 cm (2.5 to 3 ) so as to reach a thickness of at least 5 cm (2 in) after being compacted. For optimal stability, the base should extend over the surface to be paved by about thirty centimeters (a couple inches) on each side. Also note that the setup of unwanted supports around the foundation is a good method to prevent potential cracks and this asphalting done in chilly weather is going to be of poor quality. It's therefore far better to wait for the sunny days to return before beginning work.

To avoid unpleasant surprises, then select your contractor and be certain the title and address of the company are composed about the contract. The beginning and finish dates of the work, as well as proof of this contractor's liability insurance and also the technical details of the job to be completed, should also be included. No contractor should require a deposit before work begins. To avoid the inconvenience that could lead to unforeseen costs, take a look at the Tar And Chip PavingSilver Spring website. You may thus have all the tools in hand to successfully finish your asphalt paving project.

Tar And Chip Paving Silver Spring - Best Maryland at Maryland!

For quality asphalting work , call on Tar And Chip Paving, Silver Spring specialist team. Consult our Company department to figure out the regions served.

Snow Removal Silver Spring | Asphalt Silver Spring
Home >> maryland/silver spring >> tar and chip paving
Share this...